Question is ⇒ Due to which of the following reasons, the ground wave eventually disappears, as one moves away from the transmitter?, Options are ⇒ (A) Tilting, (B) Loss of line-of-eight conditions, (C) Interference from the sky wave, (D) Maximum single hop distance limitation, (E) , Leave your comments or Download question paper.

Question is ⇒ Due to which of the following reasons, the ground wave eventually disappears, as one moves away from the transmitter?, Options are ⇒ (A) Tilting, (B) Loss of line-of-eight conditions, (C) Interference from the sky wave, (D) Maximum single hop distance limitation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Due to which of the following reasons, the ground wave eventually disappears, as one moves away from the transmitter?
A.	Tilting [Correct Answer]
B.	Loss of line-of-eight conditions [Wrong Answer]
C.	Interference from the sky wave [Wrong Answer]
D.	Maximum single hop distance limitation [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Absolute permeability (μ) is given by __________ henry/metre
4p x 10^-12
4p x 10^-7
8.854 x 10^-12
8.854 x 10^-7

⇒ Figure shows the V-i characteristics of a material. The material is likely t
copper
carbon
zinc oxide
rubber

⇒ For wired AND connection we should use
TTL gates with active pull up
TTL gates with open collector
TTL gates without active pull up and with open collector
any of the above

⇒ For a random variable x following the probability density function, p(x), shown in figure, the mean and the variance are respective
1/2 and 2/3
1 and 4/3
1 and 2/3
2 and 4/3

⇒ Colour picture tube needs higher anode voltage and needs larger beam and cathode currents than monochrome tube because
it is bigger in size
it has higher level of illumination
the tube has to illuminate three phosphors simultaneously
the tube has lower efficiency because of aperture mask

⇒ Which one condition is true to check the periodically for discrete time signal (where K is any integer, N is period, f₀ is frequency of signal)
f₀ = K/N
f₀ = K + N
f₀ = KN
f₀ = N/K

⇒ When analysing two port networks in parallel it is more convenient to use
z parameters
h parameters
T parameters
y parameters

⇒ In a series regulated power supply circuit, the voltage gain A_v, of the 'pass' transistor satisfies the condition
A_v → ∞
1 << A_v < ∞
A_v ≈ 1
A_v << 1

⇒ The sum S of A and B in a Half Adder can be implemented by using K NAND gates. The value of K is
3
4
5
none of these

⇒ The product kT (where k is Boltzmann's constant and T is absolute temperature) at room temperature is about
0.051 eV
0.026 eV
0.01 eV
0.001 eV

⇒ For the system in the given figure the root l
is on real axis between points s = -1 and s = -3.6
is on real axis between points s = 0 and s = -1
is on real axis between points s = -3.6 and s = ∞
is on real axis between points s = 0 and s = -3.6

⇒ For the characteristic equation s⁵ + s⁴ + 2s³ + 2s² + 3s + 15 = 0, the number of roots in left half s plane are
1
2
3
5

⇒

Assertion (A): In an intrinsic semiconductor J = (μ_n x μ_p)en_i.

Reason (R): Intrinsic charge concentration n_i at temperature T is given by n_i² = A₀ T³ e^-E_G0/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A (75 - j 40) W load is connected to a co-axial line of z₀ = 75ω at 6 MHz. The load matching on the line can be accomplished by connecting
a short circuit stub at the load
an inductance at the load
a short circuit stub at a specific distance from the load
a capacitance at a specific distance from the load

⇒ In a multiphase chopper, the different choppers operate in
series and all simultaneously
parallel and one at a time
parallel and simultaneously
either (b) or (c)

⇒

Match the following:

	List I		List II
A.	Silicon	1.	is trivalent
B.	Arsenic	2.	rarely used as semiconductor
C.	Indium	3.	is pentavalent
D.	Germanium	4.	intrinsic semiconductor

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-4, B-3, C-1, D-2
A-2, B-1, C-3, D-4

⇒ A waveguide behave as
high Pass filter
low Pass filter
band Pass filter
all Pass filter

⇒ In a triode the potential of grid (with respect to cathode) is usually
zero
negative
positive
zero or positive

⇒ A delta modulation system is designed to operate at 3 times the Nyquist rate for a signal with a 3 KHz bandwidth. The quantization step size is 250 mv. The maximum amplitude of a 1 KHz input sinusoidal for which the delta modulator does not show slope overload is :
716.2 mV
500 mV
647.87 mV
400 mV

⇒ Which material is generally used for LED?
Compounds of silica
Compounds of gallium
Compounds of phosphorus
Compounds of sulphur

⇒ For a message signal m(t) = cos (2pf_mt) and the carrier frequency f_c, which of the following represents a single side band (SSB) signal?
cos (2pf_mt) cos (2pf_ct)
cos (2pf_ct)
cos [2p(f_c + f_m) t]
[1 + cos (2pf_mt) cos (2pf_ct)]

⇒ Consider the following statements:

Internal sorting is used if the number of items to be sorted is very large.
External sorting is used if the number of items to be sorted is vary large.
External sorting needs auxiliary storage.
Internal sorting needs auxiliary storage.

Which of the above statements are correct?
1 and 2
2 and 3
3 and 4
2 and 4

⇒ Consider the following statements for a driving point function F(jω):

Re F(jω) is an even function of ω and is 0 or positive for all values of ω.
Im F(jω) is an even function of ω and is 0 or positive for all values of ω.
Re F(jω) is an odd function of ω and is 0 or negative for all values of ω.
Re F(s) = 0 for Re s = 0.

Which one of the statements given above is/are correct?
1 only
1 and 4
2, 2 and 4
4 only

⇒ Which amplifier will be preferred for highest gain?
Darlington's pair
Single stage amplifier
Cascade amplifier
Depends on the circuitry

⇒ A JK flip flop has t_pd= 12 ns. The largest modulus of a ripple counter using these flip flops and operating at 10 MHz is
16
64
128
256

⇒ The carriers of n channel JFET are
free electrons and holes
holes
free electrons or holes
free electrons

⇒ For the logic circuit shown in figure, the simplified Boolean expression for the output
A + B + C
AB
B
C

⇒ In a step down chopper using pulse width modulation, T_on = 3 x 10^-3 and T_off = 1 x 10^-3 s. The chopping frequency is
333.33
250
500
1000

⇒ Which is the dominant mode in rectangular waveguides?
TE₁₀
TE₁₁
TE₀₁
TM₁₁

⇒ Which of the following is a valid integer constant?
17
-18.58
101.14
-810