Question is ⇒ Which of the following amplifiers has highest output impedance?, Options are ⇒ (A) CE, (B) CB, (C) CC, (D) Push pull, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following amplifiers has highest output impedance?, Options are ⇒ (A) CE, (B) CB, (C) CC, (D) Push pull, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following amplifiers has highest output impedance?
A.	CE [Wrong Answer]
B.	CB [Correct Answer]
C.	CC [Wrong Answer]
D.	Push pull [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If 8085 is required to add two 32 bit numbers, the numbers of addition sequences is
1
2
4
8

⇒ When two coupled coils of equal self inductance are cormected in series in one way the net inductance is 12 mH and when they are connected in the other way the net inductance is 4 mH. The maximum value of inductance when they are connected in parallel is
2 mH
3 mH
4 mH
6 mH

⇒ Which among the following waveforms can be reconstructed from its samples without distort
1 and 2
2 and 3
1 and 3
Only 2

⇒ If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be
a voltage source
a current source
both of the above
none of the above

⇒ Figure repres
Integrator
Differentiator
High Pass Filter
Band Pass Filter

⇒ In a mod-12 counter the input clock frequency is 10 kHz. The output frequency is
0.833 kHz
1.0 kHz
0.91 kHz
0.77 kHz

⇒ When the core of a saturable reactor is saturated, the inductance is high.
TRUE
FALSE

⇒ A device with input x(t) and y(t) is characterized by y(t) = x²(t). An FM signal with frequency deviation of 90 kHz and modulating signal bandwidth of 5 kHz is applied to this device. The bandwidth of the output signal is
370 kHz
190 kHz
380 kHz
95 kHz

⇒ In a synchro transmitter-control transformer, the voltage induced in rotor winding of control transformer is zero when the angular displacement between rotors of transmitter and transformer is
0°
90°
180°
either (a) or (c)

⇒ For dielectrics in alternating field, polarizability a_e is a complex quantity. The imaginary part of a_e is zero for
ω = 0
ω → ∞
ω = 0 and ω → ∞
ω = natural frequency ω₀

⇒ A clock signal driving a 6-bit ring counter has a frequency of 1 MHz. How long is each timing bit high?
1 ms
2 ms
3 ms
6 ms

⇒

Match the following:

	List I (Devices)		List II (characteristic)
A.	BJT	1.	Voltage controlled negative resistance
B.	MOSFET	2.	High current gain
C.	Tunnel diode	3.	Voltage regulation
D.	Zener diode	4.	High input impedance

A-1, B-4, C-2, D-3
A-2, B-4, C-1, D-3
A-2, B-3, C-1, D-4
A-1, B-3, C-2, D-4

⇒ A P-channel MOSFET operating in the enhancement mode is characterized by V_t = - 4 V and I_DQ = - 10 mA, when V_GSQ = - 5.5 V, what will be V_GSQ if I_DQ = -15 mA and I_{D, on} = - 16 mA
- 2 V
3 V
0.13 V
1.3 V

⇒

Assertion (A): Operator has a value 1 ∠ - 90° or 1 ∠ 90°.

Reason (R): Operator 'a' has a value 1 ∠ 120°.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If the midband gain of an amplifier is 40 dB, the gain at half power frequency is
37 dB
30 dB
20 dB
13 dB

⇒ Choose the function f(t), - ∞ < t < + ∞, for which a Fourier series cannot be defined
3 sin (25t)
4 cos (20t + 3) + 2 sin (10t)
exp - | t | sin 25 t
1

⇒ The power requirement of a RADAR used in military operations is
a few watts
about 500 W
about 2000 W
a few megawatts

⇒ An AND gate has two inputs A and B and one inhibit input 3, Output is 1 if
A = 1, B = 1, S = 1
A = 1, B = 1, S = 0
A = 1, B = 0, S = 1
A = 1, B = 0, S = 0

⇒ RECTIFIER : OSCILLATOR ::
Capacitance : Inductance
Series resonance : Parallel resonance
DC : AC
Regulation : Efficiency

⇒ An ac circuit has two branches in parallel. The impedances of the two branches are equal. Their power factors are 0.8 lagging and 0.8 leading. The overall p.f. is
1
zero
about 0.7 lagging
about 0.7 leading

⇒ In 8085 microprocessor, the interrupt enable flip-flop is reset by
DI instruction only
system RESET only
interrupt acknowledgment only
all of the above

⇒ Poynting vector signifies which of the following?
Power density vector producing electrostatic field
Power density vector producing electromagnetic field
Current density vector producing electrostatic field
Current density vector producing electromagnetic field

⇒ Binary number 11001 is equivalent to decimal number
35
15
105
25

⇒ The rate of change of excess carrier density is proportional to carrier density.
TRUE
FALSE

⇒ KCL is a statement of principle of conservation of energy.
TRUE
FALSE

⇒ The write cycle time of memory is 200 nsec. The maximum rate of data which can be stored is
200 words/sec
5 x 10³ words/sec
5 x 10⁶ word/sec
5 x 10⁹ words/sec

⇒ JFET is also known as
linear device
square law device
inverse law device
logarithmic law device

⇒ The multiplier resistance and meter coil in a voltmeter are in
series
parallel
series-parallel
either (a) or (b)

⇒ Figure shows an RC circuit. The magnitude plot V₂/V_{1will rise exponentially to R₂/(R₁ + R₂) as ω → ∞
will rise linearly to R₂/(R₁ + R₂) as ω → ∞
will decrease to zero as ω → ∞
will rise 1 at ω = 0 and then decrease as ω → ∞}

⇒ The decimal equivalent of ABC₁₆ is
348
2583
2748
33