Question is ⇒ The antenna current of an AM transmitter is 8 A, when only the carrier is sent, but it increases to 8.93 A when the carrier is modulated by a single sine wave. Determine the antenna current when the percent of modulation changes to 0.8, Options are ⇒ (A) 9.19 A, (B) 9.91 A, (C) 10.56 A, (D) 8.61 A, (E) , Leave your comments or Download question paper.

Question is ⇒ The antenna current of an AM transmitter is 8 A, when only the carrier is sent, but it increases to 8.93 A when the carrier is modulated by a single sine wave. Determine the antenna current when the percent of modulation changes to 0.8, Options are ⇒ (A) 9.19 A, (B) 9.91 A, (C) 10.56 A, (D) 8.61 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The antenna current of an AM transmitter is 8 A, when only the carrier is sent, but it increases to 8.93 A when the carrier is modulated by a single sine wave. Determine the antenna current when the percent of modulation changes to 0.8
A.	9.19 A [Correct Answer]
B.	9.91 A [Wrong Answer]
C.	10.56 A [Wrong Answer]
D.	8.61 A [Wrong Answer]
View Answer 2 -11 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The polarization phenomena in Faraday rotation
is non-reciprocal
exists along perpendicular direction
exists along the axis of array
does not exist

⇒ The use of a capacitor filter in a rectifier circuit gives satisfactory performance only when the load
current is high
current is low
voltage is high
voltage is low

⇒

Assertion (A): Electromagnetic waves in free space spread uniformly in all directions from a point source

Reason (R): Free space has no interference or obstacles.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): If source and destination addresses are made implicit the length of instruction is reduced.

Reason (R): 8085 has only 3 addressing modes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The amount of dielectric heating is inversely proportional to frequency.
TRUE
FALSE

⇒ The dc voltage on plate modulated class C amplifier is 8 kV. If the peak modulating voltage is 4 kV, the peak RF voltage delivered to load is
32 kV
12 kV
0.5 kV
24 kV

⇒ For a superconductor, the relative permeability is
zero
high
low
either low or high

⇒ Which one is correct option about ROC?
ROC does not contain any pole
ROC of finite duration sequence is entire plane expect z = 0, z = ∞
a and b
only a

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒ An AM wave is given by s(t)_AM = 20 (1 + 0.5 cos 10³t + 0.3 cos 10⁴ t cos 10⁶ t) the modulation index of the envelope is
0.5
0.58
0.3
0.8

⇒ Consider the following statements about 'Functions' in C

A function can be called any number of times.
A function gets called when the function name is followed by a semicolon.
The order in which functions are defined in a program and the order in which they are called must be the same.

Which of the above statements are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Logic analyser is
a multichannel oscilloscope
similar to logic pulser
similar to current tracer
none of the above

⇒ When a material is in superconducting state and a magnetic field is applied
the superconducting property is not affected
the superconducting property may be affected and resistivity may increase from zero to a low value
the superconducting property may be destroyed
the material may become an insulator

⇒ If the Nyquist plot does not encircle the (-1 + j0) point the system is always stable.
TRUE
FALSE

⇒ A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR
is forward biased
is reverse biased
may be forward biased or reverse biased
forward biased initially but reverse biased afterwards

⇒ Noise generated in a resistor is also known as
partition noise
white noise
thermal noise
shot noise

⇒

Match the following:

	List I (Memories)		List II (Characteristic)
A.	Static PLA	1.	erasable, programmable
B.	CCD	2.	ultra high speed
C.	ECL	3.	stores large volume of data
D.	GAL	4.	Does not need refreshing
		5.	Non-volatile

A-4, B-3, C-2, D-1
A-4, B-2, C-3, D-1
A-5, B-1, C-2, D-3
A-3, B-5, C-2, D-1

⇒ In a single phase full wave ac regulator, the firing angles in the two half cycles
are always equal
are sometimes equal
are never equal
may be equal or unequal

⇒ For measuring current at a high frequency we should use
moving iron instrument
electrostatic instrument
thermocouple instrument
moving coil instrument

⇒ Which op-amp circuit uses a diode as one of the circuit components?
Integrating amplifier
Differentiating amplifier
Logarithmic amplifier
Summing amplifier

⇒ In 8085 stack pointer is
4 bit register
8 bit register
16 bit register
32 bit register

⇒ Two identical hybrid tees are joined as shown in the given figure. If 16 mW power is fed into port 1, the power output at ports 2 , 3, 1', 2', 3' respectivel
8, 4, 2, 2, 0 mW
0, 8, 4, 4, 0 mW
0, 8, 2, 2, mW
8, 2, 4, 2, 0 mW

⇒ The number of inputs and outputs in a full adder are
2 and 1
2 and 2
3 and 3
3 and 2

⇒ When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common base short circuit current gain a for the transistor is
0.99
1.01
1.001
0.99

⇒

Assertion (A): In AM the amplitude of carrier is made proportional to the instantaneous amplitude of modulating wave

Reason (R): In AM, frequency of side band = frequency carrier ± frequency of modulating wave.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Top loading in an antenna increases
effective height
beam width
input capacitance
bandwidth

⇒ The no. of FF required and the maximum decimal no. of a MOD-12 counter is
12, 12
4, 11
3, 6
4, 10

⇒ A BJT amplifier has a power gain of 0.5 from source to base. The power gain in dB is
-0.3 dB
-3 dB
-6 dB
-10 dB

⇒ Super high frequency means more than 3000 MHz.
TRUE
FALSE

⇒ Why does a FM radio station perform better than and AM station radiating the same actual power?
FM is immune to noise
AM has only two sidebands while FM has more
FM uses larger bandwidth for large modulation depth.
Capture effects appears in FM.