Question is ⇒ In TTL the transistors are driven into and out of saturation., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In TTL the transistors are driven into and out of saturation., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In TTL the transistors are driven into and out of saturation.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the minterm designation Y = ∑ m (1, 3, 5, 7) the complete expression is
Y = A BC + A B C
Y = A B C + A B C + ABC + A BC
Y = A B C + A B C + ABC + A BC
Y = A B C + ABC + A BC + A BC

⇒ Good smoothing factor of a coil depends on
inductance of the coil
terminal voltage
cross-sectional area of the wire of the coil
property of the wire of the coil

⇒ Consider the following statements

ECL has least propagation delay
TTL has largest fan out
CMOS has highest noise margin
TTL has lowest power dissipation

Which of these are correct?
1 and 3
2 and 4
3 and 4
1 and 2

⇒ A tachometer has a sensitivity of 4 V/1000 rpm. Express the gain constant of the tachometer in the units volts/(rad/sec).
0.0489
0.0381
2
none of these

⇒ In figure the coordinates of Q point on the load line are (Neglect V_{BEI_C = 10 mA, V_CE = 15 V
I_C = 5 mA, V_CE = 22.5 V
I_C = 5 mA, V_CE = 15 V
I_C = 10 mA, V_CE = 22.5 V}

⇒ In 8421 Binary coded Decimal system the decimal number 237 is represented by
1000110111
1000111110
1000110111
10010010011

⇒ A direct radiating cone type loudspeaker attenuates :
medium range frequencies
very low frequencies
high frequencies
very low and high frequencies

⇒ A permeable substance is one
which is strong magnet
which is a weak magnet
which is a good conductor
through which magnetic lines of force can pass easily

⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
1 H
1.5 H
indeterminate
0.5 H

⇒ In a modulator it is found that the amplitude spectrum consists a component at f_c, the carrier frequency and one component each at f_c - f_s and f_c + f_s where f_s is the modulating signal frequency. Then the modulator used is
AM
AM or MBFM with modulation index 0.5
FM
PAM

⇒ When a binary adder is used as BCD adder, the sum is
correct when it is < 9
correct when it is > 9
correct when it is < 16
none of these

⇒

Assertion (A): For networks in figure (1) and (2) sum of products of branch voltages and branch currents at any time is zero.

Reason (R): The networks in figure (1) and (2) are not the same structura
Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In figure, I = 2A, then
5 V
3 V
2 V
1 V

⇒ Resistivity is a property of a semiconductor that depends on
the atomic weight of the semiconductor
the atomic number of the semiconductor
the atomic nature of the semiconductor
the shape of the semiconductor

⇒ A₁₆ X 2₁₆ __________ .
16₁₆
15₁₆
14₁₆
13₁₆

⇒ Effective Q of the equivalent electrical circuit of quartz crystal is of the order of
200
2000
20000
200000

⇒ Which one of the following is correct?
RAM is a volatile memory but ROM is non-volatile memory
RAM is non-volatile memory but ROM is volatile memory
Both ROM and RAM are volatile but in ROM data is not lost when power is switched off
Both ROM and RAM are non-volatile but in RAM data is lost when power is switched off

⇒

Assertion (A): Free space does not interfere with normal radiation and propagation of radio waves

Reason (R): Free space has no magnetic or gravitational fields.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The power required to produce a gain of 10 dB over 4 W of original power is __________ watt.
80
40
0.4
8

⇒ At a particular time it is observed that the frequencies of F layer at Delhi is 3 MHz the maximum electron density is
11 x 10¹⁰
1.1 x 10¹⁰
0.11 x 10¹⁰
11 x 10¹²

⇒ The holes diffuse from P-region to the N-region in a P-N junction diode because
there is greater concentration of holes in the P-region as compared to N-region
there is greater concentration of holes in the N-region as compared to P-region
the free electrons in the N-region attract them
potential difference facilities such transfer

⇒ Which of the following logic no resistors are used?
CMOS
TTL
4 n sec ECL
8 sec ECL

⇒ In floating point representation the number of bits in exponent is
8
7
6
5

⇒ 3N 200 is a
semi-conductor diode
P-N-P transistor
dual gate MOSFET
UJT

⇒ The number of possible colours with a 4 line digital input monitor are
4
16
64
2

⇒ The signal in 8086 are in minimum mode when
MN / Mx pin is tied to V_cc
MN / Mx pin is grounded
MN / MX pin is left open
none of the above

⇒ In a circuit of figure, V_s = 10 cos(ωt) power drawn by the 2Ω resistor is 4 watts. The power facto
0.3
0.4
0.6
none

⇒ How many interrupts are there of 8085 μP?
4
5
6
8

⇒ Nyquist plot provides information about absolute stability as well as relative stability.
TRUE
FALSE

⇒ For broadside array, maxima will be obtain at
90°, 270°
180°
45°
at any angle