Question is ⇒ A bipolar transistor is a __________ controlled devices whereas a FET is a __________ controlled devices., Options are ⇒ (A) current, voltage, (B) current, current, (C) voltage, current, (D) voltage, voltage, (E) , Leave your comments or Download question paper.

Question is ⇒ A bipolar transistor is a __________ controlled devices whereas a FET is a __________ controlled devices., Options are ⇒ (A) current, voltage, (B) current, current, (C) voltage, current, (D) voltage, voltage, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A bipolar transistor is a __________ controlled devices whereas a FET is a __________ controlled devices.
A.	current, voltage [Correct Answer]
B.	current, current [Wrong Answer]
C.	voltage, current [Wrong Answer]
D.	voltage, voltage [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the given figure, the flip flop
negative edge triggered
positive edge triggered
level triggered
either (a) or (c)

⇒ The tuned circuit of the oscillator in a simple AM transmitter employs a 50 H coil and a 1 nanofarad capacitor. If the oscillator output is the carrier frequency will be
448 kHz
555 kHz
625 kHz
712 kHz

⇒ Which one is a causal system?
y(n) = 3x[n] - 2x[n - 1]
y(n) = 3x[n] + 2x[n + 1]
y(n) = 3x[n + 1] + 2x[n - 1]
y(n) = 3x[n + 1] 2x[n - 1] + x[n]

⇒ What is an advantage of an electronic voltmeter over a non-electronic voltmeter?
Low power consumption
Low input impedance
The ability to measure wide ranges of voltages and resistance
Large portability

⇒ The noise figure of multicavity klystron amplifier is very low
TRUE
FALSE

⇒ The equation v(t) = A cos [ω_ct + φ(t)] where A and ω_c are constant and φ(t) is a function of base signal represents

Phase modulation
Amplitude modulation
Angle modulation
Frequency modulation

Which of the above are true?
3 only
1, 3 and 4
1, 2, 3, 4
3 and 4 only

⇒ A sample of N type semiconductor has electron density of 6.25 x 10⁸/cm² at 300 K. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density works out to be
10⁶/cm³
10⁸/cm³
10¹⁰/cm³
10^l2/cm³

⇒ Regarding TASI which one of the following statements is wrong?
It snatches the channel in his speech and may allocate it to another speaker needing it.
The same speaker is reassigned a channel almost instantly when he speaks again even when the circuit is heavily loaded.
It increases the overall utilization of the transmission channel
Intercontinental callers sometimes confuse the effects of TASI with the effects of satellite delay.

⇒ Two coils X of 1000 turns and Y of 2000 turns are placed such that 60% of the flux produced by coil X links coil Y. A current of 1 A in coil X produces 0.1 wb flux. The mutual inductance between coils is
0.12 H
0.08 H
0.06 H
0.04 H

⇒ In a series RLC circuit excited by e = E_m sin ωt is seen that LC < 1/ω². Then
I lags E
I leads E
I leads E are in phase
voltage across L and C are equal

⇒ In the circuit, the value of the voltage source
-22 V
-12 V
+12 V
-10 V

⇒ The bridge is balanced when the value of R is
50 Ω
100 Ω
200 Ω
250 Ω

⇒ An electron when placed midway between two equal and opposite charges will
remain stationary
oscillate between the charges
be thrown out of the field
spin in the field

⇒ Which part of radio spectrum is more crowded?
Lower frequency part
Higher frequency part
Both (a) and (b)
None of these

⇒ In standard TTL, the 'totem pole' stage refers to
the multi-emitter I/P stage
phase splitter
the O/P buffer
open collector O/P stage

⇒ Computers 'Basic input output system' is generally stored in RAM chips.
TRUE
FALSE

⇒ Rank of the matr
3
2
1
4

⇒ Low gain-bandwidth product of a JFET is due to
reduced number of holes
junction capacitive effects
low degree of isolation between input and output
all of the above

⇒ Lead mounting for SCR is used for
rating less than mA
rating about 1 A or less
rating of 20 A or less than 20 A
rating 100 A or less

⇒ In figure, the power dissipated in 4 resistance is P₁ and power associated with 3 A source is P₂.
P₁ = P₂
P₁ < P₂
P₁ > P₂
P₁ may be equal or less than P₂

⇒ What is the gray code word for EX-OR the binary number 101011?
101011
110101
111110
11111

⇒ Cache memory size is about
a few KB
about 500 KB
about 1 MB
about 50 MB

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in backward direction. A moving coil ammeter is also connected in the circuit. The reading of ammeter will be
0.416666666666667
0.208333333333333
3.185 A
14.14 A

⇒ A dielectric is subjected to alternating field. The dielectric losses are potential to
real part of dielectric constant
imaginary part of dielectric constant
both real and imaginary parts of dielectric constant
either real or imaginary part of dielectric constant

⇒ Which of the following equations satisfy Maxwell's equations?
E_x = E_y = 0, E_z = cos (y - ct)
E_x = E_y = 0, E_z = cos (y- ct)
F_y = cos (y - ct), E_x = E_z = 0
None of these

⇒ For an insulating material, dielectric strength and dielectric loss should be respectively
high and high
low and high
high and low
low and low

⇒ An excitation is applied to a system at t = T, and its response is zero for -∞ < t < T, such a system is
non-causal system
Stable system
causal system
unstable system

⇒ Divergence of curl A is
∇ . (∇ x A) = 1
∇ . (∇ x A) = 0
∇ . (∇ x A) = ∇
∇ . (∇ x A) = - ∞

⇒ Some typical examples of macroscopic quantities are
conductivity
µ_r
dielectric constant
all of the above

⇒ A semiconductor Read-only-Memory basically is
a combinational logic circuit
a set of flip-flop memory elements
a sequential circuit with flip-flops and gates
none of the above