Question is ⇒ To avoid objectionable noise in a microwave TV link, the SNR should be about, Options are ⇒ (A) 50 or more, (B) 10 or more, (C) 25 or more, (D) 200 or more, (E) , Leave your comments or Download question paper.

Question is ⇒ To avoid objectionable noise in a microwave TV link, the SNR should be about, Options are ⇒ (A) 50 or more, (B) 10 or more, (C) 25 or more, (D) 200 or more, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	To avoid objectionable noise in a microwave TV link, the SNR should be about
A.	50 or more [Wrong Answer]
B.	10 or more [Wrong Answer]
C.	25 or more [Correct Answer]
D.	200 or more [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a low level AM system, the amplifiers modulated stage must be
linear devices
harmonic devices
class C amplifiers
non-linear devices

⇒ Decimal number 5436 when converted into 9's complement will become
4356
4653
4563
4655

⇒ A radio station works at 800 kHz and uses AM. If this is a public broadcast system, it should transmit using
parabolic reflector to transmit all round
turnstile antenna for the required land
half wave long horizontal wave
a vertical antenna less than quarter for practical reasons

⇒ In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will
remain the same
become three times
decrease
become one-third

⇒ The types of carriers in a semiconductor are
1
2
3
4

⇒ Computers use RC circuit for edge triggering.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Bode	1.	Asymptotic plots
B.	Evans	2.	Polar plots
C.	Nyquist	3.	Root locus technique
		4.	M and N circles

A-1, B-4, C-2
A-2, B-3, C-4
A-3, B-1, C-4
A-1, B-3, C-2

⇒ A Shockley diode can be used
in place of SCR
as a trigger switch for SCR
in place of UJT
both in place of SCR and as a trigger switch for SCR

⇒ A uniform plane magnetic wave incident normally on a plane surface of a dielectric material is reflected and the percentage of reflected power is 75% What is VSWR?
14
1.4
15
13

⇒ In a JFET, the lower end is called the __________ and the upper end is called the __________ .
source, channel
channel, drain
source, drain
drain source

⇒ Binary 1111 when subtracted from binary 11111 is
101110
10110
10000
100010

⇒ Which of the following is the disadvantage of PDM and PPM?
It requires pulses of larger widths
More samples are needed per second
More powerful transmitter is required
None of the above

⇒ In a receiver, which of the following device has IF input but RF output?
Demodulator
Loudspeaker
Audio amplifier
Frequency changer

⇒ Vectored interrupt is an interrupt that takes the program to a vector location. TRAP vectors to 0024 FI, RST 7.5 to 003 CH, RST 6.5 to 0034 H and
RST 5.5
RST 6.5
24 H to 48 H
RST 5.5 to 002 CH

⇒ A second order system exhibits 100% overshoot. The damping ratio is
0
1
< 1
> 1

⇒ Which of the following circuit can operate class AB for audio power output?
Push pull
Cascade
Pull down
Darlington pair

⇒ In the given figure the reflection coefficient at source en
1
-1
42738
-1/3

⇒ Fourier series is applicable for
periodic
finite duration
non periodic
a and b

⇒ Which chopper circuit uses saturable reactor?
Auxiliary commutated
Jones chopper
Morgan chopper
Load commutated

⇒ In which mode of rectangular waveguide are all field components zero?
TM₀₀
TM₁₁
TM₀₁
TM₁₀

⇒ ECL can be used to high frequencies in the order of
500 kHz
1 MHz
100 MHz
500 MHz

⇒ A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either short circuited or open circuited

⇒ The op-amp circuit shown in the figure is a filter. The type of filter and its cut off type of filter and its cut off frequency are respectiv
high Pass, 1000 rad/sec
low Pass, 100 rad/sec
high Pass, 10000 rad/sec
low pass, 10000 rad/sec

⇒ The number of spectral component of impulse wave is
1
0
2
∞

⇒ Magnitude Plot of a Composite signal x(t) = e^2jt + e^3jt is
half wave rectified sinusoidal
full wave rectified sinusoidal
exponentially increasing sinusoidal
exponentially decreasing sinusoidal

⇒

Assertion (A): The inductance of an iron cored solenoid is not constant.

Reason (R): BH curve of an iron specimen is non-linear.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which materials find application in MASER?
Diamagnetic
Paramagnetic
Ferromagnetic
Ferrimagnetic

⇒ Pick out the odd one
stochastic variable
stochastic function
random variable
random experiment

⇒ P flag is for parity.
TRUE
FALSE

⇒ In the circuit of figure the switch is closed at t = 0, At t = 0⁺ this current through inductanc
0
0.416666666666667
6.67 A
5.1 A