Question is ⇒ Two resistances are R1 = 36 ± 5% and R2 = 75 ± 5%. If they are connected in parallel, the limiting error in percent will be, Options are ⇒ (A) 0.05, (B) 0.1, (C) 0.15, (D) 0.2, (E) , Leave your comments or Download question paper.

Question is ⇒ Two resistances are R1 = 36 ± 5% and R2 = 75 ± 5%. If they are connected in parallel, the limiting error in percent will be, Options are ⇒ (A) 0.05, (B) 0.1, (C) 0.15, (D) 0.2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two resistances are R₁ = 36 ± 5% and R₂ = 75 ± 5%. If they are connected in parallel, the limiting error in percent will be
A.	0.05 [Wrong Answer]
B.	0.1 [Wrong Answer]
C.	0.15 [Correct Answer]
D.	0.2 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The static characteristic of an adequately forward biased p-n junction is a straight line if the plot is of
log I vs log V
log I vs V
I vs log V
I vs V

⇒ Which of the following is open loop system?
Wind screen wiper
Aqualing
Respiratory system of animal
System for controlling antirocket missiles

⇒ In a lead acid battery
the numbers of positive and negative plates are equal
the number of positive plates may be equal to or more than the number of negative plates
the number of positive plates is more than the number of negative plates
the number of negative plates is more than the number of positive plates

⇒

Assertion (A): A band elimination filter attenuates signals whose frequencies lie between the cutoff frequencies.

Reason (R): A band elimination circuit is very different from band pass circuit.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a flip-flop with RS latch a high S and a low R set the output to __________ and a low S and a high R set the output __________ .
low, low
high, high
low, high
high, low

⇒ The antenna diameter of a radar system is doubled. The maximum range will
be doubled
become four times
be halved
decrease to one fourth

⇒ In a parallel resonant circuit, the circuit current at resonance is maximum.
TRUE
FALSE

⇒ Four capacitors are in parallel. Their values are 36.3 μF, 3.85 μF, 34.002 μF and 850 μF with an uncertainty of digit in the last place. The total capacitance in significant figures is
75.0 μF
75.0 ± 0.1 μF
75.1 ± 0.1 μF
75.002 ± 0.1 μF

⇒ Bandwidth is proportional to speed of response.
TRUE
FALSE

⇒ IN 3242 is a
P-N-P transistor
N-P-N transistor
UJT
semi-conductor diode

⇒

Assertion (A): At a temperature of 1000 K, thermionic emission current is about 0.1 A/cm² of surface.

Reason (R): Thermionic emission current is given by I_th = SA₀ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A bridge type single phase cycloconverter changes the frequency f to f/3. Then one half wave of output contains
3 full waves of input
3 half waves of input
6 full waves of input
6 half waves of input

⇒ The advantage of Marconi antenna over the ungrounded antenna is that
only one fourth of the height is required as compared to undergrounded antenna
one-half of the height is required as compared to undergrounded antenna
no capacitance required
none of the above

⇒ The rms voltage measured across each of the circuit element in figure is as shown, when the circuit is excited by a sinusoidal voltage E_s, the rms value of the source voltage e_{s10 volt
2 volt
E_s
5 volt}

⇒ In a computer the instructions, data, intermediate and final results during processing are held in ALU.
TRUE
FALSE

⇒ In series as well as parallel resonant circuits, increasing the value of resistance would lead to
decrease in bandwidth of both the circuits
increase in bandwidth of both the circuits
decrease in bandwidth in series circuit and increase in parallel circuit
increase in bandwidth in series circuit and decrease in parallel circuit

⇒ The maximum usable frequency for the 'E' layer is 10 MHz.
TRUE
FALSE

⇒ In a Communication system, noise is most likely to affect the signal.
at the transmitter
In the channel
in Information source
at the destination

⇒ The value of program counter of 6800 at power on are after reset is
0
FFFE
User Programmable
FFFF

⇒

Assertion (A): A 3 phase wattmeter consists of two wattmeters mounted in one case.

Reason (R): Power measurement in a 3 phase circuit can be conveniently done by two wattmeter method.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A 1000 kHz carrier is simultaneously modulated by 300 Hz and 2 kHz audio sine wave. Which of the following frequencies will not be present in the output?
998 kHz
999.7 kHz
1000.3 kHz
700 kHz

⇒ The turn ratio of a transformer is 20:1, if a load of 10Ω is connected across the secondary, what will be the effective resistance seen looking into the Primary?
2 kΩ
4 kΩ
8 kΩ
32 kΩ

⇒ A rare gas has N atoms per m³. If electronic polarizability of single atom of this gas is a_e, then
∈_r = Na_e
∈₀∈_r = Na_e
∈₀(∈_r - 1) = Na_e
∈₀(∈_r - 2) = Na_e

⇒ It is desired to reduce the reflection at an air porcelain by use of 7/4 plate (for Porcelain μ = 40, and ε_r = 7). The thickness of the polystyrene plate required at 10 GHz will be
5.039 cm
50.39 cm
0.5039 cm
0.05039 cm

⇒ Which of the following is used in automatic control of street lights?
Thermistor
Photoconductor
Transistor
Varistor

⇒ The logic realized by the circuit shown in figure belo
F = A - C
F = A + C
F = B ⊙ C
F = B ⊕ C

⇒ The input impedance for a half dipole if radii of both the antenna is 4 and 8 meter respectively
600 Ω
100 Ω
657 Ω
650 Ω

⇒ Human body cannot sustain electric current beyond
1 μA
10 μA
5 μA
35 μA

⇒ A capacitor having capacitance C is raised to voltage V. The energy stored will be
CV²
V²/C
0.5 V²C
0.5 C²V

⇒ Which of the following directives in 8085 causes two bytes to be reserved in the memory?
D S
D B
D W
E Q U