Question is ⇒ The minterm designation for ABCD is, Options are ⇒ (A) m8, (B) m10, (C) m14, (D) m15, (E) , Leave your comments or Download question paper.

Question is ⇒ The minterm designation for ABCD is, Options are ⇒ (A) m8, (B) m10, (C) m14, (D) m15, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The minterm designation for ABCD is
A.	m₈ [Wrong Answer]
B.	m₁₀ [Wrong Answer]
C.	m₁₄ [Wrong Answer]
D.	m₁₅ [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The IF stage of a receiver employs
capacitive coupling
impedance coupling
double-tuned transformer coupling
single-tuned transformer coupling

⇒ For the K map in the given figure, the simplified expressio
x_l x₂ x₄ + x₂ x₄ + x₁ x₃
x₂ x₄ + x₂ x₄ + x₁ x₃
x₁ x₂ x₄ + x_l x₂ + x₃ x₄ + x₂x₄
x₁ x₂ + x₂ x₃ + x₃x₄

⇒ Consider the real expression in Pascal language XZ and MP + K
XZ + Y and MP + K
(MP + K + X) / Y
Y / (MP + K)

⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111

⇒ The radiation resistance of a doublet antenna of length dl is proportional to
δ l
(δ l)²
(δ l)³
(δ l)⁰⁵

⇒ In figure, the value of R shoul
12 Ω
6 Ω
3 Ω
1.5 Ω

⇒ In TE and TM modes of rectangular waveguides having propagation in z direction
E_z and H_z are both zero
In TE mode E_z is zero and in TM mode H_z is zero
In TE mode H_z is zero and in TM mode E_z is zero
In both TE and TM modes both E_z and H_z are non-zero

⇒

Assertion (A): In an intrinsic semiconductor J = (μ_n x μ_p)en_i.

Reason (R): Intrinsic charge concentration n_i at temperature T is given by n_i² = A₀ T³ e^-E_G0/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following does not apply to Yagi-Uda antenna
High gain
Reasonably good bandwidth
Folded dipole
Parasitic elements

⇒ In every practical oscillator, the loop gain is slightly larger than unity and the amplitude of the oscillations is limited by the
magnitude of the loop gain
onset if non-linearity
magnitude of gain of the amplifier
feedback transmission factor

⇒ In VCR, the chrominance signal's frequency is
up converted during recording and down converted during playback
down converted during recording and up converted during playback
not changed during recording and playback
any of the above depending on VCR system

⇒ The impedance of an RC series circuit is 12 Ω at f= 50 Hz. At f= 200 Hz, the impedance will be
more than 12
less than 3
more than 3 Ω but less than 12 Ω
more than 12 Ω but less than 24 Ω

⇒ In the synthesis of RLC network
the number of elements in Bott-Duffin synthesis and Brune's synthesis are always equal
the number of elements in Bott-Duffin synthesis is more than that in Brune's synthesis
the number of elements in Bott-Duffin synthesis is less than that in Brune's synthesis
the number of elements in Bott-Duffin synthesis may be more or less than that in Brune's synthesis

⇒ Short-circuited stubs are used, because open-circuited stubs are
liable to radiate
complex in nature
providing open-circuit environments
unable to provide work over large frequency range

⇒ The resistance of human body is about
5000 Ω
2000 Ω
1000 Ω
200 Ω

⇒ A string constant in basic is
a string of capital alphabets A to Z, included in question mark
a string of capital alphabets A to Z and digits 0 to 9 included in question mark
a string of capital alphabets A to Z, digits 0 to 9 and special characters
a string of capital alphabets A to Z, digits 0 to 9 and special characters included in question mark

⇒ In which mode of BJT operation are both junctions reverse biased?
Active
Saturation
Cut off
Reverse active

⇒ The communication satellite INSAT-IB had to take up the job of INSAT-IA because the latter collapsed within __________ months of its launch.
12
20
5
36

⇒ A non-linear element has zero resistance.
TRUE
FALSE

⇒ Which binary addition is incorrect?
1001.1 + 1011.01 = 10100.11
100010 + 1000101 = 1001010
0.0011 + 0.1110 = 1.1
1011.01 + 1001.11 = 10111

⇒ A Maxwell's bridge has the unknown inductance in one arm and resistance in the other three arms.
TRUE
FALSE

⇒ Two identical FETs each having parameters g_m and r_d are connected is parallel. The composite FET has parameters
0.5 g_m and 2 r_d
0.5 g_m and 0.5 r_d
2 g_m and 2 r_d
2 g_m and 0.5 r_d

⇒ Consider the following statements

In 8085 address and data buses are multiplexed.
In Z 80 address and data buses are multiplexed
In Z 80 address and data buses are not multiplexed.
Z 80 has 16 bit address bus and 8 bit data bus.

Which of the above statements are correct?
1 and 2 only
1, 3 and 4 only
1, 2 and 4 only
2 and 4 only

⇒ In what condition does BJT act like an open switch
cut off
saturation
active
both (b) and (c)

⇒ An AND gate has four inputs. One of the inputs is low and other inputs are high. The output
is low
is high
is alternately low and high
may be high or low depending on relative magnitudes of inputs

⇒ The Table given below is the mark obtained by 2 students in 8 different subjec
-0.4748
0.4748
-0.0338
0.0338

⇒ To neglect a current source the terminals across the source are
replaced by some resistance
replaced by capacitance
open-circuited
short-circuited

⇒ The Nyquist plo
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the second quadrant
will start from (ω = ∞) in the fourth quadrant and will terminate (ω = 0) in the second quadrant
will start form (ω = ∞) in the second quadrant and will terminate (ω = 0) in the fourth quadrant
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the fourth quadrant

⇒ The number of storage classes in C is
2
3
4
6

⇒ In a digital measuring device the input electrical signal is in the frequency range of dc to ac (50) Hz. It must be sampled at a rate of
f times/sec
0.5 f times/sec
0.25 f times/sec
2 f times/sec