Question is ⇒ The parallel RLC circuit shown in figure is in resonance, Options are ⇒ (A) IR < 1 mA, (B) | IR + IL | > 1 mA, (C) | IR + IL | < 1 mA, (D) | IL + IC | > 1 mA, (E) , Leave your comments or Download question paper.


Q1.	The parallel RLC circuit shown in figure is in resonance
A.	I_R < 1 mA [Wrong Answer]
B.	\| I_R + I_L \| > 1 mA [Correct Answer]
C.	\| I_R + I_L \| < 1 mA [Wrong Answer]
D.	\| I_L + I_C \| > 1 mA [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : Kowsalya Padmanabhan Said on 2020-06-17 09:20:10 Plz explain !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a single phase full converter fed by a source having inductance, the number of thyristors conducting during overlap is
1
2
3
4

⇒ An integrating amplifier has resistance in feedback path.
TRUE
FALSE

⇒ A 4 bit synchronous counter has flip flops having propagation delay of 50 ns each and AND gates having propagation delay of 20 ns each. The maximum frequency of clock pulses can be
20 MHz
50 MHz
14.3 MHz
5 MHz

⇒ For exponential function e^-at the Laplace transform 1/(s - a)
TRUE
FALSE

⇒ A TR (transmitter receiver) tube has
low loss for low power signals and high
high loss for low power signals and low loss for high level signal
low loss for both low level and high level signals
high loss for both low level and high level signals

⇒ For the floating point numbers 1.81 x 10^-29 and 0.0152 x 10¹⁸ the normalised forms are
0.181 x 10^-28 and 0.152 x 10¹⁷respectively
18.1 x 10^-30 and 0.152 x 10¹⁷ respectively
0.181 x 10^-28 and 1.52 x 10¹⁶ respectively
None of the above

⇒ If the Nyquist plot does not encircle the (-1 + j0) point the system is always stable.
TRUE
FALSE

⇒ To realize following function 'f'
3
6
4
10

⇒ In the given figure the reflected voltage wave after first reflectio
18 V
-18 V
30 V
-30 V

⇒ Voltage V_L in the circuit when V_s < 0 where D is an ideal diode. (Take R₁ = R_s = R_L = 1 &o
0
1
1.5
cannot find

⇒ In 8086 microprocessor, if the segment register contains 1 FAB and IP register contains 10AI, the effective memory address is
20B51
304C
FBC0
FDB5

⇒ A notch filter is sometimes used in communication receivers to
reduce receiver gain at some specific frequency
increase receiver gain at some specific frequency
made selectivity more precise
spread the bandwidth

⇒ A 10 GHz signal propagates in a waveguide with a phase velocity of 4 x 10⁸ m/s. If the signal produces standing wave in the guide, then the distance between successive minimal will be
10 mm
20 mm
30 mm
40 mm

⇒ An n type silicon bar 0.1 cm long and 100 μm² in cross-sectional area has a majority carrier concentration of 5 x 10²⁰/m³ and the carrier mobility is 0.13 m⁰/V-s at 300k. If the charge of an electron is 1.6 x 10^-19 coulomb, then the resistance of the bar is
10⁶ ohm
10⁴ ohm
10^-1 ohm
10^-4 ohm

⇒
Assertion (A): The forward resistance of a p-n diode is not constant.
Reason (R): The v-i characteristics of p-n diode is non-linear.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ then Resolution in percent and volt is __________ .
1%, 1 mv
10%, 10 mv
10%, 1 mv
1%, 10 mv

⇒ Wave A = 100 sin ωt and wave B = 100 cos ωt. Then
rms values of the two waves are equal
rms values of A is more than that of B
rms values of A is less than that of B
rms values of the two waves may or may not be equal

⇒ Which of the following statement regarding link loss for a satellite is wrong?
For fixed antenna, it is inversely proportional to f²
For fixed frequency, it is inversely proportional to the product of the antenna aperture areas
For a given satellite operating at a given frequency, it is inversely proportional to
Loss in down-link is negligible as compared to that in uplink

⇒ Germanium and Si phosphorus have their maximum spectral response in the
infrared region
ultraviolet region
visible region
X-ray region

⇒ In a single phase semiconverter feeding a highly inductive load, the load current is
sinusoidal
nearly constant
absolutely constant
rectangular

⇒ In liquids charge carriers are electrons only.
TRUE
FALSE

⇒ The distance of a synchronous satellite from Earth's surface is __________ km.
300
10000
35900
5

⇒ If reflection coefficient is 1/5, then corresponding VSWR is given by
1
2
3
42796

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ Figure shows a self bias circuit for FET amplifier, I_D = 4 mA. Then I_{S4 mA
2 mA
0.4 mA
0.2 mA}

⇒ The gain of an half wavelength antenna is
2.15 dB
10 dB
1.78 dB
100 dB

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
50 Ω
200 Ω
12.5 Ω
0 Ω

⇒ In an inverting amplifier using op-amp the current input to the inverting terminal
is equal to the current through feedback resistance
is less than the current through feedback resistance
is more than the current through feedback resistance
may be equal to, less or more than current through feedback resistance

⇒ Minimum number of J-K flip-flop needed to construct a BCD counter is
2
3
4
5

⇒ A 2 μF capacitor is shunted by a 1 kΩ maintained at temperature 400 K. The rms noise voltage across the capacitor over the entire frequency band is:
6.25 x 10^-8 V
5.25 x 10^-6 V
6.25 x 10^-6 V
5.25 x 10^-8 V

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math