Question is ⇒ The signals in 8086 are classified into, Options are ⇒ (A) minimum mode and maximum mode, (B) decrement mode and increment mode, (C) low mode and high mode, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The signals in 8086 are classified into, Options are ⇒ (A) minimum mode and maximum mode, (B) decrement mode and increment mode, (C) low mode and high mode, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The signals in 8086 are classified into
A.	minimum mode and maximum mode [Correct Answer]
B.	decrement mode and increment mode [Wrong Answer]
C.	low mode and high mode [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Thyristors connected in series need static and dynamic stabilizing circuits.
TRUE
FALSE

⇒ A 256 x 4 EPROM has
8 address pins and 4 data pins
8 address pins and 8 data pins
4 address pins and 8 data pins
4 address pins and 4 data pins

⇒ For matching over a range of frequencies in a transmission line it is best to use
a balun
a broad band directional coupler
double stub
a single stub of adjustable position

⇒ A decoder can be used as a demultiplexer.
TRUE
FALSE

⇒ Which of the following statement is correct?
Pre-emphasis circuits are used in AM transmitters
FM reception is noise free as compared to AM
A limiter state is also used in AM receivers
Discriminator is used for the detection of AM signals

⇒ Which of the following plot can be used to show the input volt-ampere characteristics of a common-emitter configuration?
V_BE versus i_B for constant values of V_CE
V_CE versus i_C for constant values of I_B
V_CE versus i_C for constant values of I_E
None of the above

⇒ The Z parameters Z₁₁ and Z₂₁ for the 2-port network in the fig
Z₁₁ = - 6/₁₁Ω; Z₂₁ = 16/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = 4/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = - 16/₁₁Ω
Z₁₁ = 4/₁₁Ω; Z₂₁ = 4/₁₁Ω

⇒ System satellites orbit the Earth once in
24 hours
12 hours
1 hours
6 hours

⇒ A dc amplifier can operate
at zero frequency
only at low frequency
only at high frequencies
both at low and high frequencies

⇒ Dielectric materials have high specific resistance.
TRUE
FALSE

⇒ The attenuation in waveguides near the cut off frequency is
very low
very high
medium
zero

⇒ If the number of atoms per unit volume of a monoatomic gas changes, the dielectric constant still remains constant.
TRUE
FALSE

⇒ A quantization error is an essential aspect of ADC
TRUE
FALSE

⇒ The ROC of sequence x[n] = (0.8)ⁿ ∪[n] + (0.4)ⁿ ∪[n]
|z| > 0.8
|z| > 0.4
0.4 < |z| < 0.8
|z| < 0.8

⇒ A 1 ms pulse can be stretched to 1 sec pulse by using
an astable multivibrator
a monostable multivibrator
a bistable multivibrator
a Schmitt trigger circuit

⇒ Which of the following is not correct?
In SSB amplitude modulated system, the transmitter circuit has to be more stable leading to better reception
In SSB amplitude modulated system more channel space is available as compared to double sideband amplitude modulated system
In SSB amplitude modulated system the signal is more noise resistant as compared to double sideband system
An SSB-AM system requires lesser power (for the same signal strength) as compared to DSB-AM system

⇒ The minterm designation for ABCD is
m₈
m₁₀
m₁₄
m₁₅

⇒ Consider the following rules in Fortran

A signed or unsigned real variable name or a real constant is a real expression.
Two real expressions connected by an arithmetic operator is a real expression.
A real variable or constant exponential by an integer constant or integer variable is not valid

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The resistance of the circuit shown is figur
5 Ω
More than 6 Ω
More than 4 Ω
Between 6 and 7 Ω

⇒ Consider the following symbols

Letters A to Z and a to z
Digits 0 to 9
Logical operators and, or, not
Parenthesis ( )

Which of the above symbols are available in Pascal?
1 and 2 only
1, 2 and 3 only
1, 2 and 4 only
All

⇒ A moving iron instrument can be used for dc as well as ac.
TRUE
FALSE

⇒ Silicon and germanium are elements in the
second column of periodic table
third column of periodic table
fourth column of periodic table
fifth column of periodic table

⇒ The root locus branches
start from open loop poles and terminate at zeros
start from open loop zeros and terminate at poles
may start from pole or zero and terminate at another pole or zero
none of the above

⇒ A multilevel decoder is more costly as compared to single level decoder.
TRUE
FALSE

⇒ The normalised form of 0.0152 x 10¹⁸ is
0.152 x 10¹⁷
1.52 x 10¹⁶
15.2 x 10¹⁵
152 x 10¹⁴

⇒ The number of address lines in EPROM 4096 x 8 is
2
4
8
12

⇒ Broadcasting antennas are generally
omnidirectional type
vertical type
horizontal type
helical

⇒ In a mod-12 counter the input clock frequency is 10 kHz. The output frequency is
0.833 kHz
1.0 kHz
0.91 kHz
0.77 kHz

⇒ In which group of 8085 instructions condition flags are not affected?
Data transfer group
Arithmetic group
Logical group
Both (a) and (c)

⇒ The input gate current of FET is closer to
few amperes
few milli amperes
few microamperes
negligibly smaller value