Question is ⇒ A proportional controller is basically, Options are ⇒ (A) an amplifier with adjustable gain, (B) an integrating amplifier, (C) an amplifier with infinite gain, (D) an amplifier with almost zero gain, (E) , Leave your comments or Download question paper.

Question is ⇒ A proportional controller is basically, Options are ⇒ (A) an amplifier with adjustable gain, (B) an integrating amplifier, (C) an amplifier with infinite gain, (D) an amplifier with almost zero gain, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A proportional controller is basically
A.	an amplifier with adjustable gain [Correct Answer]
B.	an integrating amplifier [Wrong Answer]
C.	an amplifier with infinite gain [Wrong Answer]
D.	an amplifier with almost zero gain [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ One advantage of using polar plot is that it depicts the frequency response characteristics over the entire frequency.
TRUE
FALSE

⇒

Assertion (A): The maximum range of a radar is proportional to fourth root of the peak transmitted pulse power.

Reason (R): Radar signals are subjected twice to inverse square law.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ It is difficult to write a program in a machine language.
TRUE
FALSE

⇒ If X(z) = (1 - az^-1)^-1 and |a| < |z|, the initial value x₀ = 0
TRUE
FALSE

⇒ Which of the following flip-flop is used as a latch?
J K flip-flop
R S flip-flop
T flip-flop
D flip-flop

⇒ A line is excited by a 100 V, 200 ohm source and is terminated by 100 Ω resistance. If the voltage on line reaches steady value in 80 ns, the natural resonant frequency is
100 MHz
50 MHz
12.5 MHz
6.25 MHz

⇒ If all the LEDs in a seven segment display are turned on, the number displayed is
1
3
0
8

⇒ In the given figure 15.6 shows a series, R - C circuit fed by a current source i(t). There is an initial voltage v₀. across the capacitor. The sy
is linear
is non linear
may be linear or non linear
is linear only if v₀ is zero

⇒ A 4 bit synchronous counter uses flip flops with a delay time of 15 ns each. The time required for change of state is
15 ns
30 ns
45 ns
60 ns

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ In a sine wave, maximum rate of change of voltage occurs at
ascent of the waveform
+ ve maximum
- ve maximum
between maximum and minimum

⇒ The circuit of the given figure perf
OR function
AND function
exclusive OR function
exclusive NOR function

⇒ In the periodic train of rectangular pulses F₀ = (V₀/T)d
TRUE
FALSE

⇒
Assertion (A): Absolute instruments are used in standard laboratories.
Reason (R): Absolute instruments do not require calibration.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ When a transistor is connected in common emitter mode, it with have
negligible input resistance and high output resistance
high input resistance and low output resistance
medium input resistance and high output resistance
low input resistance as well as output resistance

⇒ In a 3 input NOR gate, the number of states in which output is 1 equals
1
2
3
4

⇒
Assertion (A): The behaviour of FET is similar to that of a pentode.
Reason (R): FETs and vacuum triode are voltage controlled devices.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The input voltage for starting oscillations in an oscillator is caused by
negative feedback
positive feedback
noise voltage in resistors
a special generator

⇒ In any two port network, input impedance is independent of load impedance.
TRUE
FALSE

⇒ The voltage across a zener diode
is constant in forward direction
is constant in reverse direction
is constant in both forward and reverse directions
none of the above

⇒ 300 to 3000 MHz frequency is categorized as
MF
HF
UHF
SHF

⇒ Electric breakdown strength of a material depends on its
composition
moisture content
thickness
all of the above

⇒ In N channel MOSFET with gate reverse biased, the gate current is of the order
10^-3 amp
10^-6 amp
10^-9 amp
10^-12 amp

⇒ In figure, i(0^-) and v(0^-) are zero. The switch is closed at t = 0, i(0⁺) and (∞)
3 A and 1.5 A
1.5 A and zero
3 A and zero
1.5 A and 3 A

⇒ Absolute permeability (μ) is given by __________ henry/metre
4p x 10^-12
4p x 10^-7
8.854 x 10^-12
8.854 x 10^-7

⇒ When a p-n-p transistor is operating in active region, the current in the n region is due to
only holes
only electrons
mainly holes
mainly electrons

⇒ Method of images is applicable to which fields?
Electrostatic fields only
Electrodynamic fields only
Neither electrostatic fields nor electro-dynamic fields
Both electrostatic fields and electro-dynamic fields

⇒ In a single phase semiconverter feeding a highly inductive load, the load current is
sinusoidal
nearly constant
absolutely constant
rectangular

⇒ In a single phase full wave ac regulator, the firing angles in the two half cycles
are always equal
are sometimes equal
are never equal
may be equal or unequal

⇒ In a transistor with normal bias
the emitter junction has a low resistance
the emitter junction has a very high resistance
the emitter junction supplies majority carries into the base region
none of the above

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math