Question is ⇒ Two coils X of 1000 turns and Y of 2000 turns are placed such that 60% of the flux produced by coil X links coil Y. A current of 1 A in coil X produces 0.1 wb flux. The mutual inductance between coils is, Options are ⇒ (A) 0.12 H, (B) 0.08 H, (C) 0.06 H, (D) 0.04 H, (E) , Leave your comments or Download question paper.

Question is ⇒ Two coils X of 1000 turns and Y of 2000 turns are placed such that 60% of the flux produced by coil X links coil Y. A current of 1 A in coil X produces 0.1 wb flux. The mutual inductance between coils is, Options are ⇒ (A) 0.12 H, (B) 0.08 H, (C) 0.06 H, (D) 0.04 H, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two coils X of 1000 turns and Y of 2000 turns are placed such that 60% of the flux produced by coil X links coil Y. A current of 1 A in coil X produces 0.1 wb flux. The mutual inductance between coils is
A.	0.12 H [Correct Answer]
B.	0.08 H [Wrong Answer]
C.	0.06 H [Wrong Answer]
D.	0.04 H [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : Tanu Kumari Said on 2021-03-05 20:48:16 Data incorrect if (0.1m wb) then ans 0.12H !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The circuit of figure is used to measure the value R_x. Ammeter resistance R_a = 0.1 Ω voltmeter resistance R_v = 5000 Ω. It R_x1 and R_x2, are the measured values of R_x with switch in position 1 and 2, the mean of R_x1, and R_x2,
9.98 Ω
10 Ω
10.04 Ω
10.1 Ω

⇒ A parallel connection of circuit is at below resonance circuit behave as
RC circuit
RL
RLC
resistive only

⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are
7.07 mA and 70.7 V
70.7 mA and 70.7 V
0.707 mA and 70.7 V
7.07 mA and 70.7 x 10³ V

⇒ Which family of logic circuits uses field effect transistors?
TTL
CMOS
Both LED and well as LCD
None of the above

⇒ An ideal current source has
infinite source resistance
zero source resistance
large value of source resistance
finite value of source resistance

⇒ Bus bars are always meant for very heavy currents.
TRUE
FALSE

⇒ In a rectangular waveguide if operating frequency is greater than cut off frequency then propagation constant is
purely real
purely imaginary
equal to unit
a complex number

⇒ Without any addition circuitry, an 8:1 MUX can be used to obtain.
some but not all Boolean functions of 3 variables
all functions of 3 variables but none of 4 variables
all functions of 3 variables and some but not all of 4 variables
all functions of 4 variables

⇒ The transfer function of a system is given by H(s) = 1/s² (s - 2). The impulse response of the system is
(t^2* e^-2t) U(t)
(t^* e^2t) U(t)
(te^-2t) U(t)
(te^2t) U(t)

⇒ For a distortionless line, the parameters are related as
R/G = L/C
R/L = 1
R/G = C/L
RG = LC

⇒ As compared to their values in free space
velocity of electric wave in dielectric is smaller but wave length of electric wave is more
both velocity and wave length of electric wave in dielectric are higher
both velocity and wave length of electric wave in dielectric are smaller
wave length of electric wave is less but velocity is more in dielectric

⇒ A chopper cannot be line commutated.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Very low response at very high frequencies	1.	Low-pass system
B.	Over shoot	2.	Velocity damping
C.	Synchro-control transformer output	3.	Natural frequency
		4.	Phase-sensitive modulation
		5.	Damping ratio

A-1, B-5, C-4
A-3, B-2, C-4
A-2, B-5, C-4
A-4, B-1, C-3

⇒ The stage marked X in the architecture shown below of a two stage op-amp
Direct coupled amplifier
Buffer amplifier
Level shifter
Blocking oscillator

⇒ In a transistor which of the following region is very lightly doped and is very thin?
Emitter
Base
Collector
None of the above

⇒

Assertion (A): Orbital magnetic moment of an electron in an atom is of the order of 1 Bohr magneton.

Reason (R): 1 Bohr magneton = 9.27 x 10^-24 A/m².

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of valence electrons in silicon atom is
4
2
1
zero

⇒ The angular location of poles depends on
undamped natural frequency
damping ratio
both (a) and (b)
neither (a) nor (b)

⇒ A network has two branches in parallel. One branch contains impedance Z₁ and the other branch has impedance Z₂. If it is fed from an ac voltage V of frequency f, the current through Z₁ depends, on
V, Z₁, Z₂
V, Z₁
Z₁, Z₂
V, Z₁, f

⇒ Which of the following rotors are used in two phase ac servomotor?

Solid iron rotor
Squirrel cage rotor
Drag cup rotor

Of the above the correct ones are
1, 2, 3
1, 2
2, 3
1, 3

⇒ In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is
9 kΩ
6 kΩ
3 kΩ
2 kΩ

⇒ In a bipolar junction transistor a_dc = 0.98, I_CO= 2 μA and 1_B = 15 μA. The collector current I_C is
635 mA
735 mA
835 mA
935 mA

⇒ A Wien bridge oscillator uses Wien bridge for
tuning and phase shift
tuning
phase shift
either tuning or phase shift

⇒ Computers use RC circuit for edge triggering.
TRUE
FALSE

⇒ In which of the following 8085 instructions are all condition flags except CY affected?
INR r
SEE M
ACI data
ADC r

⇒ For a superconductor, the relative permeability is
zero
high
low
either low or high

⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
31 V
32 V
insufficient data
none of these

⇒ If low pressure of 10^-6 mm of Hg is required to be measured, we should use
compound pressure gauge
thermocouple vacuum gauge
Pirani gauge
ionization type vacuum gauge

⇒ The concentration of minority carriers in a semiconductor depends mainly on
the extent of doping
temperature
the applied bias
none of the above

⇒ Two resistances are : R₁ = 36 Ω ± 1.89 Ω and R₂ = 75 Ω ± 3.75 Ω. The sum R₁ + R₂ along with limiting error is
111 Ω ± 1.8 Ω
111 Ω ± 3.75 Ω
111 Ω ± 5.55 Ω
111 Ω ± 1.95 Ω