Question is ⇒ An 8 bit binary number is to be entered into an 8 bit serial shift register. The number of clock pulses required is, Options are ⇒ (A) 1, (B) 2, (C) 4, (D) 8, (E) , Leave your comments or Download question paper.

Question is ⇒ An 8 bit binary number is to be entered into an 8 bit serial shift register. The number of clock pulses required is, Options are ⇒ (A) 1, (B) 2, (C) 4, (D) 8, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An 8 bit binary number is to be entered into an 8 bit serial shift register. The number of clock pulses required is
A.	1 [Wrong Answer]
B.	2 [Wrong Answer]
C.	4 [Wrong Answer]
D.	8 [Correct Answer]
View Answer 6 -6 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Different symbols are used for different gates

Reason (R): IEEE symbols are the same as traditional symbols for gates.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In an inverting amplifier using op-amp the current input to the inverting terminal
is equal to the current through feedback resistance
is less than the current through feedback resistance
is more than the current through feedback resistance
may be equal to, less or more than current through feedback resistance

⇒ A Read/Write memory chip has a capacity of 64 k bytes. Assuming separate data and address line and availability of chip enable signal, what is the minimum number of pins required in the IC chip?
28
26
24
22

⇒ Consider the following rules in Fortran

A signed or unsigned real variable name or a real constant is a real expression.
Two real expressions connected by an arithmetic operator is a real expression.
A real variable or constant exponential by an integer constant or integer variable is not valid

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The density of states (i.e. number of states per eV per m³) in the conduction band for energy level E is proportional to
E
E
E^1.5
E²

⇒

Assertion (A): Decoder is not a combinational circuit.

Reason (R): Every memory element of semi conductor form has a decoder.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A/D parallel converter is also called flash converter.
TRUE
FALSE

⇒ Thermistors are made of
pure metals
pure insulators
tintered mixture of metallic oxides
pure semiconductors

⇒ The circuit show
voltage series feedback amplifier
transconductance amplifier
transresistance amplifier with open circuit mutual resistance R_F
transresistance amplifier with short circuit mutual resistance R_F

⇒ An electron in a homogeneous magnetic field and having velocity perpendicular to the direction of field moves
perpendicular to the field
along the field
along a straight line inclined at 45° to field
in a circular path

⇒ In a bipolar transistor, the base collector junction has
forward bias
reverse bias
zero bias
zero or forward bias

⇒ The electric energy required to raise the temperature of a given amount of water is 1000 kWh. If heat losses are 25%, the total heating energy required is __________ kWh.
1500
1250
1333
1000

⇒ In a clocked NAND latch, race condition occur when
R and S are high CLK is low
R and CLK are high and S is low
R, S, CLK are high
R, S, CLK are low

⇒ The ability of a radio receiver to discriminate between different input signals and to accept only one definite signal is called its
sensitivity
attenuation
selectivity
modulation

⇒ A binary adder has
one half adder
one half adder and 2 full adders
two half adders
one half adder and many full adders

⇒ The phase angle of a lag circuit is
between 0 and -90°
between 0 and +90°
90°
more than 90°

⇒

Assertion (A): Water waves are longitudinal but EM waves are transverse

Reason (R): In an EM wave electric field, magnetic field and propagation are mutually perpendicular.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The power dissipated in 4 Ω resistance in figur
64 W
32 W
16 W
8 W

⇒ The number of computer viruses is some thousands.
TRUE
FALSE

⇒ Which of the following circuits come under the class of sequential logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 and 2
1, 2 and 3
3 and 4
4 and 5

⇒ A pulse function can be represented as difference of two equal step functions.
TRUE
FALSE

⇒ Which of the following elements act as donor impurities?

Gold
Phosphorus
Boron
Antimony
Arsenic
Indium

Select the correct answer using the codes given below:
1, 2, 3
1, 2, 4, 6
3, 4, 5, 6
1, 4, 5

⇒ Which amplifier has the higher power gain?
Common emitter
Common collector
Common base
Both CC and CE

⇒ In a modem digital computer, a subtractor in normally not used because
subtractors are very expensive
the design of a subtractor is very complex
the adder is geared for doing subtraction
most of the programs do not require subtraction

⇒ An m derived low pass filter has f_c = 1000 Hz and m = 0.6. This filter will have infinite attenuation at
f = 1250 Hz
all frequencies above 1000 Hz
f = 1562.5 Hz
f = 1666.67 Hz

⇒ A piezoelectric force transducer has a charge sensitivity of 20 pC/N. It is connected to a charge amplifier and overall gain of transducer and amplifier is 50 mV/N. The gain of amplifier is
1 mV/pC
1.5 mV/pC
2.5 mV/pC
4 mV/pC

⇒ In a transistor β_dc is likely to vary between 100 and 400. The proper value of β_dc to be used to located Q point is
100
400
250
200

⇒ In a series R-L circuit when excited by a 1 volt battery the current is 1 - e^-t. If it is excited by a source 2 sin t, the current will be
2 sin (t - 45°) + e^-t
2 sin (t + 45°) + e^-t
sin (t - 45°) + e^-t
sin (t + 45°) + e^-t

⇒ A chopper is a high efficiency circuit.
TRUE
FALSE

⇒

Assertion (A): Atomic number of sodium is 11.

Reason (R): Sodium has a body centred cubic lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true