Question is ⇒ The received signal frequency at any time of a super-heterodyne receiver having IF = 456 kHz is 1 MHz. The corresponding image signal is, Options are ⇒ (A) within the medium band, (B) outside the medium band, (C) depend upon modulation index, (D) depends on Modulating frequency, (E) , Leave your comments or Download question paper.

Question is ⇒ The received signal frequency at any time of a super-heterodyne receiver having IF = 456 kHz is 1 MHz. The corresponding image signal is, Options are ⇒ (A) within the medium band, (B) outside the medium band, (C) depend upon modulation index, (D) depends on Modulating frequency, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The received signal frequency at any time of a super-heterodyne receiver having IF = 456 kHz is 1 MHz. The corresponding image signal is
A.	within the medium band [Correct Answer]
B.	outside the medium band [Wrong Answer]
C.	depend upon modulation index [Wrong Answer]
D.	depends on Modulating frequency [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The basic storage element in a digital system is
flip flop
counter
multiplexer
encoder

⇒ Each of the following statements regarding frequency modulation is true except
amplitude of the modulated wave remains the same as that of carrier wave
the amount of variation of deviation from the original carrier frequency is determined by the frequency of the modulating signal
the rate at which the frequency of modulated wave varies is determined by the frequency of the modulating signal
frequency of modulated wave increases as the signal voltage increases and vice-versa

⇒ A frequency multiplier stage should operate as
class A
class B
class AB
class C

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ Audio systems use transverse recording.
TRUE
FALSE

⇒ In a uniform plane wave E and H are related by
E/H = 1
E/H = ε/μ
E/H = μ/ε
none of the above

⇒ Which of the following is used as detector in audio frequency ac bridges?
AC voltmeter
CRO
Head phones
Vibration galvanometer

⇒ The dc output voltage from a power supply
increases with higher values of filter capacitance and decreases with more load current
decreases with higher values of filter capacitance and increases with more load current
decreases with higher values of filter capacitance as well as with more load current
increases with higher values of filter capacitance as well as with more load current

⇒ If RADIUS = 3.0 the result of the following FORTRAN 77 program will be 1.5708
1
28.2744
18

⇒ Higher value of ripple factor indicates
poor rectification
ideal rectification
r.m.s. value to peak value
none of the above

⇒ The multiplier resistance and meter coil in a voltmeter are in
series
parallel
series-parallel
either (a) or (b)

⇒ As per Boolean algebra, inputs can be interchanged in
OR gates
AND gates
both OR and AND gates
none of the above

⇒ A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
230 V
0.5 x 230 V
2 x 230V
230/2V

⇒ Commercial Frequency deviation of FM is
70 kHz
75 kHz
80 kHz
65 kHz

⇒ In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be
0.05 MHz
1 MHz
2 MHz
4 MHz

⇒ When avalanche breakdown occurs covalent bonds are not affected.
TRUE
FALSE

⇒ In figure The minimum and maximum load currents
0 and 60 mA
0 and 120 mA
10 mA and 60 mA
10 mA and 120 mA

⇒ For an ideal 3000 Hz channel, Nyquist rate is
3000 bps
6000 bps
9000 bps
12000 bps

⇒ Which of the following directives in 8085 causes one byte to be reserved in the memory?
D S
D B
D W
E Q U

⇒ The number of pins in microprocessor 8086 is
30
40
50
60

⇒ Orbital disturbances of a geosynchronous satellite are caused by the
moon
sun
earth
all of the above

⇒ A parallel ac circuit in resonance will
act like a resistor of low value
have a high impedance
have current in each section equal to the line current
have a high voltage developed across each inductive and capacitive section

⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value

⇒ If an additional two diodes were used to connect the 1 kW load across a bridge rectifier circuits, utilizing the full secondary of the transformer, how much d.c. power could be delivered using a transformer with the rating of 105 VA?
35 W
60 W
85 W
100 W

⇒ Out of latch and flip flop, which has clock input?
Latch only
Flip flop only
Both latch and flip flop
None

⇒ A single element strain gauge bridge has two fixed resistances R₁ and R₁ of 120 Ω each and a variable resistance which gives full deflection at 120 Ω for zero strain and 120.6 Ω for straine e. If gauge factor is 2, strain e is
0.0025
0.0035
0.005
0.0075

⇒ If a fuse is higher than required current rating is employed in a circuit, it will
blow more frequently since it carries more current
afford better protection to the circuit
seriously overload the circuit
lead to larger maintenance cost

⇒ A 1 ms pulse can be stretched to 1 sec pulse by using
an astable multivibrator
a monostable multivibrator
a bistable multivibrator
a Schmitt trigger circuit

⇒ In a circuit of figure, V_s = 10 cos(ωt) power drawn by the 2Ω resistor is 4 watts. The power facto
0.3
0.4
0.6
none

⇒

Assertion (A): In register indirect addressing mode of 8085, the address of operand is in the specified register.

Reason (R): An example of register indirect addressing mode is MOV, A, M..

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct