Question is ⇒ The video heads, in VCR, feed the other circuit, Options are ⇒ (A) directly windings, (B) through a transformer having two rotating windings, (C) through a transformer having two stationary windings, (D) through a transformer having one stationary and one rotatory winding, (E) , Leave your comments or Download question paper.

Question is ⇒ The video heads, in VCR, feed the other circuit, Options are ⇒ (A) directly windings, (B) through a transformer having two rotating windings, (C) through a transformer having two stationary windings, (D) through a transformer having one stationary and one rotatory winding, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The video heads, in VCR, feed the other circuit
A.	directly windings [Wrong Answer]
B.	through a transformer having two rotating windings [Wrong Answer]
C.	through a transformer having two stationary windings [Wrong Answer]
D.	through a transformer having one stationary and one rotatory winding [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A d.c. power supply has an open circuit voltage of 100 V. When the full load current is drawn, the output drops to 80 V. The percentage voltage regulation is
0.9725
0.75
0.5
0.25

⇒ The output v-i characteristics of enhancement type MOSFET has
only an ohmic region
only a saturation region
an ohmic region at low voltage value and a saturation region at high voltage
a saturation region at low voltage value and an ohmic region at high voltage

⇒

Assertion (A): PIN diode is used as a fast switch.

Reason (R): PIN diode has very high resistance when reverse biased and very low resistance when forward biased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because
it loads the circuit to maximum extent
it loads the circuit moderately
it does not load the circuit at all
it uses centre zero galvanometer instead of Voltmeters

⇒ In a valence crystal, the valence electrons
are not shared
are shared between neighbouring atoms
are shared by all atoms
any of the above

⇒ Zero mean Gaussian noise of variance N is applied to a half wave rectifier. The mean squared value of the rectified output will be
0
N/2
N/2
N

⇒ Tropospheric scatter is used with frequencies in the range of
VLF
HF
UHF
VHF

⇒ Out of latch and flip flop, which has clock input?
Latch only
Flip flop only
Both latch and flip flop
None

⇒ For the two port of figure, z_{2226/7 Ω
6/7 Ω
2/3 Ω
1 Ω}

⇒ Two independence parameters Z₁₁ and Z₁₂ of the two-port network in the figure
Z₁₁ = 2.75 Ω and Z₁₂ = 0.25 Ω
Z₁₁ = 3 Ω and Z₁₂ = 0.5 Ω
Z₁₁ = 3 Ω and Z₁₂ = 0.25 Ω
Z₁₁ = 2.25 Ω and Z₁₂ = 0.5 Ω

⇒ The circuit shown in figure
oscillate at 456 kHz
oscillate at 228 kHz
oscillate at microwave frequency
not oscillate

⇒ Time delay produced by an instruction code given below using 2 MHz clock
1783 μs
1787 μs
1781 μs
1797 μs

⇒ Which of the following oscillator is generally not used at VHF?
Colpitts oscillator
Clapp oscillator
Armstrong oscillator
Ultra Audio oscillator

⇒

Assertion (A): Inverters and choppers use fast switching thyristors

Reason (R): Fast switching SCR has low turn off time.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ BCD equivalent of - 8₁₀ is
110
10110
11000
1000

⇒ Which of the following is a valid logical expression in Pascal?
2.5 : = A
(A + B) < < (C + D)
A = < B
A > = B

⇒ Which of the following is not a semiconductor?
Silicon
Calcium arsenide
Germanium
Zinc sulphide

⇒ An antenna has a gain of 44 dB. Assuming that the main beam of the antenna is circular in cross-section the beamwidth will be
0.4456°
1.4456°
2.4456°
3.4456°

⇒ The useful magnetic flux obtainable from any closed surface is
unity
constant
both (a) and (b)
none of the above

⇒ In a common emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche Beakdown of Base-Emitter junction
collector emitter breakdown voltage with base open(βV_CEO)
collector emitter breakdown voltage with emitter open(βV_CEO)
zener break down voltage of the emitter base junction

⇒ The current i(t), though a 10 Ω resistor in series with an inductance, is given by i(t) = 3 + 4 sin (10t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W, respectively
35 A, 350 W, respectively
5 A, 250 W, respectively
11 A, 1210 W, respectively

⇒ The internal impedance of a source is 3 + j 7 Ω. For maximum power transfer, load impedance should be
3 + j 7 Ω
3 - j 7 Ω
7 + j 3 Ω
7 - j 3 Ω

⇒ N-type silicon is obtained by doping silicon with
germanium
aluminium
boron
phosphorus

⇒ The number of possible colours with a 4 line digital input monitor are
4
16
64
2

⇒ In an home T.V. receiver, the leed in from the antenna is
coaxial cable of 75 Ω
ordinary twisted wire
bar copper wire
twin wire

⇒ The circuit shown in figure will ac
differentiator
adder
clipper
clamper

⇒ In RLC circuits the state variables generally selected are
voltages across capacitors
currents through resistances and voltages across capacitors
currents through resistances and capacitances
currents through inductances and voltages across capacitances

⇒ A wire strain gauge has a gauge factor of 2, resistance of 125 Ω and length 1 m. If length of wire changes by .005 m, change in resistance will be
0.25 Ω
0.5 Ω
1.25 Ω
2.5 Ω

⇒ A band elimination constant k filter has series resonant circuit in series arms.
TRUE
FALSE

⇒ Which of the following amplifiers has a voltage gain of less than 1?
CE
CC
CB
CE or CB