Question is ⇒ If X(z) = (1 - a)z-1/[(1 - z-1)(1 - az-1)] and 1 < |z|, the final value of xk is, Options are ⇒ (A) 0, (B) 1, (C) ∞, (D) 2, (E) , Leave your comments or Download question paper.

Question is ⇒ If X(z) = (1 - a)z-1/[(1 - z-1)(1 - az-1)] and 1 < |z|, the final value of xk is, Options are ⇒ (A) 0, (B) 1, (C) ∞, (D) 2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < \|z\|, the final value of x_k is
A.	0 [Wrong Answer]
B.	1 [Correct Answer]
C.	∞ [Wrong Answer]
D.	2 [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Microprocessor 8085 has facility of interrupt control.

Reason (R): TRAP, RST 7.5, RST 6.5, RST 5.5 and 1NTR are interrupt signals in 8085.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ For very low frequencies, v₀/v_i in the given figure eq
1
0
∞
0.5

⇒

Assertion (A): The gate current of an SCR is always in the form of pulses.

Reason (R): The gate losses, in pulse triggering, are low.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled, then the voltage across each resistor is
half
doubled
increase by 4 times
no change

⇒ Which of the following is a circularly polarized antenna?
Rhombic
Circular loop
Helical
Yagi

⇒ Figure repres
Integrator
Differentiator
High Pass Filter
Band Pass Filter

⇒ In a BJT amplifier the power gain from base to collector is 4000. The power gain in dB is
3.6
36
7.2
72

⇒ Consider the following:

A TV receiver antenna should pick up the TV signal and develop maximum voltage from the available strength of signal
It should reject unwanted signals
It should not suffer from co-channel interference
It should have a very narrowband

The correct statements are
1 and 2 only
1, 2 and 3 only
1, 2, 3, 4
2, 3 only

⇒

Match the following:

	Microwave Measuring Instruments		Measurements Effected
A.	Bolometer	1.	Reflection coefficients
B.	VSWR meter	2.	Half power beam widths
C.	Cavity wave meter	3.	Microwave power
D.	Pattern recorder	4.	Microwave frequency

A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2

⇒

Assertion (A): A video monitor does not need RF tuner and IF amplifier

Reason (R): The picture tube in TV is basically a CRT.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In p type semiconductor, the hole concentration
is nearly equal to density of acceptor atoms
is much greater than density of acceptor atoms
is much less than density of acceptor atoms
may be equal to or more or less than density of acceptor atoms

⇒ Using the same flip flops
a synchronous flip flop can operate at higher frequency than ripple counter
a ripple counter can operate at higher frequency than synchronous counter
both ripple and synchronous counter can operate at the same frequency
can not determine

⇒ Frequency range for satellite communication is
1 kHz to 100 kHz
100 kHz to 10 MHz
10 MHz to 100 MHz
1 GHz to 30 GHz

⇒ The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded
The diode is a silicon diode
The diode is a germanium diode
Break down voltage of the diode is 0.7 V
At 1 V rated current will pass through the diode

⇒ Which of the following can be accessed only sequentially?
Floppy disk
Hard disk
Magnetic tape
ROM

⇒ The depletion layer consists of immobile ions.
TRUE
FALSE

⇒ For real and odd signals, the Fourier series coefficient a_n is
purely imaginary
purely real and even
purely imaginary and odd
purely real and odd

⇒ In which frequency range is the noise figure in a transistor minimum
intermediate frequencies
low frequencies
high frequencies
very high frequencies

⇒ In order to rectify sinusoidal signals of millivolt range (< 0.6 V)
bridge rectifier using diodes can be employed
full wave diode rectifier can be used
a diode is to be inserted in the feedback loop of an op-amp
a diode is to be inserted in the I/P of an op-amp

⇒ ABCD + AB C D =
ABC
ABCD
A B D
ABCD

⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒ In 8085
P flag is set when the result has even parity
P flag is set when the result has odd parity
P flag is reset when the result has odd parity
P flag is reset when the result has even parity

⇒ For the floating point numbers 1.81 x 10^-29 and 0.0152 x 10¹⁸ the normalised forms are
0.181 x 10^-28 and 0.152 x 10¹⁷respectively
18.1 x 10^-30 and 0.152 x 10¹⁷ respectively
0.181 x 10^-28 and 1.52 x 10¹⁶ respectively
None of the above

⇒ In thermal ohm's law, temperature and power loss are analogous to
V and I respectively of ohm's law
I and V respectively of ohm's law
R and V respectively of ohm's law
I and R respectively of ohm's law

⇒ The AM, PM, and TV broadcast frequencies are
of the same order as microwave range
much lower than microwave range
much higher than microwave range
either (a) or (c)

⇒ 8255 A is a
programmable peripheral interface
I/O device
memory chip
none of the above

⇒

Match the following:

	List I		List II
A.	R_T	1.	A = D
B.	R_h	2.	h₁₂ = h₂₁
C.	S_T	3.	AD - BC = 1
D.	S_h	4.	h₂₁ = - h₂₁
		5.	B = C
		6.	Δh = 1

A-3, B-4, C-1, D-6
A-3, B-2, C-5, D-4
A-5, B-4, C-1, D-2
A-5, B-4, C-1, D-6

⇒ Nichrome is commonly used for
lamp filaments
transformer winding
heater coils
battery connections

⇒ What can be the maximum dimension of an array in C language program?
3
4
5
It is compiler dependent

⇒ In pulse code modulation when the maximum frequency in the signal is f_max the bandwidth required will be
≤ p.f_max
≥ p.f_max
≤ (p.f_max)²
≥ (p.f_max)²