Question is ⇒ A thermistor is used for, Options are ⇒ (A) over voltage protection, (B) temperature alarm circuit, (C) automatic light control, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A thermistor is used for, Options are ⇒ (A) over voltage protection, (B) temperature alarm circuit, (C) automatic light control, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A thermistor is used for
A.	over voltage protection [Wrong Answer]
B.	temperature alarm circuit [Correct Answer]
C.	automatic light control [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The integral of a unit step function is
an impulse function
a ramp function
a ramp function of slope 1
none of these

⇒ Two coils are so wound that 60% of the flux of one links the other. The coefficient of coupling is
1.67
0.6
0.36
0.216

⇒

Assertion (A): In AM carrier component remains constant in amplitude and frequency.

Reason (R): In AM the two side bands are images of each other.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In the given figure, the flip flop
negative edge triggered
positive edge triggered
level triggered
either (a) or (c)

⇒ Lowest resistivity of the following is
constantan
german silver
manganin
nichrome

⇒ Which amplifier has a voltage gain of less than 1?
Common emitter
Common collector
Common base
Both CB and CC

⇒

Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls.

Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Convolution of x(t + 5) with impulse function δ(t - 7) is equal to
x(t - 2)
x(t + 12)
x(t - 12)
(t + 2)

⇒

Assertion (A): Negative values of incremental operator in DO loop are allowed in Fortran 77 but not in earlier versions of Fortran.

Reason (R): Fortran 77 has better array facilities than earlier versions of Fortran.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A crowbar circuit is generally needed for protection under fault conditions.
TRUE
FALSE

⇒ A voltage V_BB is applied across the terminals of a UJT. The emitter voltage at peak point is
hV_BB
(h + 1) V_BB
hV_BB + V_D
V_D

⇒ If X(z) = (1 - az^-1)^-1 and |a| < |z|, the initial value x₀ = 0
TRUE
FALSE

⇒ The op amp is used in
A/D converters
D/A converters
both (a) and (b)
shift registers

⇒ TRAP is __________ whereas RST 7.5, RST 6.5, RST 5.5 are __________ .
maskable, non-maskable
maskable, maskable
non-maskable, non-maskable
non-maskable, maskable

⇒ The A.C. resistance of the emitter diode will be
5.05 Ω
50.5 Ω
505 Ω
5050 Ω

⇒ A digital voltmeter has a read out range from 0 to 999 counts. If the full scale reading is 9.999 V, the resolution is
1 V
0.01 V
1 mV
1 μV

⇒ If for a silicon n-p-n transistor, the base to emitter voltage (V_BE) is 0.7 V and the collector to base voltage V_CB is 0.2 Volt, then the transistor is operating in the
normal active mode
saturation mode
inverse active mode
cut off mode

⇒ Is Schottky TTL, Schottky diode is used primary to
prevent saturation of the transistor
saturate the transistor
act as a switch
act as a controlling switch

⇒ Consider the following program for 8085 decimal 20
decimal 40
decimal 10
none of the above

⇒ Which of the following is used to generate PDM?
Free running multi-vibrator
Monostable multi-vibrator
JK flip-flop
Schmitt trigger

⇒ India's Polar Satellite Launch vehicle (PSLV) to be ready in 1991 is designed to launch 1000 kg spacecraft into __________ orbit.
geostationary
equatorial
polar
sun-synchronous polar

⇒ In the circuit of figure diode will con
from 90 to 180° in the positive half cycle
from 30° to 180° in the positive half cycle
from 50° to 160° in the positive half cycle
from 30° to 150° in the positive half cycle

⇒ In a minimum phase system
all poles lie in the left half plane
all zeros lie in the left half plane
all poles lie in the right half plane
all except one pole or zero lie in the left half plane

⇒ Three impedances (3 + j 4) Ω each are connected in star. The impedances of equivalent delta circuit will be
3 - j 4 Ω each
9 + j 12 Ω each
9 - j 12 Ω each
3 + j 4, 3 - j 4 and 4 - j 3 Ω

⇒ In a JK flip flop toggle means
set Q = 1 and Q = 0
set Q = 0 and Q = 1
change the output to the opposite state
no change in output

⇒ A telephone user while talking to a person via a satellite has to wait for reply for about __________ millisecond.
100
270
470
540

⇒ Thu advantage of using a dual stop ADC in a digital voltmeter is that
its conversion time is small
its accuracy high
output is in BCD format
it does not require a comparator

⇒ A silicon diode is forward biased and total applied voltage is 5 V. The voltage across p-n junction is
5 V
Slightly less than 5 V
0.7 V
0

⇒ In a piezoelectric crystal, application of a mechanical stress would produce
plastic deformation of the crystal
magnetic Dipoles in the crystal
electric polarization in the crystal
shift in the Fermi level

⇒ In a decimal digital computer, the number 127 is stored
1111111
0001 00100111
10001
11000111