Question is ⇒ In amplitude modulation, the magnitude of side bands is, Options are ⇒ (A) ma/2 times the carrier amplitude, Ec, (B) ma times the carrier amplitude, Ec, (C) 2ma times the carrier amplitude, Ec, (D) 4ma times the carrier amplitude, Ec, (E) , Leave your comments or Download question paper.

Question is ⇒ In amplitude modulation, the magnitude of side bands is, Options are ⇒ (A) ma/2 times the carrier amplitude, Ec, (B) ma times the carrier amplitude, Ec, (C) 2ma times the carrier amplitude, Ec, (D) 4ma times the carrier amplitude, Ec, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In amplitude modulation, the magnitude of side bands is
A.	ma/2 times the carrier amplitude, E_c [Correct Answer]
B.	ma times the carrier amplitude, E_c [Wrong Answer]
C.	2ma times the carrier amplitude, E_c [Wrong Answer]
D.	4ma times the carrier amplitude, E_c [Wrong Answer]
View Answer 1 -5 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the system in the given figure. The transfer function C(s)/R(s
G₁ + G₂ + 1
G₁ G₂ + 1
G₁ G₂ + G₂ + 1
G₁ G₂ + G₁ + 1

⇒ High purity copper is obtained by
rolling casting
casting
electrolytic refining
induction heating

⇒ In a magnetron the magnetic flux density is of the order of
1 mWb/s
1 Wb/m²
10⁶ m/s
10¹² m/s

⇒ In a current mirror
the i - v curve of compensating diode is similar to collector curve of transistor
the i - v curve of compensating diode is similar to transconductance curve of transistor
either (a) or (b)
neither (a) nor (b)

⇒ A 12-bit binary counter has the following state. The octal number represente
677
7163
7128
7183

⇒ Voltage series feedback (Also called series-shunt feedback) results in
increase in both I/P and O/P impedances
decrease in both I/P and O/P impedances
increase in I/P impedance and decrease in O/P impedance
decrease in I/P impedance and increase in O/P impedance

⇒ Power Point is a presentation software.
TRUE
FALSE

⇒ The complement of exclusive OR function is
AB + A B
AB + A B
A B + A
AB + A B

⇒ In 8085 the pins for + 5 V input and ground are
20 and 40 respectively
40 and 20 respectively
1 and 2 respectively
1 and 1 respectively

⇒ In a TV receiver there is no raster, no picture and no sound. The most likely defective stage is
power supply unit
video output circuit
horizontal oscillator
balun

⇒ (1001-10) is equal to
7
(8)₈
(7)₄
(8)₄

⇒ When a p-n junction is forward biased, the current remains zero till the applied voltage overcomes the barrier potential.
TRUE
FALSE

⇒ The noise figure of FET circuit is
independent of the quiescent point
dependent on the quiescent point only
dependent on the triggering mechanism
independent of all above

⇒ The energy stored in a coil is 108 J. It is opened suddenly in 10 ms. The power dissipated instantaneously across the blades of switch is
108 W
1080 W
10800 W
108000 W

⇒ Consider the following statements about 'Functions' in C

A function can be called any number of times.
A function gets called when the function name is followed by a semicolon.
The order in which functions are defined in a program and the order in which they are called must be the same.

Which of the above statements are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The INTELSAT-IV satellite launched in 1974 had two earth coverage antenna and two narrower-angle antennas subtending 4.5°. The signal from narrow-angle antenna was stronger than that from earth- coverage antenna by a factor of
17.34/4.5
17.34 x 4.5
(17.34/4.5)²
(17.34/4.5)⁴

⇒ If the oscillator output is modulated by audio frequencies upto 10 kHz, the frequency range occupied by the side bands will be
711.9 kHz to 712.1 kHz
702 kHz to 722 kHz
692 kHz to 732 kHz
71.2 kHz to 71.20 kHz

⇒ The material used in RTD is
linear
aluminium
silver
platinum

⇒ Which of the following addressing modes is used in the instruction PUSH B?
Direct
Register
Register Indirect
Immediate

⇒ The relation between plate current and plate voltage of a vacuum diode is called
Richardson Dushman equation
Langmuir Child law
Ohm's law
Boltzmann's law

⇒ A single phase half wave controlled rectifier circuit has a free wheeling diode. The load is a combination of R and L. The firing angle is a. The period of conduction of SCR and free wheeling diode respectively are
a < ωt < p and p < ωt < (2p + a)
a < ωt < p and p < ωt < 2p
a < ωt < (p + a) and (p + a) < ωt < 2p
a < ωt < p and p < ωt < (2p - a)

⇒ The number of thyristors in a single phase fully controlled bridge rectifier is
16
8
4
2

⇒

Assertion (A): Inverters and choppers use fast switching thyristors

Reason (R): Fast switching SCR has low turn off time.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A unity feedback system has the following open loop frequency resp
0 dB, -17°
3.86 dB, -180°
0 dB, 10°
3.86 dB, 10°

⇒ For a paramagnetic material, susceptiblity increases with increasing temperature.
TRUE
FALSE

⇒ In the given figure
A
B
A + B + C
ABC

⇒ If figure, I = 2A if R = 20 Ω. When R = 10 Ω current I
0.0416666666666667
0.0833333333333333
2.5 A
0.125

⇒ A half wave diode rectifier has a capacitance input filter. If input voltage is V_m sin ωt, PIV is
V_m
2 V_m
3 V_m
4 V_m

⇒ Which of the following devices exhibit negative resistance characteristics?
UJT
PUT
Both UJT and PUT
UJT, PUT and SBS

⇒ A system is said to be marginal stable if
poles lies on Real axis
zero lies on Real axis
poles lies on Imaginary axis
zeros lies on origin