Question is ⇒ Positive feedback is mainly used in, Options are ⇒ (A) oscillators, (B) thyristors, (C) voltage regulators, (D) both (a) and (b), (E) , Leave your comments or Download question paper.

Question is ⇒ Positive feedback is mainly used in, Options are ⇒ (A) oscillators, (B) thyristors, (C) voltage regulators, (D) both (a) and (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Positive feedback is mainly used in
A.	oscillators [Wrong Answer]
B.	thyristors [Wrong Answer]
C.	voltage regulators [Wrong Answer]
D.	both (a) and (b) [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If ω₀ is the angular frequency of rotation of electron in the absence of magnetic field, the angular frequency ω, when a magnetic field B is acting is ω ≅ ω₀ + (e/2m)B.
TRUE
FALSE

⇒ What do the contents of instruction register specify?
Operand for the instruction being executed
Op code for the instruction being executed
Op code for the instruction to be executed next
Operand for the instruction to be executed next

⇒

Assertion (A): A dc stabilizer has constant output voltage irrespective of variations in input voltage and load current

Reason (R): A dc series regulator uses a zener diode across the load to stabilize the output voltage.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A cycloconverter for single phase operation has
one positive group and one negative group converters
two positive group and two negative group converters
three positive group and three negative group converters
any of the above

⇒ The gain of a current element is
0 dB
1.67 dB
1.76 dB
3 dB

⇒ The time constant of the circuit in figur
RC
2 RC
3 RC
5 RC

⇒ Subroutines are used in larger programs not
to increase the programming case
to reduce storage equipment
to reduce program extension time
for ease of program testing at the program development time

⇒ An I/O processor control the flow of information between
cache memory and I/O devices
main memory and I/O devices
1 Two I/O devices
cache and main memories

⇒ In a single stage differential amplifier, the output offset voltage is mainly dependent on the mismatch of
V_BE, I_B and β
V_BE and I_B
I_B and β
V_BE and β

⇒ A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is
20 k ohm
80 k ohm
320 k ohm
640 k ohm

⇒ For the signal flow graph of the given figure consider the following statements

It has three forward paths
It has three individual loops
It has two non touching loops

Out of above the correct statements
1, 2, 3
1, 2
2, 3
1, 3

⇒ In which frequency range is the noise figure in a transistor independent of frequency
intermediate frequencies
high frequency
low frequencies
both low and high frequencies

⇒

Assertion (A): An unbiased p-n junction develops a built-in potential at the junction with the n-side positive and the p-side negative.

Reason (R): The p-n junction behaves as a battery and supplies current to a resistance connected across its terminals.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The resistance of a 230 V, 100 W lamp is
529 Ω
2300 Ω
5290 Ω
23 Ω

⇒ Surface impedance at high frequencies is a consideration for
good conductors
semiconductors
dielectrics
ferrites

⇒ In a two tone AM system the two modulating frequencies are 2000 p and 4000 p rad/sec. If carrier frequency is 2p x 10⁶ rad/sec the frequencies of upper sidebands are
1.002 MHz and 1.004 MHz
1.001 MHz and 1.002 MHz
1.001 MHz and 1.004 MHz
1.002 MHz and 1.008 MHz

⇒ Which of the following characters is allowed in variable names in C?
comma
dot
blank
underscore

⇒ Panel instruments are generally mounted vertically.
TRUE
FALSE

⇒

Assertion (A): The wave shown in the given figure does not contain the dc component and even harmo
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The main drawback in the performance of shunt peaked wide band amplifier is
two low gain at low frequency
poor phase response
reduce frequency at middle frequency
that the maximum gain of the stage is small

⇒ Unit doublet is the Laplace inverse of __________ .
1/s
s²
s
none of these

⇒

Assertion (A): A p-n junction has high resistance in reverse direction.

Reason (R): When a reverse bias is applied to p-n junction, the width of depletion layer increases.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ To obtain very high input and O/P impedance in a feedback amplifier, the type of feedback utilized
voltage series
current series
voltage shunt
current shunt

⇒

Assertion (A): The h-parameter model of a BJT can be derived from its hybrid-p model and vice-versa.

Reason (R): The hybrid-p model has many more additional elements as compared to h-parameter model of the BJT.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The switching expression corresponding
C D + B C
C ⊙ D
C ⊕ D
CD

⇒ A geosynchronous satellite
has the same period a that of the Earth
has a circular orbit
rotates in the equatorial plane
has all of the above

⇒ An RLC series circuit has a variable inductance. The value of L for resonance conditions at fundamental frequency is 0.18 H. For resonance conditions at third harmonic frequency the value of inductance is
0.54 H
0.06 H
0.02 H
1.62 H

⇒ The Boolean function/implemented in the figure using two I/P multiplexer
ABC + ABC
ABC + AB C
ABC + ABC
ABC + AB C

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ Digital television is also called
High digital television
High definition television
High deflection television
High display television