Question is ⇒ In grid bias modulation system the power required for modulating amplifier, Options are ⇒ (A) is negligibly low since grid is negative, (B) is large as compared to that for plate modulation, (C) is almost the same as compared with plate modulation, (D) is small as compared to that for plate modulation, (E) , Leave your comments or Download question paper.

Question is ⇒ In grid bias modulation system the power required for modulating amplifier, Options are ⇒ (A) is negligibly low since grid is negative, (B) is large as compared to that for plate modulation, (C) is almost the same as compared with plate modulation, (D) is small as compared to that for plate modulation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In grid bias modulation system the power required for modulating amplifier
A.	is negligibly low since grid is negative [Wrong Answer]
B.	is large as compared to that for plate modulation [Wrong Answer]
C.	is almost the same as compared with plate modulation [Wrong Answer]
D.	is small as compared to that for plate modulation [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An extrinsic semiconductor sample has 6 billion silicon atoms and 3 million pentavalent impurity atoms. The number of electrons and holes is
3 million each
6 billion each
3 million free electrons and very small number of holes
3 million holes and very small number of free electrons

⇒ Transmitted voltage level is:
11
7.8
7.348 V
none of these

⇒ A radar has a maximum range of 120 km. The maximum allowable pulse repetition frequency for unambiguous reception is
1250
330
2500
8330

⇒ In the fabrication of n-p-n transistor in an IC, the buried layer on the P-type substrate is
P⁺ -doped
n⁺ -doped
used to reduce the parasitic capacitance
located in the emitter region

⇒ The input resistance of JFET ideally approaches
zero
1 ohm
100 ohm
infinity

⇒ If f is more than f_unity the gain of op-amp becomes less than 1.
TRUE
FALSE

⇒ The degree of the nodes 1, 2, 3,
2
3
2 for 1, 2, 3, and 3 for 4
all 3

⇒ In a CMOS CS amplifier, the active load is obtained by connecting a
p channel current mirror circuit
n channel transistor
p channel transistor
BJT current mirror

⇒ In 3 phase power measurement by two wattmeter method, both wattmeters had equal reading. The power factor of load is
1
0.5 lagging
0.5 leading
0

⇒ If a microcomputer has a 64 K memory; what is the hexadecimal notations for the last memory location?
1111
1A1A
EEEF
FFFF

⇒ For a system to be designated as hi-fi, the signal to noise ratio should be at least
25 dB
50 dB
75 dB
100 dB

⇒ Atomic and molecular resonance is observed in many substances
at microwave frequencies
at low frequencies
at frequencies used in AM broadcast
at both (b) and (c)

⇒ The direction of vectors gives the direction of propagation of electromagnetic waves
Vector (E x H)
Vector (F x H)
Vector E
Vector H

⇒ For frequencies upto 1650 kHz __________ antenna is used
yagi
grounded
turnstile
marconi

⇒ Ferrite have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ For resonant long wire antenna 'n' half wavelength long in free space, if 'n' is increased then inclination of the major lobe with wire axis will __________ .
increases
decreases
remains same
none

⇒ A TTL circuit with totem pole output has
high output impedance
low output impedance
very high output impedance
none of the above

⇒ In an intrinsic semiconductor, the intrinsic charge concentration at any absolute temperature T is proportional to
T
T²
T³
T⁴

⇒ An intrinsic silicon sample has 1 million free electrons at room temperature. As the temperature is increased
the number of free electrons increases
the number of free electrons increases but the number of holes decreases
the number of free electrons and holes increase by the same amount
the number of free electrons and holes increase but not by the same amount

⇒ When a wave reaches the open circuited end of a line
all the forward energy is reflected by the open circuit
all the forward energy is absorbed by the open circuit
a small portion of energy is radiated into atmosphere and the remaining energy is reflected
either (a) or (b)

⇒ For the port shown, the short circuit network function at port 2 is give
s + 1/4
s + 4
4s + 1
s + 16

⇒ In the circuit of fi
V_a would always lag V_b
V_a would always lead V_b
V_a and V_b can be in phase
phase angle between V_a and V_b would always be 90°

⇒ For a symmetrical network
z₁₁ = z₂₂
z₁₂ = z₂₁
z₁₁ z₂₂ and z₁₂ = z₂₁
z₁₁ z₁₂ - z₁₂² = 0

⇒ For a paramagnetic material, susceptiblity increases with increasing temperature.
TRUE
FALSE

⇒ All of the output pulses are at full transmitter power for a strong signal in all of the following except
PWM
PAM
PFM
PCM

⇒ In a single phase full wave converter (M - 2 connection) feeding a highly inductive load, the firing angle for each thyristor is a in the respective half cycle. The period of conduction of each thyristor is
p - a
p
p + a
p - 2a

⇒ The input impedance for folded dipole antenna (two half dipole) is
73 n²
377 n²
73 n
377 n

⇒ In a rectifier circuit the filter capacitance is increased. Then the ripple will
increase
decrease
remain the same
either (a) or (b)

⇒ Which of the following should dominant wave have?
Lowest cut off frequency
Highest cut off frequency
No attenuation
No phase shift

⇒ In the stabilized reactance modulator AFC system
phase modulation is converted into amplitude modulation by the equalizer circuit
the discriminator frequency must not be too low or the system will fail
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency, better the oscillator frequency stability