Question is ⇒ Which inductor is linear?, Options are ⇒ (A) Air cored, (B) Cast iron cored, (C) Sheet steel cored, (D) Iron alloy cored, (E) , Leave your comments or Download question paper.

Question is ⇒ Which inductor is linear?, Options are ⇒ (A) Air cored, (B) Cast iron cored, (C) Sheet steel cored, (D) Iron alloy cored, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which inductor is linear?
A.	Air cored [Correct Answer]
B.	Cast iron cored [Wrong Answer]
C.	Sheet steel cored [Wrong Answer]
D.	Iron alloy cored [Wrong Answer]
View Answer 3 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following BJT circ
2.46 kΩ
2.88 kΩ
200 Ω
18.48 Ω

⇒ The Ni-Zn ferrites are used for audio and TV transformers is that
they have large saturation magnetisation
they are easy to fabricate by rolling
they are free from pores and voids
they have high electro-resistivity

⇒ In a CRO which of the following is not a part of electron gun
cathode
grid
accelerating anode
X - Y plates

⇒ The no. of FF required and the maximum decimal no. of a MOD-12 counter is
12, 12
4, 11
3, 6
4, 10

⇒ The efficiency of a chopper circuit is about
80% or more
around 50%
around 20%
around 5%

⇒ For the design of a sequential circuit having 9 states, minimum number of memory elements required is
3
4
5
9

⇒ In a purely inductive ac circuit, the supply voltage and voltage induced across inductance are equal and opposite at all instants.
TRUE
FALSE

⇒ In Schering bridge, the potential of detector above earth potential is about
a few volts
10 kV
1000 V
either (a) or (b)

⇒ A Schottky diode has
no minority carriers and very low voltage drop in forward direction
no minority carriers and very high voltage drop in forward direction
large number of minority carriers and very high voltage drop in forward direction
large number of minority carriers and very low voltage drop in forward direction

⇒ In a JFET, gates are always
forward biased
reverse biased
either forward or reverse biased
unbiased

⇒ In the following figure C = 0.02 μF, and V_th is known to be of frequency ω = 10⁷ rad/sec and r_d = 2.5 Ω and Z_Th = R_Th = 10 Ω Then phase angle between i_d and V_{d26.5°
25°
30°
0°}

⇒ Frequency range for satellite communication is
1 kHz to 100 kHz
100 kHz to 10 MHz
10 MHz to 100 MHz
1 GHz to 30 GHz

⇒ A capacitor with initial charge q₀ at t = 0⁺ acts as
current source
voltage source
short-circuit
open-circuit

⇒ Given figure shows a unity feedback system. The ratio of time constants for open loop and closed loop response
0.0423611111111111
0.0840277777777778
0.126388888888889
0.0854166666666667

⇒ Photoelectric emitters in photo tubes are generally made of
alkali metals
metals
semiconductors
metal and semiconductors

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
-0.6
-1
0.6
0

⇒ The coding system generally used in digital telemetry is
PPM (Pulse position modulation)
PAM (Pulse amplitude modulation)
PCM (Pulse code modulation)
PDM (Pulse duration modulation)

⇒ While calculating Norton's resistance, all current sources are short circuited.
TRUE
FALSE

⇒ A limiter circuit can be built using a diode and resistance.
TRUE
FALSE

⇒ Which statement is incorrect for the signal x(t) = 5 sin (2p x 10³t) sin (2p x 10⁶t)?
Upper side band frequency is 1001000
Carrier amplitude is 5
Lower sideband frequency is 990000
x(t) is DSB-SC

⇒ A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with e_r = 15. The reflection coefficient for normal incidence is
0.6 ∠0°
1 ∠0°
0.6 ∠180°
1.2 ∠180°

⇒ An amplifier has to amplify pulses of 1 H-s duration. The minimum bandwidth of amplifier must be
10 kHz
10 MHz
1 kHz
1 MHz

⇒ An oscilloscope has an input impedance consisting of 1 MΩ and 20 pF is parallel. A high impedance probe connected to input of this oscilloscope has a 10 MΩ series resistance. This 10 MΩ series resistance
may not be shunted
should be shunted by 2 pF capacitor
should be shunted by 20 pF capacitor
should be shunted by 200 pF capacitor

⇒ The input to ALU are the contents of accumulator and temporary register.
TRUE
FALSE

⇒ Light dependent resistors are
highly doped semiconductor
intrinsic semiconductor
lightly doped semiconductor
either (a) or (c)

⇒ The circuit show
voltage series feedback amplifier
transconductance amplifier
transresistance amplifier with open circuit mutual resistance R_F
transresistance amplifier with short circuit mutual resistance R_F

⇒ The gain of an FET amplifier can be changed by changing
r_m
g_m
R_d
none of the above

⇒ Semi conducting materials are all
elements
compounds
elements or compounds
elements or mixtures

⇒ At a temperature of 7 K, lead is a superconductor.
TRUE
FALSE

⇒ Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 10¹² cm^-3. Density of electrons = 8 x 10¹³ cm^-3, mobility of conduction electron = 2.3 x 10⁴ cm²/ V-sec and mobility of holes = 100 cm²/V-sec.
0.43 Ω-m
0.34 Ω-m
0.42 Ω-m
0.24 Ω-m