Question is ⇒ Discharge breakdown in insulators is due to voids., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Discharge breakdown in insulators is due to voids., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Discharge breakdown in insulators is due to voids.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Radiowaves are electromagnetic waves having frequency range
0.001 to 50 H
0.001 to 50 kHz
0.002 to 50 MHz
0.001 to 10¹⁶ Hz

⇒ The materials having low retentivity are suitable for making
temporary smagnets
weak magnets
permanent magnets
both temporary and permanent magnets

⇒ For the K map in the given figure the simplified Boolean expressio
A C + A D + ABC
A C + A D + ABC
A C + A D + ACD
A C + A D + AB C

⇒ In a composite filter terminating half sections are used for impedance matching.
TRUE
FALSE

⇒ In colour TV receiver, varactor diode is used for
detection
rectification
tuning
both (a) and (b)

⇒ Figure represen
NPN transistor
PNP transistor
Zener diode
Power diode

⇒ For measuring mutual inductance we can use
Anderson bridge
Maxwell's bridge
Heaviside bridge
Either (a) or (b)

⇒ A ship-to-ship communication system is plagued by fading. The best solution seems to be the use of
space diversity
frequency diversity
a broad band antenna
a more directional antenna

⇒ If the functions w, x, y, z are as foll
w = z x = z
w = z, x = y
w = y
w = y = z

⇒ In a full bridge circuit supplying an RLC under damped circuit
the waveshapes of output voltage and load current are square
the waveshapes of output voltage and load current are sinusoidal
the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
none of the above

⇒ If Y(s) = 1 + s, the network has
1 Ω resistor and 1 F capacitor in series
1 Ω resistor and 1 F capacitor in parallel
1 Ω resistor and 1 H inductor in series
1 Ω resistor and 1 H inductor in parallel

⇒ In 8355, the ROM is organized as __________ words of 8 bits each.
2000
2048
8355
835

⇒

Assertion (A): Operator has a value 1 ∠ - 90° or 1 ∠ 90°.

Reason (R): Operator 'a' has a value 1 ∠ 120°.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Peak inverse voltage will be highest for
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_CQ will be
910 mA
5 mA
5.25 mA
4.95 mA

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒

Assertion (A): Gunn diode is a transferred electron device.

Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): A p-n junction has high resistance in reverse direction.

Reason (R): When a reverse bias is applied to p-n junction, the width of depletion layer increases.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ At night the ionosphere can be considered to be consisting of
D, E, F₁ and F₂ layers
D, E, F₁ layers
D, E, F₂ layers
E and F₂ layers

⇒ Following figure repres
AND
OR
NAND
NOT

⇒ R, L and C are in parallel. The circuit is switched on to a constant current source I at t = 0. At t = ∞ the current through inductance is I.
TRUE
FALSE

⇒ The circuit in the given figur
positive logic OR gate
negative logic OR gate
negative logic AND gate
positive logic AND gate

⇒

Assertion (A): The velocity factor of a line is the ratio of wave velocity on the line to speed of light.

Reason (R): If the conductors of a line are immersed in a non magnetic insulating liquid, the wave velocity increases.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If a line is terminated in characteristic impedance Z₀, the input impedance measured at the input will be
Z₀
Z₀/2
Zero
infinite

⇒ The domain mode in rectangular waveguide is
TE₀₁
TE₀₂
TE₁₀
TM₁₁

⇒ A minimum function has
poles and zeros on imaginary axis of s plane
no poles or zeros on imaginary axis of s plane
only poles but no zeros on imaginary axis of s plane
only zeros but no poles on imaginary axis of s plane

⇒ In 8085, TRAP is
always maskable
cannot interrupt a service subroutine
used for catastrophic events like temporary power failure
lowest priority interrupt

⇒ Consider the following sys
System I has larger bandwidth and faster speed of response than System II
System II has larger bandwidth and faster speed of response than System I
System I has larger bandwidth but System II has faster speed of response
System II has larger bandwidth but System I has faster speed of response

⇒ The power factor at the input terminals of a cyclo- converter is generally
low and leading
low and lagging
high and leading
high and lagging

⇒ Frequency range for satellite communication is
1 kHz to 100 kHz
100 kHz to 10 MHz
10 MHz to 100 MHz
1 GHz to 30 GHz