Question is ⇒ Which of the following statements defines a full adder?, Options are ⇒ (A) It adds two binary digits and produces their SUM and CARRY, (B) It adds three inputs (two binary digits and a carry) and produces their SUM and CARRY, (C) It has two inputs and two outputs, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following statements defines a full adder?, Options are ⇒ (A) It adds two binary digits and produces their SUM and CARRY, (B) It adds three inputs (two binary digits and a carry) and produces their SUM and CARRY, (C) It has two inputs and two outputs, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following statements defines a full adder?
A.	It adds two binary digits and produces their SUM and CARRY [Wrong Answer]
B.	It adds three inputs (two binary digits and a carry) and produces their SUM and CARRY [Correct Answer]
C.	It has two inputs and two outputs [Wrong Answer]
D.	None of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If input ac is 10 V_rms, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be
10 V
14 V
20 V
28 V

⇒ In 8085 the instruction MOV A, B is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ A dipole antenna was radiating with some excitation in free space radiating a certain amount of the power. If this antenna is immersed in a lake where water is non-dissipative but has a dielectric constant of 81, the radiated power with the same excitation will
decrease to finite non-zero value
remain the same
increase
decrease to zero

⇒ The rate of change of excess carrier density is proportional to carrier density.
TRUE
FALSE

⇒ h parameters are used in transistor analysis.
TRUE
FALSE

⇒ The earliest uses of electromagnetic waves were
point to point communication
radar
both (a) and (b)
neither (a) nor (b)

⇒ Inverse Fourier transform of '1' is
U(t)
δ(t)
0'
infinite

⇒ Panel type instruments are used in
power stations
automobiles
industries
all of the above

⇒ The system with given pole-zero diagram is _______
Causal
Anti-causal
Both sided
Cannot be determined

⇒ When all the seven segments of a display are energized, the number shown is
0
1
7
8

⇒ The number of valence electrons in a donor atom is
2
3
4
5

⇒ Periodic recharging of the memory cells at regular intervals of 3 to 8 millisecond is required in a
ROM
Static RAM
Dynamic RAM
PLA

⇒ A 3 phase induction motor is fed by a 3 phase ac regulator to change the stator voltage. The variation in speed will be more if
load torque is constant
load torque increases with increase in speed
load torque decreases with increase in speed
either (a) or (b)

⇒ In P-N junction, the region containing the uncompensated acceptor and donor ions is called
transition zone
depletion region
neutral region
active region

⇒ The relative permeability of a ferromagnetic material is
1
less than 1
about 10
1000 or more

⇒ X(t) is a stationary process with the power spectral density S_x(f) > 0 for all f. The process is passed through a system shown be
S_y(f) > 0 for all f
S_y(f) = 0 for |f| > 1kHz
S_y(f) = 0 for f = nf₀, f₀ = 2kHz, n any integer
S_y(f) = 0 for f = (2n + 1)f₀ = 1 kHz, n any integer

⇒ A 100 + j 100 Ω load is to be matched to a line with Z₀ = 300 Ω to give SWR = 1. The reactance of stub is
j 200 Ω
-j 200 Ω
j 100 Ω
-j 100 Ω

⇒ In a second order system with a unit step input, the speed of response is high if system is
overdamped
undamped system
critically damped
underdamped

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ Heating effect of current is used in
ammeters
voltmeters
both ammeters and voltmeters
wattmeters

⇒ Feedback factor may be less or more than 1.
TRUE
FALSE

⇒ The symbol in figure is
UJT
PUT
SCS
SBS

⇒ In a N-P-N transistor of the emitter junction is reverse biased and collector junction is also reversed biased, the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒ How many number of branches the root loci of the equation s(s + 2)(s + 3) + K(s + 2) = 0 have?
Zero
One
Two
Three

⇒

Match the following:

	List I		List II
A.	Electro-encephalograph	1.	Diagnostic tool for heart ailment
B.	Electro-cardiograph	2.	Diagnostic tool for brain ailment
C.	Sphygmomanometer	3.	used for measuring BP
D.	Stethoscope	4.	used to heart pulse/ heart beat

A-2, B-1, C-3, D-4
A-3, B-1, C-2, D-4
A-2, B-1, C-4, D-3
A-1, B-2, C-3, D-4

⇒

Assertion (A): A tuned amplifier uses a parallel tuned circuit

Reason (R): A tuned amplifier is used to amplify a narrowband frequencies

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Before doping the semiconductor material is
dehydrated
heated
hardened
purified

⇒ For the polynomial P(s) = s⁵ + s⁴ + 2s³ + 2s² + 3s + 15 The number of roots which lie in the right half of the s plane is :
4
2
3
1

⇒ The 2 out of 5 code has
two 0s and three 0s in each code group
one 1s and four 0s in each code group
four 1s and one 0s in each code group
three 1s and two 0s in each code group

⇒ When electronic emission occurs due to bombardment of high velocity electrons on a metal surface, it is called secondary emission.
TRUE
FALSE