Question is ⇒ Light dependent resistor is, Options are ⇒ (A) photo resistive device, (B) photo voltaic device, (C) photo emissive device, (D) either (a) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ Light dependent resistor is, Options are ⇒ (A) photo resistive device, (B) photo voltaic device, (C) photo emissive device, (D) either (a) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Light dependent resistor is
A.	photo resistive device [Correct Answer]
B.	photo voltaic device [Wrong Answer]
C.	photo emissive device [Wrong Answer]
D.	either (a) or (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit of figure the current through 5 Ω resistance at t = &infin
0.166666666666667
2.5 A
3.1 A
0

⇒ Which of the following diode is designed to operate in the breakdown region?
Signal diode
Power diode
Zener diode
None of the above

⇒ Satellite communication systems use the frequency band
10 to 20 MHz
50 to 70 MHz
3 to 6 GHz
100 to 120 GHz

⇒ The switch board instruments
should be mounted in vertical position
should be mounted in horizontal position
should be mounted at about 45°
should be mounted at about 80°

⇒ The order of the differential equa
1
2
3
4

⇒ Parallel wire transmission line is an example of
lumped network
distributed
depend upon I/P signal strength
power I/P

⇒ In a two stage cascade amplifier, each stage has a gain of 10 dB and noise figure of 10 dB. The overall noise factor is
10
1.09
1
10.9

⇒ To produce p type semiconductor we add
acceptor atoms
donor atoms
pentavalent impurity
trivalent impurity

⇒ In figure the rms valu
5
2.5
2.5
50

⇒ The frequencies in ultra high frequency range are propagated by means of __________ waves
surface
ground
sky
space

⇒ Pulse stuffing is used in
synchronous TDM
asynchronous TDM
Any TDM
All

⇒ Figure shows basic Hartley oscillator configuration. Do you think the polarities marked for the split coiled are corr
yes they are
no they are not
it really doesn't matter
none of the above

⇒ In the given figure, of potentiometer V₀ = V_i (R₀/R_i) only
R_L = 0
R_L = ∞
R_L is neither low nor high
R_L is low but not zero

⇒ What is the chemical bonding in silicon semiconductor?
Metallic
Ionic
Covalent
van der Waals

⇒ Compared to a p-n junction with N_A = N_D = 10¹⁴/cm³, which one of the following statements is TRUE for a p-n junction with N_A = N_D = 10²⁰/cm³?
Reverse breakdown voltage is lower and depletion capacitance is lower
Reverse breakdown voltage is higher and depletion capacitance is lower
Reverse breakdown voltage is lower and depletion capacitance is higher
Reverse breakdown voltage is higher and depletion capacitance is higher

⇒ Which of the following antennas is λ /4 length?
Dipole
Marconi
Monopole
Parabolic

⇒ A TV. transmitting aerial is fixed on top of a 150 metre tower located on a mountain 1200 m height. The range of transmitter is
51 km
152 km
152 m
51 m

⇒ Which of the following is an indirect method of generating FM?
Reactance BJT modulator
Armstrong modulation
Varactor diode modulation
Reactive FM modulator

⇒ Microwave signals transmitted towards the sky are
strongly absorbed by the ionosphere
strongly reflected by the ionosphere
transmitted through the ionosphere
unable to reach the ionosphere because of strong absorption in the lower atmosphere

⇒ In FM and AM the ratio of signal to noise ratio at the detector output least depends upon
bandwidth
transmission
carrier frequency
modulating frequency

⇒ Four MSI TTL 4-bit ripple counters are cascaded to form a 16-bit binary counter. Its propagation delay is about __________ nanoseconds.
70
140
210
280

⇒ The output voltage waveform of a CE amplifier is fed to a dc coupled CRO. The trace on the screen will be
dc output voltage
ac output voltage
sum of dc and ac output voltage
either (a) or (b)

⇒ A thermocouple instrument can be used over a very wide frequency range.
TRUE
FALSE

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ Which of the following is not a valid real constant?
-73.1
10251,3
10.23
-5.7381

⇒ The code used to reduce the error due to ambiguity in reading of a binary optical encoder is
Octal code
Excess-3 code
gray code
BCD code

⇒ Thyristors are suitable for dc circuit breakers but not for ac circuit breakers.
TRUE
FALSE

⇒ The simplest standing wave is due to the value of reflection co-efficient is
-1
zero
unity
infinity

⇒ 8085 data bus has 8 lines and is bidirectional.
TRUE
FALSE

⇒ Figure represen
Varactor
LED
Zener diode
Temperature dependent diode