Question is ⇒ Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The use of microprocessor control in automobiles results in
improved fuel economy
improved car control
advanced information system for driver
all of the above

⇒ Ripple factor RF and form factor FF are related as
RF = FF² - 1
RF = (FF² - 1)^0.5
RF = FF - 1
RF = (FF - 1)^0.5

⇒ To prevent a DC return between source and load, it is necessary to use
resistor between source and load
inductor between source and load
capacitor between source and load
either (a) or (b)

⇒ A silicon diode is forward biased and total applied voltage is 5 V. The voltage across p-n junction is
5 V
Slightly less than 5 V
0.7 V
0

⇒ VSWR = E_max/E_min.
TRUE
FALSE

⇒ A 400 W carrier is amplitude modulated with m = 0.75. The total power in AM is
400 W
512 W
588 W
650 W

⇒ The three sides of an admittance triangle denote
G, B, Y
R, X, Y
G, B, Z
(R, Y, Z) or (R, X, Z)

⇒ In order to receive a vertical polarized wave, the conductor of the dipole should be mounted
horizontally
vertically
at an angle of 45°
at an angle of 90°

⇒

Hall coefficient R_H is directly proportional to the charge density
R_H depends upon type of the semiconductor material (n - type or p - type)
Hall co-efficient R_H is directly proportional to hall voltage V_H

From the above statements which are the false statements?
I only
II only
III only
all of the above

⇒ De-emphasis circuit is used
to attenuate high frequencies
to attenuate low frequencies
to attenuate mid-band frequencies
None of the above

⇒ In 8085, which of the following registers cannot be paired?
A
E
C
both (b) and (c)

⇒

Match the following:

	List I (Amplifier coupling)		List II (Feature)
A.	RC	1.	High voltage gain and impedance matching
B.	Inductive	2.	Ability to amplify dc and low frequency signals
C.	Transformer	3.	Minimum non-linear distortion
D.	Direct	4.	Low collector supply voltage can be used

A-4, B-1, C-3, D-2
A-3, B-4, C-1, D-2
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1

⇒ The function shown in the given Figure can be writte
sum of two sinusoidal functions
sum of two sinusoidal functions one originating at t = 0 and the other at t = 1
difference of two sinusoidal functions one originating at t = 0 and the other at t = 1
none of the above

⇒ In calculating output impedance of an amplifier the source is replaced by an open circuit.
TRUE
FALSE

⇒

Assertion (A): A class C chopper can operate in first and second quadrants

Reason (R): A class B chopper operates only in second quadrant.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ The number of flip flops needed for a Mod 7 counter are
7
5
3
1

⇒ In TE₁₀ mode of rectangular waveguide
there is one half sine wave variation along x direction and one along y direction
there is one half sine wave variation along y direction and one along x direction
there is one full sine wave variation along x direction and one along y direction
none of the above

⇒ Voltage 1 + 2 sin ωt is applied to the circuit shown be
0 volt
2 volts
-2 volts
-3 volts

⇒ Dynamic memory cells are constructed using
FETs
MOSFETs
Transistors
Flip flops

⇒ If i_b is plate current, e_b is plate voltage and e_c is grid voltage the v-i curve of a vacuum triode
0.5 and 1
- 2 and 1
30 and 1
30 and 1.5

⇒ Find current flowing through 1 H inductor at t = 0, at which switch 'S' is ope
0
2
3
5

⇒ A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is
21 kHz
22 kHz
42 kHz
44 kHz

⇒ Figure represen
Varactor
LED
Zener diode
Temperature dependent diode

⇒ The frequency tolerance for the RF carrier in the standard AM radio broadcast band is
zero
+20 Hz
+1000 Hz
+25 Hz

⇒ The emf of a Weston cell is 1.286 V.
TRUE
FALSE

⇒ Figure given below shows the internal schematic of a TTL AND-OR Invert (AOI) gate, For the input shown in the given figure, the output
0
1
AB
AB

⇒ Which of the following antennas is circularly polarized?
Yagi-Uda
Parabolic reflector
Small circular loop
Helical

⇒ A digital voltmeter has a read out range from 0 to 999 counts. If the full scale reading is 9.999 V, the resolution is
1 V
0.01 V
1 mV
1 μV

⇒ The Darlington pair consists of the following two stages
CE and CC
both CE
both CC
CE and CB