Question is ⇒ The abbreviation DTL stands for, Options are ⇒ (A) Digital Timing Logic, (B) Diode Transistor Logic, (C) Dynamic Transient Logic, (D) Delayed Tracking Logic, (E) , Leave your comments or Download question paper.

Question is ⇒ The abbreviation DTL stands for, Options are ⇒ (A) Digital Timing Logic, (B) Diode Transistor Logic, (C) Dynamic Transient Logic, (D) Delayed Tracking Logic, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The abbreviation DTL stands for
A.	Digital Timing Logic [Wrong Answer]
B.	Diode Transistor Logic [Correct Answer]
C.	Dynamic Transient Logic [Wrong Answer]
D.	Delayed Tracking Logic [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If X = 1 in the logic equation [X + Z { Y + (Z + X Y)}] { X + Z (X + Y)} = 1, then
Y = Z
Y = Z
Z = 1
Z = 0

⇒ The area of an impulse is
1
0
∞
any finite value

⇒ It is necessary to measure the amplitudes of two signals and also the phase difference between them. This can be done by using a
phase meter
waveform meter
vector voltmeter
digital voltmeter

⇒ The sum of two sine waves of different frequencies is a sine wave.
TRUE
FALSE

⇒ A single phase fully controlled bridge rectifier is fed by a source having inductance. The output voltage during overlap period is
V_m
0.5 V_m
zero
0.5 V_m - voltage drop across inductance

⇒ In a CE amplifier the ac emitter resistance
is zero
is high
is very high
may have any value

⇒ Figure shows a pole zero plot of I(s). The likely current response in time domai
i (t) = e^-1 - e^-3t
i (t) = e^-1 - 2e^-2t
i (t) = e^-1 - e^-2t
i (t) = e^-1 - e^-4t

⇒ An arithmetic statement in C must be
integer mode arithmetic statement
real mode arithmetic statement
mixed mode arithmetic statement
any of the above

⇒ A short circuited stub is shunt connected to a transmission line as shown in the figure is, if z₀ = 500 ohms, the admittance y seen at the function of the stub and the transmission line
(0.01 - j 0.02) mho
(0.02 - j 0.01) mho
(0.04 - j 0.02) mho
(0.02 + j 0) mho

⇒ Which of the following is not an electromagnetic device?
Hall transducer
Transformer
Speedometer
Eddy current damping device

⇒ The scale of hot wire ammeter is
linear
non-linear
cramped
absolute linear

⇒ Consider the follo
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R_E
decrease the voltage gain and decrease the I/P impedance
increase the voltage gain and decrease the I/P Impedance
decrease the voltage gain and Increase the I/P impedance
none of the above

⇒ For a series RLC circuit bandwidth is ω₂ - ω₁ = R/2L.
TRUE
FALSE

⇒ Which of the following is true about an impulse voltage?
It is a unidirectional voltage
Chopped impulse flashover does not occur
Time taken to rise is equal to time taken to fall
RMS value is always less than 50% of average value

⇒ In the expression A + BC, the total number of minterms will be
2
3
4
5

⇒ Circular polarized waves result when
magnitudes are the same
phases are the same
magnitudes are same and phase difference is 90°
magnitudes are same and phase difference is zero

⇒ Thermosetting polymers are
injection moulded
extruded
cast moulded
none of the above

⇒

Assertion (A): In TV scanning is done from left to right and top to bottom.

Reason (R): Interlaced scanning is useful in eliminating flicker

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the following time parameters

Domain growth time constant.
Transit time.
Dielectric relaxation time in positive mobility regime.

Which of the above are used in connection width transferred electron device?
1, 2, and 3
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Present day stereophonic systems have
only CD playback facility
only tape playback facility
both CD and tape playback facilities along with radio
none of the above

⇒ A 1000 kHz carrier wave modulated 40% at 4000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulation after passing the wave through this circuit?
0.4
0.2
0.27
0.554

⇒ An air-filled rectangular waveguide has dimensions 8cm x 10cm . The group velocity is
1.8 x 10⁸ m/s
2.6 x 10⁸ m/s
3 x 10⁸ m/s
0.3 x 10⁸ m/s

⇒ Transfer function of a certain system
2 sec
4 sec
6 sec
8 sec

⇒ In which amplifier circuit is gate conductance negligible?
JFET amplifier
MOSFET amplifier
Both JFET and MOSFET amplifier
None of the above

⇒ Thermal run away of a transistor occurs when
heat dissipation from transistor is excessive
transistor joints melt due to high temperature
there is excessive leakage current due to temperature rise
none of the above

⇒

Assertion (A): A PROM can be used as a synchronous counter

Reason (R): Each memory location in a PROM can be read synchronously.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): An on off controller gives rise to oscillation of the output between two limits.

Reason (R): Location of a pair of poles on jω axis gives rise to self sustained oscillations in the output.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In a self bias circuit for CE amplifier, an increase in emitter resistance R_E results in
increase in emitter voltage
decrease in emitter voltage
increase in emitter current
decrease in emitter current

⇒ A 2 μF capacitor is shunted by a 1 kΩ maintained at temperature 400 K. The rms noise voltage across the capacitor over the entire frequency band is:
6.25 x 10^-8 V
5.25 x 10^-6 V
6.25 x 10^-6 V
5.25 x 10^-8 V