Question is ⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. Which of the following will increases from this type of operation?, Options are ⇒ (A) Stability, (B) Bandwidth, (C) Distortion, (D) Input resistance, (E) , Leave your comments or Download question paper.

Question is ⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. Which of the following will increases from this type of operation?, Options are ⇒ (A) Stability, (B) Bandwidth, (C) Distortion, (D) Input resistance, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. Which of the following will increases from this type of operation?
A.	Stability [Wrong Answer]
B.	Bandwidth [Wrong Answer]
C.	Distortion [Correct Answer]
D.	Input resistance [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The series element of a band stop filter is
capacitive
inductive
parallel combination of L and C
series combination of L and C

⇒ The units of μ₀ and μ_r are
H/m for both
H/m for μ_r and no units for μ₀
H/m for μ₀ and no units for μ_r
Wb/m for μ₀ and no units for μ_r

⇒ In ionosphere incidence angle is 60°. The maximum usable frequency f_m is equal to
2f_c
f_c
0.5 f_c
3 f_c

⇒ A transmission line of characteristic impedance z₀ = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z₁ = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
(30 + j x 40) Ω
(30 - j 40) Ω
(50 + j x 40) Ω
(50 - j 40) Ω

⇒ Insertion of a dielectric material between the plates of an air capacitor
increases the capacitance
decreases capacitance
has no effect an capacitance
increases breakdown voltage

⇒

Match the following:

	List I		List II
A.	Servomotor	1.	Error detector
B.	Amplidyne	2.	Transducer
C.	Potentiometer	3.	Actuator
D.	Flapper valve	4.	Power amplifier

A-3, B-1, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1

⇒

Assertion (A): Maxwell bridge is for measuring inductance of medium magnitude.

Reason (R): In Maxwell's bridge the unknown inductance is measured by comparing it with a capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The total number of pins in 8085 are
20
30
40
50

⇒ Calculate the O/P voltage of a non-inverting constant gain multiplier with R₁ = 100 kΩ, R_f= 600 kΩ, V₁ = 2 volt, then O/P voltage V_o of non inverting op-amp is given by
16 V
14 V
20 V
15 V

⇒ Parity means the same as positive or negative number.
TRUE
FALSE

⇒ The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded
The diode is a silicon diode
The diode is a germanium diode
Break down voltage of the diode is 0.7 V
At 1 V rated current will pass through the diode

⇒

Assertion (A): Energy meters use induction principle.

Reason (R): Induction wattmeter is less accurate than a dynamometer wattmeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following terms is not applicable to Yagi-Uda array?
High gain
Folded dipole
Parasitic elements
Good bandwidth

⇒ An increase in junction temperature of a semiconductor diode
causes a small increase in reverse saturation current
causes a large increase in reverse saturation current
does not affect reverse saturation current
may cause an increase or decrease in reverse saturation current depending on rating of diode

⇒ A lead compensator
speeds up the transient response
increases the stability margin
increases the stability margin and speeds up the transient-response.
none of the above.

⇒ Slotted line can be used for measurement of high frequencies
TRUE
FALSE

⇒ At t = ∞; V_R2 and V_C wil
4, 4
2, 4
0, 2
2, 0

⇒ The signal in 8086 are in minimum mode when
MN / Mx pin is tied to V_cc
MN / Mx pin is grounded
MN / MX pin is left open
none of the above

⇒

Assertion (A): Thermistors are commonly used to measure hot spot temperatures in electric machines.

Reason (R): Thermistor has the advantages of high temperature coefficient, small size and high speed of response.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Consider the following statements

An iron cored choke is non linear and passive device.
A carbon resistor kept in sunlight is a time invariant and passive device.
A dry cell is a time varying and active device.
An air capacitor is time invariant and passive device.

Of these statements
1, 2, 3 and 4 are correct
1, 2, 3 are correct
1, 2, 4 are correct
2 and 4 are correct

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ In a series R-L-C circuit, the voltage across inductance will be maximum
at resonance frequency
just before resonant frequency
just after resonant frequency
none of the above

⇒ Quantizing error occurs in
TDM
FDM
PCM
PWD

⇒ In TV transmission the modulation schemes for video and audio are respectively
FM and AM
FM and FM
AM and FM
AM and AM

⇒ The complement of Boolean expression AB (B C + AC) is
(A + B) + (B + C) + (A + C)
A B + (B + C)(A + C)
(A + B) + (B + C) (A + C)
none of the above

⇒ BPSK stands for
Binary Phase Shifting Key
Broad Phase Shifting Key
Bit Phase Shifting Key
Binary Pulse Shifting Key

⇒ There is no hysteresis phenomenon is any dielectric material.
TRUE
FALSE

⇒ CMOS is extensively used in
pocket calculators
digital wrist watches
satellites
all of the above

⇒ Some ceramic materials become superconducting
below liquid helium temperature
between liquid helium and liquid nitrogen temperature
above liquid nitrogen but below room temperature
at room temperature

⇒ In the given figure, the number of individual loop
2
4
5
6