Question is ⇒ In the circuit shown in the fi, Options are ⇒ (A) only red will glow, (B) only green will glow, (C) both red and green will glow, (D) none will glow, (E) , Leave your comments or Download question paper.

Question is ⇒ In the circuit shown in the fi, Options are ⇒ (A) only red will glow, (B) only green will glow, (C) both red and green will glow, (D) none will glow, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the circuit shown in the fi
A.	only red will glow [Correct Answer]
B.	only green will glow [Wrong Answer]
C.	both red and green will glow [Wrong Answer]
D.	none will glow [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Decimal -90 equals __________ in 8 bit 2s complement
1000 1000
1010 0110
1100 1100
0101 0101

⇒

Assertion (A): The time response, usually, is slower with lag compensation.

Reason (R): The natural undamped frequency and bandwidth are increased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The Thevenin's equivalent of network in figure(1) is a 10 V source in series with 2 Ω resistance. If a 3 Ω resistance is connected across AB as shown in figure(2) the Thevenin's equivalen
10 V in series with 1.2 Ω resistance
6 V in series with 1.2 Ω resistance
10 V in series with 5 Ω resistance
6 V in series with 5 Ω resistance

⇒ The electrolyte in a dry cell is completely dry.
TRUE
FALSE

⇒ A zinc carbon cell is a primary cell.
TRUE
FALSE

⇒ A sequence x(n) with the z transform X(z) = z⁴ + z² - 2z + 2 - 3z - 4 is applied as an input to a linear, time invariant system with the impulse response h(n) = 2δ(n - 3) wh
-6
zero
2
-4

⇒ A full adder can be made out of
two half adders
two half adders and a OR gate
two half adders and a NOT gate
three half adders

⇒ In a resistive ac circuit, the current __________ the voltage by __________ .
lags, 90°
lags, 45°
lags, 0°
leads 90°

⇒ The carrier mobility in a semiconductor is 0.4 m²/Vs. Its diffusion constant at 300k will be (in m²/s).
0.43
0.16
0.04
0.01

⇒ An RC snubber circuit is used to protect a thyristor against :
false triggering
failure to turn on
switching transients
failure to commutate

⇒ In order to obtain triangular pulses at the output of the circuit in the figure, the input should
grounded
a square wave
Triangular wave
Trigger

⇒ The number of spectral component when two cosine waves are multiplied of different frequency
1
2
8
4

⇒ The frequencies in ultra high frequency range are propagated by means of __________ waves
surface
ground
sky
space

⇒ A non-inverting voltage feedback amplifier is a
voltage amplifier
current amplifier
current to voltage converter
voltage to current converter

⇒ In 8355, the ROM is organized as __________ words of 8 bits each.
2000
2048
8355
835

⇒ For pole-zero plot shown, the system is ________
minimum phase
maximum phase
mixed phase
none of these

⇒ A counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time
8 μ sec
10 μ sec
2 μ sec
5 μ sec

⇒ Z_L = 200 Ω and it is desired that Z_i = 50 Ω The quarter wave transformer should have a characteristic impedance of
100 Ω
40 Ω
10000 Ω
4 Ω

⇒ The following switching functions are to be implemented using a decoder

f₁ = ∑m (1, 2, 4, 8, 10, 14)
f₂ = ∑m (2, 5, 9, 15)
f₃ = ∑m (2, 4, 5, 6, 7)

The minimum configuration of decoder is
2 to 4 line
3 to 8 line
4 to 16 line
5 to 32 line

⇒ A three terminal monolithic IC regulator can be used as
an a adjustable output voltage regulator alone
an adjustable output voltage regulator & a current regulator
a current regulator & a power switch
a current regulator alone

⇒ Radiation resistance of an antenna is a
dc resistance
ac resistance
either (a) or (b)
none of the above

⇒ Which of these instrument does not have a control spring?
Moving iron ammeter
PMMC ammeter
Electrostatic voltmeters
Power factor meter

⇒

Match the following:

	List I (Library function in Pascal)		List II (Type of argument)
A.	ROUND X	1.	X in radians
B.	ABS X	2.	X real
C.	SQR X	3.	X real or integer
D.	SIN X

A-2, B-3, C-3, D-1
A-2, B-3, C-1, D-3
A-3, B-2, C-2, D-1
A-2, B-3, C-2, D-1

⇒ In a series RLC circuit the dB level of currents at half power frequencies as compared to current at resonance is
3
-3
0.5
-0.5

⇒ In figure the approximate voltage
base and emitter are - 8 V and - 7.3 V
base and collector are - 8 V and - 5 V
collector and emitter are - 5 V and - 7.3 V
base, emitter and collector are - 8, - 7.3 and - 5 V

⇒ When a transistor is connected in common emitter mode, it with have
negligible input resistance and high output resistance
high input resistance and low output resistance
medium input resistance and high output resistance
low input resistance as well as output resistance

⇒ A (75 - j 50) Ω load is connected to a coaxial line of Z₀ = 75 Ω at 10 GHz. The best method of matching consists of using
a capacitance at some specific distance from load
a short circuited stub at some specific distance from load
an inductance at load
a short circuited stub at load

⇒ In an 8085 microprocessor, the instruction CMP B has been executed while the content of the accumulator is less than that of register B, As a result.
carry flag will be set but zero flag will be reset
carry flag will be reset but zero flag will be set
both carry flag and zero flag will be reset
both carry flag and zero flag will be set

⇒ Amplification of ultrasonic waves is possible in a piezoelectric semiconductor under applied electric field. The basic phenomenon involved is known as
electrostriction
acousto-optic interaction
acousto-electric interaction
stimulated Brillouin scattering

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1