Question is ⇒ The Causal system given below is _______, Options are ⇒ (A) maximum phase, (B) minimum phase, (C) mixed phase, (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ The Causal system given below is _______, Options are ⇒ (A) maximum phase, (B) minimum phase, (C) mixed phase, (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The Causal system given below is _______
A.	maximum phase [Wrong Answer]
B.	minimum phase [Correct Answer]
C.	mixed phase [Wrong Answer]
D.	none of these [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a 1 cm x 2 cm air filled rectangular waveguide the maximum frequency should be less than about
1000 MHz
5000 MHz
14000 MHz
140000 MHz

⇒ In the Taylor series expansion of exp(x) + sin(x) about the point x = p, the coefficient of (x - p)² is
exp (p)
0.5 exp (p)
exp (p) + 1
exp (p) - 1

⇒ The disturbance from adjacent power lines is known as
cross talk
cross fire
inductive disturbance
none of the above

⇒ Thermal noise has a power spectral density which is quite uniform upto frequencies in the order of
100 Hz
10⁶ Hz
10⁹ Hz
10¹³ Hz

⇒ As compared to an ordinary semiconductor diode, a Schottky diode
has higher reverse saturation current
has higher reverse saturation current and higher cut in voltage
has higher reverse saturation current and lower cut in voltage
has lower reverse saturation current and lower cut in voltage

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ The fluctuation in the received signal strength at the receiver of a random variation in the received signal is known as
fluctuation
fading
absorption
cycling

⇒ Short circuited stubs are preferred to O.C stubs because
O.C stubs are incapable of giving full range of reactances
O.C stubs are liable to radiate
O.C stubs are difficult to make and connect
none of the above

⇒ Addition of a small amount of antimony to germanium will result in
formation of p-type semiconductor
more free electrons than holes in semiconductor
antimony concentrating on the edges of the crystal
increased resistance

⇒ In PAL system weighting of R - Y and B - Y signals is done to
prevent over modulation on saturated colours
prevent under modulation of saturated colours
allow over modulation of saturated colours
allow under modulation on saturated colours

⇒ A radio station works at 800 kHz and uses AM. If this is a public broadcast system, it should transmit using
parabolic reflector to transmit all round
turnstile antenna for the required land
half wave long horizontal wave
a vertical antenna less than quarter for practical reasons

⇒ For an amplifier the power gain in decibels will be equal to voltage gain in decibels only when
R₀ = 0
R₀ = R_i = 90
R₀ = R_i
R_i = 0

⇒ K maps can be drawn
only for 2 variables
only for 3 variables
only for 4 variables
for any number of variables

⇒ Given a power supply filter circuit, what measurements must be made of determine percentage regulation
current through and voltage across the capacitor
d.c. load voltage and r.m.s. load voltage
current through load and voltage across load resistance
number of turns and gauge of secondary winding of transformer

⇒ The seven segment display used in watches and clocks generally uses
LED
LCD
Photodiode
FET

⇒ Tellegen's theorem is applicable to
circuits with passive elements only
circuits with linear elements only
circuits with time invariant elements only
circuits with active or passive, linear or nonlinear and time invariant or time varying elements

⇒ The magnetic quantum number determines the component of angular momentum along a prescribed direction.
TRUE
FALSE

⇒ When a semiconductor bar is heated at one end, a voltage across the bar is developed. If the heated is positive the semiconductor is
P-type
n-type
intrinsic
highly degenerate

⇒ A Hartley oscillator is used for
very low frequencies
radio frequencies
micro wave frequencies
audio frequency

⇒ Find the output voltage for 011100 in a 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V.
6.4 V
2.84 V
0.1 V
8 V

⇒ The current I for the netw
0 mA
10.72 mA
10.94 mA
11.32 mA

⇒ Status register in the 8156 contains information about
the timer
the ports
both (a) and (b)
none of the above

⇒ The depletion layer around p-n junction in JFET consists of
hole
electron
immobile charges
none of the above

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ Figure shows the variation of Z(ω) for a positive real function. The functio
RC impedance
RL impedance
RLC impedance
Reactance function

⇒ The stray capacitance between the last stage and the first stage of an oscillator may cause
unwanted low frequency oscillations
unwanted high frequency oscillations
unwanted oscillations at low and high frequencies
large feedback

⇒ When a unit step voltage drives a lag network the output
remains constant at unit step value
increases exponentially from zero to final value
decreases exponentially from 1 to 0
either (b) of (c) depending on values of R and C

⇒ How many and which types of machine cycles are needed to execute PUSH PSW by 8085 microprocessor?
2, Fetch and memory write
3, Fetch and memory write
3, Fetch and memory read
3, Fetch and memory read and memory write

⇒ In the given circuit, viewed from AB, the circuit can be reduced to an equivalent circui
5 volts source in series with 10 Ω resistor
7 volts source in series with 2.4 Ω resistor
15 volts source in series with 2.4 Ω resistor
1 volt source in series with 10 Ω resistor

⇒ In C the keywords are also called
special words
reserved words
class words
character words