Question is ⇒ If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is, Options are ⇒ (A) 23 dB, (B) 25 dB, (C) 46 dB, (D) 50 dB, (E) , Leave your comments or Download question paper.

Question is ⇒ If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is, Options are ⇒ (A) 23 dB, (B) 25 dB, (C) 46 dB, (D) 50 dB, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is
A.	23 dB [Wrong Answer]
B.	25 dB [Wrong Answer]
C.	46 dB [Correct Answer]
D.	50 dB [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The reason for glitches on the outputs of decoding gates on a synchronous counter is
FFs changing states together
FFs changing states one at a time
AND gates not functioning properly
none of the above

⇒ Which coupling produces the minimum interference with frequency response?
RC coupling
Transformer coupling
Direct coupling
Impedance coupling

⇒ In TV system in India, each frame is divided into
625 horizontal lines
525 horizontal lines
425 horizontal lines
325 horizontal lines

⇒ The speed transducer using a drag cup rotor has the main advantage of
very high accuracy
low energy requirement
cheap construction
all of the above

⇒ If 4 in binary system is 100 then 8 will be
10
100
111
1000

⇒ Two voltages are -5 V and -10 V. In positive logic
-5 V is 1 and -10 V is 0
-10 V is 1 and -5 V is 0
-5 V is 1 in some circuits and 0 in others
-10 V is 1 in some circuits and 0 in others

⇒ What does the B register contain after the first MOV B, A has been executed?
40 H
60 H
80 H
80 D

⇒

Match the following:

	List I		List II
A.	Total instantaneous value of emitter current	1.	I_E
B.	Quiescent value of emitter current	2.	i_E
C.	Instantaneous value of as component of emitter current	3.	I_e
D.	RMS value of ac component of emitter current	4.	i_e

A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3
A-2, B-1, C-3, D-4
A-2, B-3, C-4, D-1

⇒

Assertion (A): In simplifying block diagram the product of transfer functions in feed forward direction must remain the same.

Reason (R): In simplifying block diagram the product of transfer functions around a closed loop must remain the same.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Match the following:

	List I		List II
A.	Ring modulator	1.	Clock recovery
B.	VCO	2.	Demodulation of FM
C.	Foster Seeley discriminator	3.	Frequency conversion
D.	Mixer	4.	Summing of two points
		5.	Generation of FM
		6.	Generation of DSB-SC

A-1, B-3, C-2, D-4
A-6, B-5, C-2, D-3
A-6, B-1, C-3, D-2
A-5, B-6, C-1, D-3

⇒ The speeds used in recording audio programs in house hold recorders are
38 cm/s and 9.5 cm/s
38 cm/s and 19 cm/s
9.5 cm/s and 4.75 cm/s
38 cm/s and 4.75 cm/s

⇒

Assertion (A): The propagation delay in ECL is minimum

Reason (R): Transistors used in ECL switch between active and cutoff regions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If B is the bandwidth, the thermal noise voltage is proportional to
B
B^0.5
B^1.5
B²

⇒ Consider the following differences between QPSK and MSK

The side lobes in MSK are relatively much smaller in comparison to the main lobe
The spectrum of MSK has a main centre lobe which is 1.5 times as wide as the main lobe of QPSK
The waveforms of both MSK and QPSK exhibit phase continuity

Which of the above statements are correct?
1 only
1 and 2 only
1, 2 and 3
2 and 3 only

⇒ The main use of JFET with a
frequency mixer
source follower
voltage doubler
trigger

⇒ If the valence electron is separated from a copper atom, the remaining part of atom has a net charge of
1
-1
0
3

⇒ Strength of space wave is not dependent on distance.
TRUE
FALSE

⇒ The binary equivalent of 4096.90625 is
1000000000000.11
10000000000001.1
1000000000001.1
1000000000000.1

⇒ Which amplifier has the higher power gain?
Common emitter
Common collector
Common base
Both CC and CE

⇒ It is difficult to write a program in a machine language.
TRUE
FALSE

⇒ The number of possible colours with a 4 line digital input monitor are
4
16
64
2

⇒ Am equivalent 2's complement representation of the 2's complement number 1101 is
110100
1101
110111
111101

⇒ Circuit switching, Message switching and Packet Switching Network belong to which of the following systems?
Computer communication system
Electromechanical communication system
PBX system
EPBX system

⇒ If sound intensity is 8 W/m², the dB level of this sound is about
5 dB
50 dB
129 dB
1290 dB

⇒

Assertion (A): A GTO circuit is more compact than SCR circuit

Reason (R): A GTO can be turned off by negative gate pulse.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The device most likely to be found in an SSB transmitter is
class C audio amplifier
tuned modulator
class B RF amplifier
class A RF amplifier

⇒ Gain of an antenna with a circular aperture of diameter 4 meter at frequency of 10 GHz, with directivity 60
60
100
30
90

⇒ In a differential amplifier, CMRR can be improved by using an increased
emitter resistance
collector resistance
power supply voltages
source resistance

⇒ An enhancement mode MOSFET is on when the gate voltage is
zero
positive
high
more threshold value

⇒ From the noise point of view, bandwidth should
be large
not be too large
should be as large as possible
should be infinite