Question is ⇒ A minimum function has, Options are ⇒ (A) poles and zeros on imaginary axis of s plane, (B) no poles or zeros on imaginary axis of s plane, (C) only poles but no zeros on imaginary axis of s plane, (D) only zeros but no poles on imaginary axis of s plane, (E) , Leave your comments or Download question paper.

Question is ⇒ A minimum function has, Options are ⇒ (A) poles and zeros on imaginary axis of s plane, (B) no poles or zeros on imaginary axis of s plane, (C) only poles but no zeros on imaginary axis of s plane, (D) only zeros but no poles on imaginary axis of s plane, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A minimum function has
A.	poles and zeros on imaginary axis of s plane [Wrong Answer]
B.	no poles or zeros on imaginary axis of s plane [Wrong Answer]
C.	only poles but no zeros on imaginary axis of s plane [Correct Answer]
D.	only zeros but no poles on imaginary axis of s plane [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements about transport-lag

It is of non-minimum phase behaviour
It normally exists in thermal, hydraulic and pneumatic systems
It has an excessive phase lag with no attenuation at high frequency

Which of the above statements are correct?
1 only
1 and 2
All
2 and 3

⇒ When a magnetic circuit is compared with an electric circuit, the equivalent of the magnetic flux is
the conductivity of the lines
the voltage of the source
the current in the lines
the conductance of the load

⇒

Assertion (A): Megger is used to check insulation resistance of cables.

Reason (R): Insulation resistance of cables is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In the 8421 BCD code, the decimal number 125, is written as
1111101
0001 0010 0101
7 D
none of these

⇒ Class A and class B chopper
operate in first quadrant
operate in second quadrant
class A chopper operates in first quadrant while class B operates in second quadrant
may operate in either first or second quadrant

⇒ Which one of the following materials is used for making permanent magnets?
Steel
Carbon
Carbon-Steel
Graphite

⇒ Consider the common emitter amplifier shown below with the following circuit parameters: β = 100, g_m = 0.3861 A/V, r₀ = ∞ r_p = 259 Ω, R_s = 1 kΩ, R_B = 93 kΩ, R_C = 250 Ω, R_L = 1 kW, C₁ = ∞ and C₂ = 4.
33.9 Hz
27.1 Hz
13.6 Hz
16.9 Hz

⇒ Typical size of digital IC is about
1″ x 1″
2″ x 2″
0.1″ x 0.1″
0.001″ x 0.001″

⇒ In 8085, the instruction CMA is an example of
Implict addressing
Direct addressing
Register addressing
Immediate addressing

⇒ RS latch can be built with
NOR gates
NAND gates
NOR or NAND gates
none of the above

⇒ In Weston synchronoscope the fixed coils are connected across
bus bars
incoming alternator
lamp
either (a) or (b)

⇒ What is the RF amplifier plate voltage when the audio-modulating voltage is +600
-600 V
Zero
600 V
1200 V

⇒ If 137 + 276 = 435 how much is 731 + 672?
534
1403
1623
1513

⇒

Match the following:

	List I		List II
A.	loop antenna	1.	flat line
B.	folded dipole	2.	300 W
C.	SWR of 1	3.	sharp broadside full
D.	VHF band	4.	30 to 300 MHz

A-1, B-4, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ Find the output voltage for 011100 in a 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V.
6.4 V
2.84 V
0.1 V
8 V

⇒ A register is
a group is memories
a group of devices that store digital data
a chip used in computers
a pure silica piece used in digital systems

⇒ To measure moisture in wood, the most suitable method is
electric conduction
electrical-capacitive
absorption of radiation
equilibrium-moisture Vs humidity

⇒ The colour subcarrier and sidebands produced by its modulation with the chrominance signals are accommodated in the standard channel width by the process of
frequency adjustment
frequency interleaving
frequency changing
frequency amalgamation

⇒ In figure V_CE (sat) = 0.1 V. Then I_C (sa
10 mA
20 mA
30 mA
40 mA

⇒ A thyristor has its gate current zero. To start conduction the forward voltage must exceed
about 0.5 V
forward breakover voltage
on state voltage
peak working off state forward voltage

⇒ The class of insulation of impregnated paper is
A
B
C
F

⇒ In decimal system the base of radix is
0
1
10
e

⇒ In a transmission line, losses due to dielectric heating are
proportional to voltage and inversely proportional to Z₀
proportional to voltage and proportional to Z₀
proportional to current and proportional to Z₀
proportional to current and inversely proportional to Z₀

⇒ Modelling error may occur due to
neglecting the nonlinear characteristics of plant
inaccuracy of parameters
change of plant characteristics with time
any of the above

⇒ Evaluate the power stored in inductor and capac
25 J, 12.5 J
12.5 J, 25 J
25 J, 50 J
12.5 J, 50 J

⇒ For the given circuit, the current
0.0833333333333333
0.208333333333333
0.291666666666667
0.333333333333333

⇒ In the amplifier circuit of figure h_fe = 100 and h_ie = 1000 Ω. The voltage gain of amplifier is a
0.33
0.5
0.66
1

⇒ ∈_r is determined by the atomic structure of the dielectric.
TRUE
FALSE

⇒ Which of the following is non-sinusoidal oscillator?
Multivibrator
Relaxation oscillator using UJT
Relaxation oscillator using tunnel diode
Any of the above

⇒ The tree selected for the formation of state equations contains
all voltage sources
all capacitors
all inductors and current sources
all voltage sources and maximum number of capacitors