Question is ⇒ In figure which diode will conduct and what will be the value of V0</s, Options are ⇒ (A) D3, 1 V, (B) D1, 2 V, (C) D2, 5 V, (D) D1, 5 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure which diode will conduct and what will be the value of V0</s, Options are ⇒ (A) D3, 1 V, (B) D1, 2 V, (C) D2, 5 V, (D) D1, 5 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure which diode will conduct and what will be the value of V₀
A.	D₃, 1 V [Wrong Answer]
B.	D₁, 2 V [Wrong Answer]
C.	D₂, 5 V [Correct Answer]
D.	D₁, 5 V [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A signal x(t) = 100 cos (24p x 10³t) is ideally sampled with a sampling period of 50 μ sec and then passed through an ideal low pass filter with cut off frequency of 15 kHz Which of the following frequencies are present at the filter output?
12 kHz only
8 kHz only
12 kHz and 9 kHz
12 kHz and 8 kHz

⇒ For type 0 system the starting point (i.e. ω = 0) of polar plot is finite and is on positive real axis.
TRUE
FALSE

⇒ The dependent current source shown in given fig
delivers 80W
absorbs 80W
deliver 40W
absorbs 40W

⇒ What is the address space of 8086 CPU?
One Megabyte
256 Kilobytes
1 K Megabytes
64 Kilobytes

⇒ A generated voltage is equally dependent on three resistances R₁, R₂, R₃ and its value is V = (R₁R₂)/R₃. If tolerance of each resistor is 0.1%, the maximum error in voltage is
0.003
± 0.3%
0.001
± 0.1%

⇒ Lower chip area requirements of MOS is advantage in
low power circuits
high power circuits
repetitive operation circuits
large scale integration

⇒ An RLC series circuit is underdamped. To make it overdamped, the value of R
has to be increased
has to be decreased
has to be increased to infinity
has to be reduced to zero

⇒ In a transistor β_dc is likely to vary between 100 and 400. The proper value of β_dc to be used to located Q point is
100
400
250
200

⇒ If three cascaded stages of amplifier have gains 10, 20 and 30 the overall voltage will be
30
60
600
6000

⇒ In the circuit shown in figure the current I of sinusoidal sourc
25 A
0.166666666666667
20 A
Not determinable from given data

⇒ In its lowest state, the electron is bound to the field of proton by an energy equal to
100.5 eV
51.2 eV
13.6 eV
0.2 eV

⇒

Assertion (A): In n-p-n transistor conduction is mainly due to electrons.

Reason (R): In n type materials electrons are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): The impedance of a series resonant circuit is minimum at resonance.

Reason (R): Resonance condition implies unity power factor condition.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If the mantissa has a sign bit of 0 and the exponent is changed from a negative number to a more positive number the result is
a positive number and closer to zero
a positive number and away from zero
a negative number
a negative number and closer to zero

⇒ MS Excel is an application software for financial planning.
TRUE
FALSE

⇒ The Thevenin's equivalent of network in figure(1) is a 10 V source in series with 2 Ω resistance. If a 3 Ω resistance is connected across AB as shown in figure(2) the Thevenin's equivalen
10 V in series with 1.2 Ω resistance
6 V in series with 1.2 Ω resistance
10 V in series with 5 Ω resistance
6 V in series with 5 Ω resistance

⇒ At a very low temperature, a semiconductor
becomes a conductor
becomes an insulator
may become a conductor or an insulator
will remain a semiconductor becomes a conductor or an insulator

⇒ In log magnitude Bode diagram the slope of high frequency asymptote of (1 + jωT) is
20 dB per decade
10 dB per decade
20 dB per octave
10 dB per octave

⇒ The dead zone in a pyrometer is 0.125% of span. The calibration is 400°C to 1000°C. What temperature change might occur before it is detected.
0.125°C
0.75°C
0.4°C
1°C

⇒ The IF stage of a receiver employs
capacitive coupling
impedance coupling
double-tuned transformer coupling
single-tuned transformer coupling

⇒ A sample of N-type semiconductor has electron density of 6.25 x 10¹⁸/cm³ at 300k. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature the hole density works out to be
10⁶/cm³
10⁸/cm³
10¹⁰/cm³
10^l2/cm³

⇒ A reverse voltage of 18 V is applied to a semiconductor diode. The voltage across the depletion layer is
0 V
0.7 V
about 10 V
18 V

⇒ In the spectrum of a FM wave
the carrier frequency cannot disappear
the carrier frequency disappears when the modulation index is large
the amplitude of any sideband depends on the modulation index
the total number of sidebands depends on the modulation index

⇒ One eV = 1.602 x 10^-19 joules.
TRUE
FALSE

⇒ Amplification of ultrasonic waves is possible in a piezoelectric semiconductor under applied electric field. The basic phenomenon involved is known as
electrostriction
acousto-optic interaction
acousto-electric interaction
stimulated Brillouin scattering

⇒ The efficiency of a direct radiating cone type loudspeaker is about
0.05
0.2
0.5
0.8

⇒ Which of the following can not be used as a variable name in C?
else
coal
ram
vendy

⇒ The switch board instruments
should be mounted in vertical position
should be mounted in horizontal position
should be mounted at about 45°
should be mounted at about 80°

⇒ Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?
Measurement of unknown voltage
Measurement of resistance
Measurement of unknown current
Calibration of voltmeter

⇒ In a cellular communication system, path loss between transmitter and receiver is due to
scattering from building, trees, vehicles and other structure
reason at (a) above and due to reflections from ground only
reason at (a) and (b) above along with reflections from ionosphere only
reasons at (a), (b) and (c) above along with loss due to surface wave phenomenon