Question is ⇒ A short circuited stub is preferred to an open circuited stub because an open circuited stub, Options are ⇒ (A) is more difficult to fabricate and construct, (B) is made of transmission line of different Z0, (C) is liable to radiate, (D) is incapable of giving full range of reactance, (E) , Leave your comments or Download question paper.

Question is ⇒ A short circuited stub is preferred to an open circuited stub because an open circuited stub, Options are ⇒ (A) is more difficult to fabricate and construct, (B) is made of transmission line of different Z0, (C) is liable to radiate, (D) is incapable of giving full range of reactance, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A short circuited stub is preferred to an open circuited stub because an open circuited stub
A.	is more difficult to fabricate and construct [Wrong Answer]
B.	is made of transmission line of different Z₀ [Wrong Answer]
C.	is liable to radiate [Correct Answer]
D.	is incapable of giving full range of reactance [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Binary storage of decimal number 44 in 8 bits is
101100
10101100
10101101
101101

⇒ The maximum power handling capacity of a resistor depends on
total surface area
resistance value
thermal capacity of the resistor
resistivity of the material used in the resistor

⇒ The generic microprocessor contains a zero and a carry flag. These are located on
interrupt control
status register
either (a) or (b)
none of the above

⇒ A virtual ground is a ground for
voltage
current
both voltage and current
voltage but not for current

⇒ Pick the correct statement with respect to following fig
both the circuit are not identical filter Ckts
identical filter circuit at all frequencies
identical filter circuit at low frequency
identical filter circuit at high frequency

⇒ A constant k low pass T section filter has a characteristic impedance of 600 p at zero frequency. At f = f_c the characteristic impedance is
600 Ω
zero
infinite
more than 600 ohms

⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20

⇒ When the core of a saturable reactor is saturated, the inductance is high.
TRUE
FALSE

⇒ In a two phase servomotor the two stator windings have a phase difference of
30°
45°
90°
135°

⇒ The maximum temperature limit of class B insulation is
90°C
105°C
120°C
130°C

⇒ What is the decimal equivalent of the binary number shown in fourth row?
79
97
117
127

⇒ Lowest noise can be expected in case of
carbon composition resistors
carbon film resistors
tin oxide resistors
metal film resistors

⇒ Which of the following is a vector quantity?
Standing wave ratio
Reflection coefficient
Gain
All of the above

⇒ Slotted line can be used for measurement of high frequencies
TRUE
FALSE

⇒ In a radio receiver, if the intermediate frequency is too low
Image-frequency rejection will improve
Selectivity will be too sharp
The frequency selectivity of the local oscillator will have to be lowered
All of the above

⇒ Choose the correct statement
The reflection coefficient (r) of a transmission line is greater than 1
r varies from 0 to ∞
r is less than or equal to 1
r varies from - ∞ to + ∞

⇒ A casual LTI system is described by the difference equat
|a| = 2 |β| < 2
|a| > 2 |β| > 2
|a| < 2 any value of β
|β| < 2, any value of a

⇒ In an op-amp a virtual ground is a ground for
voltage only
current only
both voltage and current
neither voltage nor current

⇒ When a JFET is cut off, it's like an __________ switch and when it is saturated, it's like a __________ switch.
closed, open
open, closed
open, open
closed, closed

⇒ An audio signal is to be transmitted digitally. Which is the system best suited for good fidelity?
8 bit PCM
13 bit PCM
32 bit PCM
PCM system with non-uniform quantizer

⇒ The clear data and present input of the JK flip-flop are known as
direct inputs
synchronous inputs
indirect inputs
either direct inputs or synchronous inputs

⇒ In audio cassettes the width of each recording track is
5 mm
2.5 mm
1.5 mm
1 mm

⇒ In the circuit shown, the device connected to Y5 can have address in the r
2000 - 20FF
2D00 - 2DFF
2E00 - 2EFF
FD00 - FDFF

⇒ In a coaxial line
the characteristic impedance is less than that of two wire line
the wave velocity is less than that of two wire line
both (a) and (b)
neither (a) nor (b)

⇒ If sequence y(n) = x(-n) then it is
Causal
Non-Causal
Depends on x(-n)
None

⇒ In an R-C series circuit excited by a voltage E, the charge across capacitor at t = 0⁺ is
0
CE
CE (1 - e^-t/RC)
none of the above

⇒ The electric field in a TWT due to applied signal
is directed along the helix axis
is directed radially from helix axis
is inclined to the helix axis by about 60°
is inclined to the helix axis by about 45°

⇒ In a single phase semi-converter the number of thyristors is
16
8
4
2

⇒ Which of the following material is preferred for transformer cores operating in micro wave frequency range?
Ferrites
Silicon steel
Superalloy
Copper

⇒ When an electron breaks a covalent bond and moves away,
a hole is created
a proton is also lost
atom becomes an ion
rest of the electron move at a faster rate