Question is ⇒ The given figure shows a pole zero diagram. The transfer function G(<i>j</i>1, Options are ⇒ (A) 0.5 ∠0, (B) 2.7 ∠- 31°, (C) 2 ∠45°, (D) 2 ∠- 67.4°, (E) , Leave your comments or Download question paper.

Question is ⇒ The given figure shows a pole zero diagram. The transfer function G(<i>j</i>1, Options are ⇒ (A) 0.5 ∠0, (B) 2.7 ∠- 31°, (C) 2 ∠45°, (D) 2 ∠- 67.4°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The given figure shows a pole zero diagram. The transfer function G(j1
A.	0.5 ∠0 [Correct Answer]
B.	2.7 ∠- 31° [Wrong Answer]
C.	2 ∠45° [Wrong Answer]
D.	2 ∠- 67.4° [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
1 mA
2 mA
5 mA
10 mA

⇒ Binary multiplication 1 x 0 =
1
0
10
11

⇒ Which binary addition is incorrect?
1001.1 + 1011.01 = 10100.11
100010 + 1000101 = 1001010
0.0011 + 0.1110 = 1.1
1011.01 + 1001.11 = 10111

⇒ As regards dielectric constant ε_r
the units are farads/m
the units are newton/coulomb
it is dimensionless
the units are farads

⇒

Assertion (A): The modified ramp function of the given figure can be represented s sum of two ramp functions of the given fig
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For the given circuit, the current
0.0833333333333333
0.208333333333333
0.291666666666667
0.333333333333333

⇒

Assertion (A): Megger is used to check insulation resistance of cables.

Reason (R): Insulation resistance of cables is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ An angle modulated signal is expressed by f_a(t) = cos (2 x 10⁸ pt) + 75 sin (2 x 10³ pt). The peak frequency deviation of the carrier is
1 kHz
7.5 kHz
75 kHz
100 MHz

⇒ The percentage saving in power when the carrier and one of the sidebands are suppressed in an AM wave modulated to a depth of 100% will be nearly
0.5
0.66
0.75
0.83

⇒ A second order active bandpass filter can be obtained by cascading LP second order filter having higher cut off frequency f_OH with a second order HP filter having lower cut off frequency f_OL provided
f_OL < f_OH
f_OL > f_OH
f_OH = f_OL
f_OH < 0.5 f_OL

⇒

Assertion (A): PIN diode is commonly used for microwave control.

Reason (R): A PIN diode uses heavily doped p and n materials.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The system of the given fi
has two poles and one zero in left half plane
has two poles and one zero in right half plane
has two poles in left half plane and zero in right half plane
none of the above

⇒ The seven bit Hamming code received is 0010001. If even parity has been used, the correct code is
10001
1110001
110001
11001

⇒

Assertion (A): Inverse Laplace transform can be found from P(s) by inversion integral.

Reason (R): The function f(t) is assumed to be zero for t < 0.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A voltage multiplier circuit, using diodes and capacitors is suitable for
high voltage high current device
high voltage low current device
low voltage low current device
low voltage high current device

⇒

Assertion (A): A transducer needs an output measuring or display device for measuring a non electrical quantity.

Reason (R): In some transducers the output voltage is too small and needs amplification before it can be measured.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In high power AM transmission modulation is done at
IF stage
RF power
buffer stage
oscillator stage

⇒ The polar plot for positive frequencies is shown below. The gain margi
- 8.02 dB
6.02 dB
5 dB
none of these

⇒ In the given figure,
(A + B)C + DE
AB + C(D + E)
(A + B)C + D + E
none of the above

⇒ The effect of negative feedback on distortion and bandwidth because
both are decreased
both are increased
distortion is reduced and bandwidth is increased
distortion is increased and bandwidth is decreased

⇒ In a CD the sampling frequency is nearly
half the highest frequency in audio signal
equal to highest frequency in audio signal
double the highest frequency in audio signal
four times the highest frequency in audio signal

⇒ In floating point number 0110100000010101, the exponent is equal to __________ ₁₀
11
-11
10
-10

⇒ Which is not a valid Java variable
lot
c 1t
s $ 2
2 s $

⇒ Which of the following circuits come under the class of sequential logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 and 2
1, 2 and 3
3 and 4
4 and 5

⇒ In the case of the circuit shown in the figure V_io = 10 mV dc maximum, the maximum possible output offset voltage V_oo caused by the input offset voltage V_io with respect to groun
60 mV dc
110 mV dc
130 mV dc
150 mV dc

⇒ Impedance inversion may be obtained with
a short circuited stub
a quarter wave line
an open circuited stub
a half wave line

⇒

Assertion (A): Negative values of incremental operator in DO loop are allowed in Fortran 77 but not in earlier versions of Fortran.

Reason (R): Fortran 77 has better array facilities than earlier versions of Fortran.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
0.5 M(f + f_c)
0.5 M(f - f_c)
0.5 M(f + f_c) + 0.5 M(f - f_c)
0.5 M(f - f_c) + 0.5 M(f - f_c)

⇒

Assertion (A): The small signal analysis of a transistor amplifier is done to obtain the current gain, voltage gain and the conversion efficiency of an amplifier.

Reason (R): The small signal analysis of a transistor amplifier uses the small signal parameters of the transistor.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Two sinusoidal signals of same amplitude and frequencies 10 kHz and 10.1 kHz are added together. The combined signal is given to an ideal frequency detector. The output of the detector is
0.1 kHz sinusoidal
10.1 kHz sinusoidal
a linear function
a constant