Question is ⇒ The current wave shown in figure is applied at t = 0 to a 0.1 F capacitor. At t = 1 s, the voltage across capacito, Options are ⇒ (A) 0 V, (B) 10 V, (C) 20 V, (D) 40 V, (E) , Leave your comments or Download question paper.

Question is ⇒ The current wave shown in figure is applied at t = 0 to a 0.1 F capacitor. At t = 1 s, the voltage across capacito, Options are ⇒ (A) 0 V, (B) 10 V, (C) 20 V, (D) 40 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The current wave shown in figure is applied at t = 0 to a 0.1 F capacitor. At t = 1 s, the voltage across capacito
A.	0 V [Wrong Answer]
B.	10 V [Wrong Answer]
C.	20 V [Correct Answer]
D.	40 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure shows a parallel resonant circuit having resonance frequency of 15 MHZ. At this frequ
its impedance is minimum
its impedance is maximum
its impedance is infinite
its impedance is zero

⇒ As the bandwidth increases, the cost of components
generally decreases
generally increases
may increase or decrease
does not change

⇒ If f_h(t) is the Hilbert transform of f(t), and f(t) is a real valued signal, the pre-envelope of f(t) is
f(t) - jf_h(t)
f(t) + jf_h(t)
f_h(t) + jf(t)
f_h(t) - jf(t)

⇒ When a superheterodyne receiver is tuned to 455 kHz, its local oscillator provides a mixer with the input at 1010 kHz. The image frequency is
555 kHz
1010 kHz
1465 kHz
1920 kHz

⇒ Fortran 77 has six arithmetic operators.
TRUE
FALSE

⇒ Lead mounting for SCR is used for
rating less than mA
rating about 1 A or less
rating of 20 A or less than 20 A
rating 100 A or less

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ An instruction used to set the carry flag in a computer can be classified as
data transfer
arithmetic
Logical
program control

⇒ If a sound wave has a frequency of 50 Hz, the wavelength is
66 m
6.6 m
0.66 m
0.066 m

⇒ Time delay of a TTL standard family is about
180 ns
50 ns
18 ns
3 ns

⇒ An R-L circuit has an initial current of 5 A. In the s-domain equivalent circuit, the voltage source to take into account the initial current has a strength of
5L volts
5/L volts
5L² volts
5/L² volts

⇒ Which of the following statement is false?
Bandwidth of a circuit is given by the range of frequencies lying between half-power points
Half-power points on a resonance curve are those points where power is half of that at resonance
Half-power points are also known as 3 dB points
At both half-power points, the p.f. = 0.707 lagging

⇒ In a rectangular waveguide if operating frequency is greater than cut off frequency then propagation constant is
purely real
purely imaginary
equal to unit
a complex number

⇒ Which of the following can be used as a buffer amplifier?
CE
CC
CB
Both (a) and (c)

⇒ The phase difference between them is __________ degrees.
15
50
60
105

⇒ All other parameters remaining the same, a 3 phase bridge inverter with 180° mode of operation
has the same peak thyristor current as in 120° mode of operation
has higher peak thyristor current than in 120° mode of operation
has lower peak thyristor current than in 120° mode of operation
any of the above

⇒ In a digital system there are three inputs ABC. Output should be high when atleast two inputs are high. Then output =
AB + BC + AC
ABC + ABC + A BC + ABC
AB + BC + AC
AB + BC + AC

⇒ The advantage of semiconductor strain gauge over resistance strain gauge is
it is more sensitve
it is more linear
it is less temperature dependent
it is cheaper

⇒ A DAC has full scale output of 5 V. If accuracy is ± 0.2% the maximum error for an output of 1 V is
5 mV
10 mV
2 mV
20 mV

⇒ Decimal number 5436 when converted into 9's complement will become
4356
4653
4563
4655

⇒ A potential of 7 V is applied to a silicon diode. A resistance of 1 kΩ is also connected in series. If the diode is forward biased, the current in the circuit is
7 mA
6.3 mA
0.7 mA
0

⇒ In a superheterodyne receiver with an IF of 450 kHz is tuned to a signal at 1200 kHz. The image frequency is
750 kHz
990 kHz
1650 kHz
2100 kHz

⇒

Assertion (A): The velocity factor of a line is the ratio of wave velocity on the line to speed of light.

Reason (R): If the conductors of a line are immersed in a non magnetic insulating liquid, the wave velocity increases.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The bandwidth of an amplifier can be reduced by
miller effect compensation
pole zero compensation
dominant pole compensation
lead compensation

⇒

Assertion (A): In series R-L-C circuit, the current may lead or lag the voltage depending on the value of R.

Reason (R): Phase angle of an R-L series circuit is tan^-1 (ωL/R).

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): Data communication using digital data must be very accurate.

Reason (R): In analog signals redundancy is available but in digital signals redundancy is not available.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following represents a stable system?

Impulse response decreases exponentially.
Area within the impulse response in finite.
Eigen values of the system are positive and real.
Roots of the characteristic equation of the system are real and positive.

Select the answer using the following codes:
1 and 4
1 and 3
2, 3 and 4
1, 2

⇒ In given figure a silicon diode is carrying a constant current of 1 mA. When the temperature of the diode is 20°C, V_D is found to be 700 mV. If the temperature rises to 40°C, V_D becomes approximately equa
747 mV
660 mV
680 mV
700 mV

⇒ Tuned voltage amplifiers are not used
in public address systems
in radio receivers
in television receivers for sound signals
in television receivers for video signals

⇒ In a klystron amplifier the transit time of electron passing the gap in the cavity should be
less than one cycle
less than half cycle
less than quarter cycle
more than quarter cycle