Question is ⇒ In a TWT the amplitude of resultant wave travelling down the helix, Options are ⇒ (A) increases exponentially, (B) increases linearly, (C) decreases exponentially, (D) is almost constant, (E) , Leave your comments or Download question paper.

Question is ⇒ In a TWT the amplitude of resultant wave travelling down the helix, Options are ⇒ (A) increases exponentially, (B) increases linearly, (C) decreases exponentially, (D) is almost constant, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a TWT the amplitude of resultant wave travelling down the helix
A.	increases exponentially [Correct Answer]
B.	increases linearly [Wrong Answer]
C.	decreases exponentially [Wrong Answer]
D.	is almost constant [Wrong Answer]
View Answer 4 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The emitter bias largely depends on
gain
signal input
I_E
none of the above

⇒ The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to
any where
a dc ground potential
the most positive potential available in the circuit
the most negative potential available in the circuit

⇒ The output of a linear system for any input can be computed in which of the following ways?
Only by summation of inpulse response by convolution integral
Only by summation of step response by superposition integral
Neither a nor b
Either (a) or (b)

⇒ Which of the following is a valid real variable in FORTRAN 77?
IT
GURGAON
42892
SUNDAY

⇒

Assertion (A): Power transistors are more commonly of silicon npn type.

Reason (R): The fabrication of silicon npn transistors is easy.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Graphic equaliser system in stereophonic systems generally have
3 or 4 bands
1 band
more than 8 bands
large number of bands

⇒ A radar beacon is a small radar set having a receiver, a separate transmitter and an antenna.
TRUE
FALSE

⇒ 4 point DFT for x(n) = {2, - 1, 2, 3} is
{6, 4 - 2j, 2, 2j}
{6, 4j, 2, - 4j}
{6, -1 + 3j, 4 - 4j, 4 - 2}
{6, 2j, 4 - 2j, - 2 + 2j}

⇒ The function of interface circuit is
to match output conditions of driver with input conditions of load device
to match output conditions of load device with input conditions of driver
both (a) and (b)
neither (a) nor (b)

⇒ What kind of signal does the times produce?
Single pulse
Square wave
Continuous pulse
No signal

⇒ The circuit shown in the figure, with R = 1/3 Ω, L = 1/4H, C = 3F has input voltage v(t) = sin2t. The resulting current i(t
5 sin (2t + 53.1°)
5 sin (2t - 53.1°)
25 sin (2t + 53.1°)
25 sin (2t - 53.1°)

⇒ The following circuit resonate
0.5 Hz
5 Hz
1 rad/sec
0.5 rad/sec

⇒ The number of LED display indicators in logic probe are
1
2
1 or 2
4

⇒ Pick out the odd one
stochastic variable
stochastic function
random variable
random experiment

⇒ Which of the following is also called Non volatile RAM?
Shadow RAM
UVEPROM
EEPROM
Both (b) and (c)

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ In a low level amplitude modulated system, the amplifier modulated stage must be
class C
linear
non linear
harmonic

⇒ Which one of the following can be used for amplification of microwave energy?
TWT
Magnetron
Reflex klystron
Gunn diode

⇒ A broadside array operating at 100 cm wavelength consist of 4 half-wave dipoles spaced 50 cm apart. Each element carries radio frequency current in the same phase and of magnitude 0.5 A. The radiated power will be
196 W
73 W
36.5 W
18.25 W

⇒ In a minimum function
the degree of numerator is higher than that of denominator
the degree of numerator is lower than that of denominator
the degree of numerator and denominator are equal
the denominator is a constant

⇒ The polarization of dielectric materials results in
production of eddy currents
creation of electric dipoles
absorption of electrons
release of high velocity protons

⇒ Four inputs A, B, C, D are fed to a NOR gate. The output of NOR gate is fed to an inverter. The output of inverter is
A + B + C + D
A + B + C + D
ABCD
ABCD

⇒ The output V₀ in figur
-100 V
-100 mV
10 V
10 mV

⇒ In a NAND SR latch S = R = 1. Then
Q = 1, Q = 0
Q = 0, Q = 1
both Q and Q will be same as before
the latch will be set

⇒ The linear transistor circuits always operate in the
saturation
cut off
active
inactive

⇒

Assertion (A): The transient performance of a control system is generally analysed by using unit step function as reference input.

Reason (R): Impulse is the most common input found in practice.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Consider a 300 Ω, quarter wave long at 1 GHz transmission line as shown in figure. It is connected to a 10 V, 50 Ω source at one end is left open circuited at the other end. The magnitude of the voltage at the open circuit end of the line
10 V
5 V
60 V
60/7 volt

⇒ For a 12 pulse operation, the two 6 pulse units are fed by
Y - Y and Y - Y transformers
Δ - Δ and Δ - Δ transformers
Y - Y and Y - Δ transformers
Y - Δ and Y - Δ transformers

⇒ n-type semiconductors
are negatively charged
are produced when indium is added as impurity to germanium
are produced when phosphorus is added as impurity to silicon
none of the above

⇒ In a network
Number of links = Number of branches - number of nodes + 1
Number of links = Number of branches - number of nodes
Number of links = Number of branches - number of nodes - 1
Number of links = Number of branches - number of nodes - 2