Question is ⇒ It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are, Options are ⇒ (A) 60 and 15, (B) 15 and 60, (C) 6 and 1.5, (D) 1.5 and 6, (E) , Leave your comments or Download question paper.

Question is ⇒ It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are, Options are ⇒ (A) 60 and 15, (B) 15 and 60, (C) 6 and 1.5, (D) 1.5 and 6, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are
A.	60 and 15 [Correct Answer]
B.	15 and 60 [Wrong Answer]
C.	6 and 1.5 [Wrong Answer]
D.	1.5 and 6 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Fermi level in intrinsic semiconductor is at the centre of forbidden energy band.
TRUE
FALSE

⇒ In figure which diode will conduct and what will be the value of V_{0D₃, 1 V
D₁, 2 V
D₂, 5 V
D₁, 5 V}

⇒ Maximum undistorted power output of a transmitter is obtained when its modulation is __________ percent.
more than 100
100
less than 100
50

⇒ In 8085 microprocessor, what is the memory word addressing capability?
32 K
64 K
256 K
512 K

⇒ Varactor diode is forward biased when it is used.
TRUE
FALSE

⇒ At absolute temperature
the forbidden energy gap in germanium is higher than that in silicon
the forbidden energy gap in germanium and silicon are equal
the forbidden energy gap in silicon is higher than that in germanium
none of the above

⇒ To obtain very high I/P and O/P impedances in a feedback amplifier, the topology used is
voltage series
current series
voltage shunt
current shunt

⇒ A divide by 78 counters can be realized by using
six mod-13 counters
thirteen mod-6 counters
one mod 13 counter followed by one mod-6 counter
thirteen mod-13 counters

⇒ In the given figure shows a root locus plot. Consider the following statements for this plot

The open loop system is a second order system
The system is overdamped for K > 1
The system is stable for all values of K

Which of the above statements are corr
1, 2, 3
1, 3
2, 3
1, 2

⇒ Consider the following statement associated with bipolar junction transistor and JFET

The former has higher input impedance than the later
The former has higher frequency stability than the later
The later has lower noise figure than the former
The later has higher power rating than the former.

Of these statements
1 and 2 are correct
2 and 3 are correct
3 and 4 are correct
1 and 4 are correct

⇒ Consider the following stateme
1, 4 are correct
1 and 2 correct
1, 2, 3 are correct
2, 3, 4 are correct

⇒ Which one of the following blocks is not common in both AM and FM receivers?
RF amplifier
Mixer
IF amplifier
Slope detector

⇒ The term efficacy, is defined by
same as efficiency
measure of the ability of a device to produce a desired effect
input/output
(efficiency)²

⇒ In 8085 eight address and data buses are multiplexed.
TRUE
FALSE

⇒ In the signal flow graph in the given figure the number of forward paths and pairs of non-touching loops are respecti
3 and 1
3 and 2
4 and 2
2 and 4

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W

⇒

Match the following:

	List I		List II
A.	Direct addressing	1.	MOV A, M
B.	Register addressing	2.	MOV C, A
C.	Register indirect addressing	3.	LDA 7
D.	Immediate addressing	4.	STA FFC

A-1, B-2, C-3, D-4
A-4, B-2, C-1, D-3
A-2, B-3, C-4, D-1
A-3, B-2, C-1, D-4

⇒ In the circuit of fi
V_a would always lag V_b
V_a would always lead V_b
V_a and V_b can be in phase
phase angle between V_a and V_b would always be 90°

⇒ The analog signal given below is sampled at 1200 samples per second. m(t) = 2 sin 120 pt + 3 sin 240 pt + 4 sin 360 pt + 5 sin 480 pt + 6 sin 600 pt + 7 sin 720 pt. The folding (maximum) frequency is __________ .
300 Hz
360 Hz
600 Hz
480 Hz

⇒ Intrinsic or characteristic impedance of free space has a value of
120 ohm
73 ohm
73 ε ohm
120 ε ohm

⇒ Assume that x = 7, the Java operation x = x - means that final value of x is
7
-1
6
-6

⇒ Which of these instruments is dynamometers type?
Wattmeter
Power factor meter
Frequency meter
Both (a) and (b)

⇒ Calculate the stability factor and change in I_c from 25°C to 100°C for, β = 50, R_B/R_E = 250, ΔI_CO = 19.9 nA for emitter bias configuration
42.553, 0.85 μF
40.91, 0.58 μF
38.53, 0.85 μF
41.10, 0.39 μF

⇒ For making a capacitor, the dielectric should have
high ∈_r
low ∈_r
∈_r = 1
∈_r neither too high nor too low

⇒ Which of the following microphones has lowest output impedance?
Moving coil
Ribbon
Crystal
Condenser

⇒ In figure, the current through 10 V batter
0
0.5 A charging
0.5 A discharging
none of the above

⇒ High speed logic circuits use
pulses with very small width
pulses with very large width
pulses whose width is neither small nor large
either (b) or (c)

⇒ Saturation of iron core causes distortion.
TRUE
FALSE

⇒

Assertion (A): An SR latch has the problem of RAC condition

Reason (R): While designing a digital circuit RAC condition should be avoided.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In Java which operator can be used even if there is a single operand
+
-
*
%