Question is ⇒ The resistance of a standard conductor., Options are ⇒ (A) increases with frequency, (B) same for ac and dc, (C) increases with frequency, (D) increases as square root of frequency, (E) , Leave your comments or Download question paper.

Question is ⇒ The resistance of a standard conductor., Options are ⇒ (A) increases with frequency, (B) same for ac and dc, (C) increases with frequency, (D) increases as square root of frequency, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The resistance of a standard conductor.
A.	increases with frequency [Wrong Answer]
B.	same for ac and dc [Wrong Answer]
C.	increases with frequency [Wrong Answer]
D.	increases as square root of frequency [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the time domain response shown in figure the
lies in left half plane
lies on imaginary axis
lies along the positive real axis
may be complex or imaginary

⇒ A function of one of more variables which conveys information on the nature of physical phenomenon is called
Noise
Interference
System
Signal

⇒ At resonance, the parallel circuit constituted by an iron-cored coil and a capacitor behaves
open circuit
short circuit
pure resistor of value R
pure resistor of value much higher than R

⇒ The word 'LORAN' means
long range navigation
long range TV transmission
long range cable transmission
either (b) or (c)

⇒ Internet is a worldwide network of computers where most of the information is freely available.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	loop antenna	1.	flat line
B.	folded dipole	2.	300 W
C.	SWR of 1	3.	sharp broadside full
D.	VHF band	4.	30 to 300 MHz

A-1, B-4, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ In floating point representation the number of bits in exponent is
8
7
6
5

⇒ Sometimes the rotating devices in a room having fluorescent lamps appear to be any station. This is due to
defect in the lamp
low voltage
high voltage
stroboscopic effect

⇒ A loudspeaker transformer has a turns ratio of 20 : 1. The speaker impedance is 20Ω. Primary impedance of transformer is
10 K
8 K
20 K
0.5 K

⇒ What is the direction of address
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into up and some others out of μp

⇒ In digital computer programming, subroutines are used
to reduce program execution time at the expense of more memory
to reduce storage requirements
to increase programming ease and reduce storage requirements
because most of the functions are same

⇒ Which of the following constitutes an active component?
Semiconductor device
Resistors
Capacitors
Inductors

⇒ Which of the following is also called handshaking programmed data transfer?
Synchronous transfer
Asynchronous transfer
Interrupt driver transfer
Both (a) and (c)

⇒ An SR flip flop can be built using NOR gates or NAND gates.
TRUE
FALSE

⇒ In a 3 input NAND gate, the number of states in which output is 1 equals
8
1
6
5

⇒ Peak inverse voltage will be highest for
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ If R(t) is autocorrelation of a waveform v(t) and R(0) is autocorrelation for t = 0, then
R(0) > R(t)
R(0) ≥ R(t)
R(0) < R(t)
R(0) ≤ R(t)

⇒ The scaling factor of an MOS device using constant voltage scaling model, the gate area of the device will be scaled as
1/a
1/a²
1/a³
1/a⁴

⇒ The addition of a pole to the open loop transfer function pulls the root locus
to the right
to the left and making the system more stable
towards right or left depending on the position of new pole
none of the above

⇒ In which of these does thermionic emission occur?
LED
LCD
VF display
None

⇒ The access time of a word in 4 MB main memory is 100 ms. The access time of a word in a 32 kb data cache memory is 10 ns. The average data cache bit ratio is 0.95. The efficiency of memory access time is
9.5 ns
14.5 ns
20 ns
95 ns

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒

Assertion (A): Stubs, directional couplers and baluns are very commonly used in communication systems

Reason (R): Characteristic impedance of a line is an important parameter.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the following features:

negative operands cannot be used
when immediate operand changes, the program should be reassembled
the program is difficult to read
the size of operand is restricted by word length of the computer

Disadvantages of immediate addressing include
1 and 2
2 and 4
2 and 3
1 and 4

⇒ In a CRO the Y plates are oriented
horizontally
vertically
at an angle of 20° of horizontal
at an angle of 70° of horizontal

⇒

Assertion (A): A universal RLC bridge has a battery and also a high frequency ac source.

Reason (R): RLC bridge uses a Wienbridge arrangement for measuring capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following input is not possible in case of a SR flip-flop?
S = 0, R = 0
S = 0, R = 1
S = 1, R = 0
S = 1, R = 1

⇒ In a homogeneous magnetic field H of a solenoid, the core carries a magnetic dipole moment M per unit volume equal to
μ₀ H
μ_r H
(μ_r - 1) H
μ_oμ_r H

⇒ A full wave diode rectifier using centre tapped transformer has diodes with forward resistance of 50 ohms each. The load resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulation is
0.2
0.5
1
2

⇒ With regard to a transmission line, which of the following statements is correct?
Any impedance repeats itself every 1/4 on the Smith chart.
The S.W.R. = 2 circle and the magnitude of reflection coefficient = 0.5 circle coincide on the Smith chart.
At any point on a transmission line, the current reflection coefficient is the reciprocal of the voltage reflection coefficient.
Matching eliminates the reflected wave between the source and the matching device location.