Question is ⇒ Typical values of voltage gain for CE, CB and CC amplifiers are, Options are ⇒ (A) 100, 100 and 1 respectively, (B) 100, 1 and 100 respectively, (C) 100, 1 and 1 respectively, (D) 1, 100 and 100 respectively, (E) , Leave your comments or Download question paper.

Question is ⇒ Typical values of voltage gain for CE, CB and CC amplifiers are, Options are ⇒ (A) 100, 100 and 1 respectively, (B) 100, 1 and 100 respectively, (C) 100, 1 and 1 respectively, (D) 1, 100 and 100 respectively, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Typical values of voltage gain for CE, CB and CC amplifiers are
A.	100, 100 and 1 respectively [Correct Answer]
B.	100, 1 and 100 respectively [Wrong Answer]
C.	100, 1 and 1 respectively [Wrong Answer]
D.	1, 100 and 100 respectively [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Wheatstone bridge is suitable for low resistances.
TRUE
FALSE

⇒ A universal register
accepts serial input
accepts Parallel input
gives serial and Parallel output
all of the above

⇒ In an integral controller
the output is proportional to input
the rate of change of output is proportional to input
the output is proportional to rate of change of input
none of the above

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ 'Rotate instruction' in microprocessor belongs to
data transfer group
arithmetic group
logic group
branch group

⇒ Figure shows the feedback network of one of the very popular types of sinusoidal oscillators. Which one is t
Weinbridge oscillator
Hartley oscillator
Colpitt's oscillator
R-C phase shift oscillator

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Developed by)
A.	CCD charger	1.	Toshiba
B.	New vicon	2.	Philips
C.	Plumbicon	3.	Matushita
D.	Chalnicon	4.	RCA

A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1
A-4, B-3, C-1, D-2
A-1, B-2, C-3, D-4

⇒ A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low pass filter with cut off frequency 800 Hz. The output signal has the frequency.
0 Hz
0.75 kHz
0.5 kHz
0.25 kHz

⇒ In the balanced bridge shown in figure. X should
a self inductance having resistance
a capacitance
a non-inductive resistance
an inductance and capacitance in parallel

⇒ For a series R-L-C circuit tuned at resonant frequency which of the following statements is correct?
The voltage across inductance is greater than applied voltage
The voltage across capacitance is greater than applied voltage
The voltage across both inductance and capacitance is greater than applied voltage
The voltage across both inductance and capacitance is less than applied voltage

⇒ The mass of an electron is nearly
9.1 x 10^-27 kg
9.1 x 10^-29 kg
9.1 x 10^-31 kg
9.1 x 10^-35 kg

⇒ In a pulsed RADAR typical value of pulse duration and pulse frequency respectively are
1 μs and 50 Hz
1 μs and 500 Hz
4 μs and 50 Hz
4 μs and 500 Hz

⇒ In the above circuit, if the power dissipated in the 6 Ω resistor is zero then
20 2∠ 45°
20 ∠ 30°
20 ∠ 45°
20 2∠ 30°

⇒ In Java 31% gives an answer
3
4
42798
42828

⇒

Match the following:

	List I (Characteristics)		List II (Device)
A.	Voltage controlled device	1.	BJT
B.	Current controlled device	2.	UJT
C.	Conductivity modulation device	3.	FET
D.	Negative conductance device	4.	Impatt diode

A-2, B-3, C-1, D-1
A-2, B-3, C-4, D-1
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be
opaque to visible light
transparent to visible light
transparent to ultraviolet radiation
transparent to infrared radiation

⇒ The number of noise sources in a BJT are
3
2
1
4

⇒ In a single phase half wave converter feeding resistive load and full wave converter (M - 2 connection) feeding a resistive load the circuit conditions are similar. The firing angle is a. Then the waveshapes of voltages across thyristors
are similar
are not similar
may be similar or dissimilar
are similar only for some values of a

⇒ Magnetic flux density has the dimensions
MI^-1T^-2
M^-1I^-2T^-2
ML^-3T^-2
MI^-1T^-3

⇒ The dimensions of EMF are
ML²I^-1T^-3
M^-1T^-3
ML²I^-2T^-3
ML³I^-1T^-3

⇒ The three sides of an admittance triangle denote
G, B, Y
R, X, Y
G, B, Z
(R, Y, Z) or (R, X, Z)

⇒ A photo diode is
forward biased
reverse biased
either forward or reverse biased
unbiased

⇒ The device most likely to be found in an SSB transmitter is
class C audio amplifier
tuned modulator
class B RF amplifier
class A RF amplifier

⇒ Microprocessor 386SX is a 16/32 bit microprocessor. It has
16 bit registers and 32 bit data bus
16 bit registers and 16 bit data bus
32 bit registers and 32 bit data bus
32 bit register and 16 bit data bus

⇒ At room temperature, the current in the, intrinsic semiconductor is due to
holes
electrons
ions
holes and electrons

⇒

Assertion (A): A DIAC has four layers but only two terminals.

Reason (R): A DIAC can conduct in both directions.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ AM amplifier having noise figure of 20 dB and available power gain of 15 dB is followed by a mixer circuit having noise figure of 9 dB. The overall noise figure as referred to input in dB is
10.44
11.07
21.52
0.63

⇒ In a rectifier only a portion of input power is converted into DC power. The rest is AC power.
TRUE
FALSE

⇒ In FORTRAN 77 the total number of characters in a variable can be a maximum of
6
1
8
9

⇒ In common base amplifier the current gain is less than one, but the voltage gain may be anywhere from
0.5 to 1
1 to 5
5 to 10
50 to 2000