Question is ⇒ An FM signal with a deviation δ is passed through a mixer, and has its frequency reduced 5 fold. The deviation in the output of the mixer is, Options are ⇒ (A) 5/δ, (B) Intermediate, (C) δ/5, (D) δ, (E) , Leave your comments or Download question paper.

Question is ⇒ An FM signal with a deviation δ is passed through a mixer, and has its frequency reduced 5 fold. The deviation in the output of the mixer is, Options are ⇒ (A) 5/δ, (B) Intermediate, (C) δ/5, (D) δ, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An FM signal with a deviation δ is passed through a mixer, and has its frequency reduced 5 fold. The deviation in the output of the mixer is
A.	5/δ [Wrong Answer]
B.	Intermediate [Wrong Answer]
C.	δ/5 [Wrong Answer]
D.	δ [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Nichrome is used for
overload line wires
heater coils
lamp filaments
all of the above

⇒ The induced magnetic dipole moment has a direction opposite to the applied magnetic field.
TRUE
FALSE

⇒ When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common base short circuit current gain a for the transistor is
0.99
1.01
1.001
0.99

⇒ For the logic circuit of the given figure the simplified Boolean expressio
Y = AB + A C
Y = (AB) (A C)
Y = ABC
Y = A B + A C

⇒ The current I in the circuit show
- j1 A
j1 A
0
20 A

⇒ Consider the following statements about 8085

The instruction LDA uses direct addressing mode.
The instruction MVI uses direct addressing mode.
The instruction MVI uses immediate addressing mode.
The instruction LDA uses immediate addressing mode.

Which of the above are correct?
1 and 3 only
3 and 4 only
1 and 2 only
2 only

⇒ In the field controlled motor the entire damping comes from
armature resistance
back emf
motor friction and load
field resistance

⇒ The circuit in figur
CE amplifier
CB amplifier
Constant voltage source
Constant current source

⇒ A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be
zero or 16 W
4 W or 8 W
zero or 8 W
8 W or 16 W

⇒ Two identical silicon diodes D₁ and D₂ are connected back to back shown in figure. The reverse saturation current I_s of each diode is 10^-8 amps and the breakdown voltage V_Br is 50 v. Evaluate the voltages V_D1 and V_D2 dropped across the diodes D₁ and D₂ assuming KT/q to be 25
4.983 V, 0.017 V
- 4.98 V, - 0.017 V
0.17 V, 4.983 V
- 0.017 V, - 4.98 V

⇒ Most of the amplification of the received signal is obtained in a superheterodyne receiver from the
IF stage
RF stage
power amplification stage
none of the above

⇒ Which of the following is basically a voltage controlled capacitance?
Zener diode
Diode
Varactor diode
LED

⇒

Assertion (A): KCL is dual of KVL.

Reason (R): Node is dual of mesh.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A current of 1 A in the coil of an iron cored electromagnet causes B = 0.5T. If current is 2A, B =
0.5 T
1 T
1 T or more
1 T or less

⇒ Which of these commutation methods uses two leads?
Class A
Class B
Class C
Class D

⇒ In a stereo tape recorder the speed of the tape is
38 m/s
19 m/s
9.5 m/s
4.75 m/s

⇒ Typical value of power consumption of TV transmitter is
0.5 kVA
2 kVA
50 kVA
1000 kVA

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒ The power factor at the input terminals of a cyclo- converter is generally
low and leading
low and lagging
high and leading
high and lagging

⇒ In a 3 phase system, the zero sequence component of line to line voltages is zero
if line to line voltages are balanced
if line to line voltages are unbalanced
if line to line voltages are balanced or unbalanced
if degree of unbalanced in line to line voltages is small

⇒ When sources of different frequencies feed a network the only method of solution is superposition theorem.
TRUE
FALSE

⇒ The precision of an instrument indicates its ability to reproduce a certain reading with a given
drift
resolutions
shift
consistency

⇒ Incompatibility between memory and I/O device may be due to
timing according to which data transfer is to take place
electrical characteristics of the two devices
format of data transfer
all of the above

⇒ The problem of logic race occurs in
SOP functions
POS functions
Hybrid function
SOP and POS functions

⇒ From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier
gain bandwidth product
slew rate
upper 3 dB frequency
lower 3 dB frequency

⇒ A dipole antenna of λ/8 length has an equivalent total loss resistance of 1.5 Ω. The efficiency of the antenna is
0.0089159
0.089159
0.89159
8.9159

⇒ Two passive elements are connected in series and a dc voltage is applied to the circuit. The time variation of the current is shown in figure. The two elements
one resistance and the other inductance
both resistances
one inductance and the other capacitance
one resistance and the other capacitance

⇒ In practical commercial AM system channel bandwidth is
150 kHz
100 kHz
15 kHz
200 kHz

⇒ As compared to dimensions of most feeds, the skin depth at microwave frequencies is
of the same magnitude
much larger
much smaller
either (b) or (c)

⇒ An intrinsic silicon sample has 1 million free electrons at room temperature. As the temperature is increased
the number of free electrons increases
the number of free electrons increases but the number of holes decreases
the number of free electrons and holes increase by the same amount
the number of free electrons and holes increase but not by the same amount