Question is ⇒ In spread spectrum technique, Options are ⇒ (A) a modulated signal is modulated again, (B) a modulated signal is modulated twice again, (C) the power of a modulated signal is increased, (D) the noise component of a modulated signal is decreased, (E) , Leave your comments or Download question paper.

Question is ⇒ In spread spectrum technique, Options are ⇒ (A) a modulated signal is modulated again, (B) a modulated signal is modulated twice again, (C) the power of a modulated signal is increased, (D) the noise component of a modulated signal is decreased, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In spread spectrum technique
A.	a modulated signal is modulated again [Wrong Answer]
B.	a modulated signal is modulated twice again [Wrong Answer]
C.	the power of a modulated signal is increased [Wrong Answer]
D.	the noise component of a modulated signal is decreased [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If a line having Z₀ = 300 ∠ 0 W is open circuited at far end, VSWR is
0
1
∞
2

⇒ In the given figure the input frequency f = 0.1 (1/2 p
0 dB
3 dB
-3 dB
20 dB

⇒ The name field effect is related to the __________ layers of a JFET.
depletion
drain
source
gate

⇒ An amplifier with resistive -ve feedback has two left poles in its open loop transfer function. The amplifier
will always be unstable at high frequencies
will be stable for all frequencies
may be unstable, depending on the feedback factor
will oscillate at low frequencies

⇒ A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with ε_r = 4. The reflection coefficient for the normal incidence is
zero
0.5 ∠180°
0.33 ∠0°
0.33 ∠180°

⇒ Which of the following is an indirect way of generating FM?
Armstrong modulator
Varactor diode modulator
Reactance FET modulator
Reactance bipolar transistor

⇒ Consider the following:

Oscillator
Emitter follower
Cascaded amplifier
Power amplifier

Where of these use feedback amplifiers?
1 and 2
1 and 3
2 and 4
3 and 4

⇒ The initial state of MOD-16 down counter is 0110. What state will it be after 37 clock pulses?
Indeterminate
110
101
1

⇒ In carbon resistor colour code, the fourth band indicates tolerance.
TRUE
FALSE

⇒ Find the value of K and velocity constant K_v so that the maximum overshoot in the unit step response is 0.2 and the peak time is 1
12.37, 0.175
12.86, 2.175
11.36, 1.175
1.86, 0.175

⇒ A microprocessor with a 16 bit address bus is used in a linear memory selection configuration. Address bus lines are directly uses as chip selects of memory chips with 4 memory chips the maximum addressable memory space is
64 k
16 k
8 k
4 k

⇒ The bridge is balanced when the value of R is
50 Ω
100 Ω
200 Ω
250 Ω

⇒

Match the following:

	List I (Characteristic equation)		List II (Degree of damping)
A.	s² + 15s + 56.25	1.	Undamped
B.	s² + 5s + 6	2.	Underdamped
C.	s² + 20.25	3.	Critically damped
D.	s² + 4.55s + 42.25	4.	Overdamped

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-1, B-2, C-4, D-3

⇒ A transistor may fail due to
open weld at the wire leads to the semi-conductor
short circuit caused by momentary overloads
overheating due to circuit failures
any of the above

⇒ Fields are said to be circularly polarized if
their magnitudes are equal
their magnitudes are equal and they differ in phase by ± 90°
their magnitudes are unequal and they differ in phase ± 90°
their magnitudes are unequal and they are in phase

⇒ The power to the base unit of a cordless telephone is supplied by
battery
AC mains
both battery and AC mains
either battery or AC mains

⇒ Which of the following is multiband HF receiving antenna?
Square loop
Log-periodic
Conical horn
Folded dipole

⇒ At t = ∞; V_R2 and V_C wil
4, 4
2, 4
0, 2
2, 0

⇒ In an amplifier the voltage gain is the ratio of
output voltage and emitter resistance
output voltage and input current
output voltage and input voltage
none of the above

⇒ In which one of the following types of analog to digital converts the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒ In a high frequency coaxial line and the length of line characteristic impedance is a function of
properties of insulating material only
inner and outer conductor radius only
both (a) and (b)
neither (a) nor (b)

⇒ At a frequency equal to cutoff frequency in a rectangular wave guide
the flow of electromagnetic energy is zero
the flow of electromagnetic energy is infinite
the flow of electromagnetic energy is 50% of maximum
the flow of electromagnetic energy is 10% of maximum

⇒ The attenuation in a waveguide near the cut off frequency is
zero
low
high
very high

⇒ M circles are symmetrical with respect to
real and imaginary axis
M = 1 straight line and real axis
M = 1 straight line and imaginary axis
M = 1 straight line

⇒

Match the following:

	List I		List II
A.	RC coupled amplifier	1.	Very low drift
B.	Tuned amplifier	2.	Flat frequency response from zero frequency onwards
C.	Chopper stabilized amplifier	3.	Flat frequency response with upper and lower cut off frequency
D.	DC amplifier	4.	Peak in gain frequency response

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1

⇒ When an SCR is reverse biased
two junctions are reverse biased and one junction is forward biased.
all the three junctions are reverse biased.
one junction is reverse biased and two junctions are forward biased.
any of the above depending on the magnitude of reverse bias.

⇒ The range of life time carriers (electrons and holes) is
1 μs to 100 μs
1 nano sec to 1 μs
1 nano sec to hundreds of μs
none of the above

⇒ In a 3 phase full converter, the instantaneous output voltage can have negative part if
firing angle is less than 60°
firing angle is less than 90°
firing angle is more than 60°
firing angle is more than 90°

⇒ The most commonly used moving iron instruments are
repulsion type
attraction type
a combination of attraction and repulsion type
none of the above

⇒ A receiver having poor IF selectivity will also have poor
sensitivity
double spotting
blocking
all of the above