Question is ⇒ Voltage series feedback (Also called series-shunt feedback) results in, Options are ⇒ (A) increase in both I/P and O/P impedances, (B) decrease in both I/P and O/P impedances, (C) increase in I/P impedance and decrease in O/P impedance, (D) decrease in I/P impedance and increase in O/P impedance, (E) , Leave your comments or Download question paper.

Question is ⇒ Voltage series feedback (Also called series-shunt feedback) results in, Options are ⇒ (A) increase in both I/P and O/P impedances, (B) decrease in both I/P and O/P impedances, (C) increase in I/P impedance and decrease in O/P impedance, (D) decrease in I/P impedance and increase in O/P impedance, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Voltage series feedback (Also called series-shunt feedback) results in
A.	increase in both I/P and O/P impedances [Wrong Answer]
B.	decrease in both I/P and O/P impedances [Wrong Answer]
C.	increase in I/P impedance and decrease in O/P impedance [Correct Answer]
D.	decrease in I/P impedance and increase in O/P impedance [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In Weston frequency meter, the magnetic axes of the two fixed coils are
parallel
perpendicular
inclined at 60°
inclined at 15°

⇒ The correct sequence of parts in klystron amplifier are
anode, catcher cavity, cathode, buncher cavity
cathode, buncher cavity, catcher cavity, cavity
anode, buncher cavity, catcher cavity, cathode
cathode, catcher cavity, anode, buncher cavity

⇒ The impedance of an RC series circuit is 12 Ω at f= 50 Hz. At f= 200 Hz, the impedance will be
more than 12
less than 3
more than 3 Ω but less than 12 Ω
more than 12 Ω but less than 24 Ω

⇒ Figure shows an R-L circuit. The current is i = 1 - e^-t. The rate of change of current at t = 1 secon
1 A/s
0.63 A/s
0.37 A/s
0

⇒ In the full adder, denoting Sum by S and carry by C
S = 1 when two or more inputs are unity
C = 1 when two or more inputs are unity
C = 1 when all the inputs are unity
S = 1 when all the inputs are unity

⇒ Bipolar IC memories are fabricated using
high density versions of MOSFET or low density versions of bipolar transistor flip-flop.
high density version of MOSFET or bipolar transistor flip-flop
low density versions of MOSFETs
high density versions of the bipolar transistor flip-flop.

⇒ A two branch parallel tuned circuit has 100 Ω resistance and 0.1 H inductance in one branch and 10^-6 F capacitor in the other. At resonance frequency, the dynamic resistance is
10 Ω
100 Ω
1000 Ω
10000 Ω

⇒ For a reactance function H(s)
Re [H(jω)] is positive for ω ≥ 0
Re [H(jω)] is zero for ω ≥ 0
Re [H(jω)] is positive or zero for ω ≥ 0
Re [H(jω)] is zero or negative for ω ≥ 0

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode

⇒ The main use of JFET with a
frequency mixer
source follower
voltage doubler
trigger

⇒ Frequency domain of a periodic triangular function is a
discrete sinc function
continuous sampling function
discrete sampling function
continuous sampling square function

⇒ Which one of the following is applicable to any network-linear or non-linear, active or passive, time-varying or invariant - as long as Kirchhoff laws are not violated?
Tellegen's theorem
Reciprocity theorem
Maximum power transfer theorem
Superposition theorem

⇒ Consider the resonant circuit as shown b
R = 10⁴ L = 5 μH C = 20 pF
1000 L = 50 μH C = 200 pF
10 K L = 50 μH C =20 pF
None of these

⇒ The decimal equivalent of ABC₁₆ is
348
2583
2748
33

⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?
0.001
0.005
0.01
0.02

⇒ The satellites used for intercontinental communication are called
Comsat
Domsat
Marisat
Intelsat

⇒ The precision of an instrument indicates its ability to reproduce a certain reading with a given
drift
resolutions
shift
consistency

⇒ A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is
0.001
1000
2 digit
1 mV

⇒ Thin gate oxide in a CMOS process in preferably grown using
wet oxidation
dry oxidation
epitaxial deposition
ion implantation

⇒ A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = V_m sin ωt. The thyristor will conduct
from 0 to 180°
when v > 50 V
from 0 to 90°
When v < 50 V

⇒ A (75 - J50) ohm load is connected to a coaxial of Z₀ = 75 ohm at 10 GHz. The best method of matching is to connect
an inductance at load
a short circuited stub at load
a short circuited stub at specific distance from load
a capacitance at specific distance from load

⇒ In modern MOSFET_S, the material used for the gate is
high purity silicon
high purity silica
heavily doped polycrystalline silicon
epitaxial grown silicon

⇒

Assertion (A): Secondary instruments require calibration at frequent intervals.

Reason (R): Secondary instruments have many errors.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If u is input, y is output and a, b are constants, the system y = au + b
is linear
is nonlinear
may be linear or nonlinear dependig on values of a and b
may be linear or nonlinear depending on value of u

⇒ Which of the following is wrong for a magic used to tee?
E and H arms are decoupled
coplanar arms are coupled
all ports are perfectly matched
A signal into coplanar arm splits equally between E and H arms

⇒ A directional coupler is used to determine
r_v
r_v and VSWR
L and C
wave velocity

⇒ For F₁ layer the maximum ionic density is 2.3 x 10⁴ electrons per cc. The critical frequency for this layer will be
1.36 MHz
13.6 MHz
136 MHz
1360 MHz

⇒ Find the value of i_x if each resistance is of 3 Ω and each battery is of
1.1428 V
1.432 A
0.2892 A
O A

⇒

Assertion (A): A radiation pyrometer is very suitable for high temperature measurement.

Reason (R): When temperature is high, a physical contact between hot body and thermometer is not desirable.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A dc series motor is coupled to a load whose torque is proportional to speed. It is fed by a single phase ac supply through a full converter. When speed is 500 rpm, firing angle is 45°. It is desired to raise the speed. It will be necessary to
decrease the firing angle
increase the firing angle
either decrease or increase the firing angle depending on the required speed
decrease the load torque