Question is ⇒ Find I for circuit shown b, Options are ⇒ (A) 0.125, (B) 0.0416666666666667, (C) 0.0833333333333333, (D) 0, (E) , Leave your comments or Download question paper.

Question is ⇒ Find I for circuit shown b, Options are ⇒ (A) 0.125, (B) 0.0416666666666667, (C) 0.0833333333333333, (D) 0, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Find I for circuit shown b
A.	0.125 [Wrong Answer]
B.	0.0416666666666667 [Wrong Answer]
C.	0.0833333333333333 [Correct Answer]
D.	0 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure shows a parallel resonant circuit having resonance frequency of 15 MHZ. At this frequ
its impedance is minimum
its impedance is maximum
its impedance is infinite
its impedance is zero

⇒ Dolby system of noise reduction divides the total audio spectrum into
8 frequency bands
4 frequency bands
2 frequency bands
none of the above

⇒ In the network of figure it is desired that maximum power be supplied to Z₂. The values of Z₁ and Z₂ are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfe
|Z₂|/|Z₁|
[|Z₂|/|Z₁|]^0.5
[|Z₂|/|Z₁|]²
[|Z₂|/|Z₁|]^0.75

⇒ The circuit in figure, the switched on at t = 0. After a long time the current through 5 Ω resistanc
0.0416666666666667
0.166666666666667
0.416666666666667
0

⇒ In its lowest state, the electron is bound to the field of proton by an energy equal to
100.5 eV
51.2 eV
13.6 eV
0.2 eV

⇒ The gate width of a monostable multivibrator is given by
T = 1.1 RC
T = 0.693 RC
0.963 RC
T = 0.369 RC

⇒ For H(s) to be positive real, the condition Re[H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞ is
a necessary condition
a sufficient condition
a necessary and sufficient condition
is not a necessary condition

⇒ At room temperature, a possible value for the mobility of electrons in the inversion layer of a silicon n-channel MOSFET is
450 cm²/V-s
1350 cm²/V-s
1800 cm²/V-s
3600 cm²/V-s

⇒ The v-i characteristics of a FET is shown in figure. In which region is the device biased for small signal amplifica
AB
BC
CD
BD

⇒ If B, H and M denote flux density, field intensity and magnetisation, B = μ₀ (H + M).
TRUE
FALSE

⇒ A chopper
converts constant voltage dc into ac and then into variable voltage dc
converts constant voltage dc into variable voltage dc directly
converts ac of one frequency into ac of another frequency
converts ac to dc

⇒ If the characteristic equation is (λ + 1) (λ + 2) (λ + 3) = 0, the eigen values are
-1, -2, -3
1, 2, 3
0, 1, 2
0, 2, 3

⇒ Which of the following number specification refers to FET with one gate?
2N
3N
3Y
3X

⇒

Assertion (A): Germanium is more commonly used than silicon.

Reason (R): Forbidden gap in germanium is less than that in silicon.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): For a physically realisable driving point function, the degree of numerator and denominator should be equal.

Reason (R): The sum of positive real functions is real.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following microphones has bidirectional feature?
Moving coil
Ribbon
Condenser
Carbon

⇒ The dual of a link is
twig
node
loop
tree branch

⇒ A Wien bridge oscillator uses
negative feedback
positive feedback
both negative and positive feedback
none of the above

⇒ The number of electrons in motion at the instant of positive peak of a symmetrical ac wave is the same as that at the instant of negative peak.
TRUE
FALSE

⇒ Which multivibrator can be used as a clock timer?
Astable multivibrator
Bistable multivibrator
Any of the above
None of the above

⇒ (62)₁₀ in binary system is
110000
111100
111110
111111

⇒ Ohm's law is valid for
dc voltage and current
ac voltage and current
all voltages and current
dc and ac voltages and currents

⇒ At corner frequency the phase angle of factor 1/(1 + jωT) is
+90°
-90°
+45°
-45°

⇒ One input terminal of high gain comparator circuit is connected to ground and a sinusoidal voltage is applied to the other input. The output of comparator will be
sinusoidal
full rectified sinusoidal
half rectified sinusoidal
square wave

⇒ When negative feedback is used the fractional changes in closed loop gain are desensitized by the factor (1 + A_vβ)
TRUE
FALSE

⇒ Modulation is also called detection.
TRUE
FALSE

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?
1002 kHz
1000 kHz
999.2 kHz
998.0 kHz

⇒ The standard FORTRAN exponential form of decimal number - 0.000000023 is
2.3 E - 8
-2.3 E - 8
2.3 E - 7
-2.3 E - 7

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]

⇒ The approximate value of input impedance of CE amplifier with emitter resistance R_E is given by
h_ie + A_i R_E
h_ie + (1 + h_fe) R_E
h_ie
(1 + h_fe) R_E