Question is ⇒ The decoder for PAL system is, Options are ⇒ (A) similar to NTSC decoder, (B) similar to NTSC decoder supplemented by 64 ms delay line, (C) similar to NTSC decoder supplemented by 64 ms delay line and an electronic commutator, (D) either (b) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ The decoder for PAL system is, Options are ⇒ (A) similar to NTSC decoder, (B) similar to NTSC decoder supplemented by 64 ms delay line, (C) similar to NTSC decoder supplemented by 64 ms delay line and an electronic commutator, (D) either (b) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The decoder for PAL system is
A.	similar to NTSC decoder [Wrong Answer]
B.	similar to NTSC decoder supplemented by 64 ms delay line [Wrong Answer]
C.	similar to NTSC decoder supplemented by 64 ms delay line and an electronic commutator [Correct Answer]
D.	either (b) or (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the series circuit shown in figure, for series resonance, the value of the coupling coefficient, K wil
0.25
0.5
0.1
1

⇒

Assertion (A): The closeness of G(jω) locus to (- 1 + j0) point can be used as a measured of margin of stability.

Reason (R): When the G(jω) locus comes close to encircling (- 1 + j0) point the system becomes oscillatory.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Is the interrupt-enable flag?
Low
High
Never
None

⇒ For the given circuit, the current
0.0833333333333333
0.208333333333333
0.291666666666667
0.333333333333333

⇒ Study the circuit of figure and examine the following statem
1, 2 and 3
1 and 2
1 and 3
2 and 3

⇒ A series resonant circuit has R = 10 Ω, L = 1 μH and C = 1 mF. If R is increased to 20 Ω the resonant frequency
increases
decreases
remains constant
may increases or decreases

⇒ A BJT is said to be operating in saturation region if
both junctions are reverse biased
both junctions are forward biased
base emitter junction is forward biased and base collector junction is reverse biased
base collector junction is forward biased and base emitter junction is reverse biased

⇒ A shadow zone does not receive any space wave
TRUE
FALSE

⇒ In an ac circuit that delivers constant power at varying p.f., the current is
lowest when p.f. is leading
lowest when p.f. is lagging
lowest when p.f is unity
the same for all power factors

⇒ For the circuit shown in the figure, D has a transition from 0 to 1 after CLK changes from 1 to 0. Assume gate delays to be neglig
Q goes to 1 to the CLK transition and stays at 1
Q goes to 0 at the CLK transition and stays at 10
Q goes to 1 at the CLK transition and goes to 0 when D goes to 1
Q goes to 0 at the CLK transition and goes to 1 when D goes to 1

⇒ AM-SC stands for
Amplitude Modulated-Suppressed Carrier
Amplitude Modulated-Single Carrier
Amplitude Modulated-Synchronous Carrier
Amplitude Modulated-Self Carrier

⇒ Windows have a user friendly program called 'Front Page Express' for creating web pages.
TRUE
FALSE

⇒ Rotation of a geosynchronous satellite means its
drift from stationary position
wobbling
three-axis stabilization
three-dimensional stabilization

⇒ Poles and zeros of a driving point function of a network are simple and alternate on jω axis. The network consists of
R and C
L and C
R and L
R, L and C

⇒ For a transistor amplifier with self biasing network, the following components are used. R₁ = 4 kΩ, R₂ = 4 kΩ, R_C = 1 kΩ. The approximate value of the stability factor 'S' will be
4
3
2
1.5

⇒ FM receivers using the standard 88 to 108 MHz band use IF of
8 MHz
9.9 MHz
10.7 MHz
12.2 MHz

⇒ Television receiver antenna is usually
loop type
yagi antenna
parabolic dishes
none of the above

⇒ Which one of the following is an active component?
Diode (p-n)
Transistor as Amplifier
Transformer
Inductor

⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒ The depletion layer width of Junction
decreases with light doping
is independent of applied voltage
is increased under reverse bias
increases with heavy doping

⇒ The time required for horizontal blanking is 16% of that for each horizontal line. If horizontal time is 63.5 μs, the horizontal blanking time for each line is about
1 μs
10 μs
100 μs
none of the above

⇒

Assertion (A): Thyristors can be used in controlled heating, excitation systems of alternators, speed control of motors and HVDC

Reason (R): A static var system using thyristors is very commonly used in high voltage ac systems.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The correct sequence of events to improve system stability is
insert derivative action, use negative feedback, reduce gain
reduce gain, use negative feedback, insert derivative action
reduce gain, insert derivative feedback, use negative feed back
use negative feedback, reduce gain, insert derivative action

⇒ Which of the following is not a wideband antenna?
Marconi
Discone
Helical
Folded dipole

⇒ The average value of wave in figur
90 V
75 V
60 V
50 V

⇒ Hall effect is observed in a specimen when it is carrying current and is placed in a magnetic field. The resulting electric field inside the speciment will be in
direction normal to both current and magnetic field
the direction of current
direction antiparallel to magnetic field
an arbitrary direction depend upon conductivity

⇒ In most transistor the collector region is made physically larger than the emitter region
for dissipating heat
to distinguish it from other regions
as it is sensitive to ultraviolet rays
to reduce resistance in the path of flow of electrons

⇒ A binary with a digits, all of which are unity has the value
n² - 1
2ⁿ
2(^{n - 1})
2ⁿ - 1

⇒ In 8085 microprocessor with memory mapped I/O which of the following is true?
I/O devices have 16 bit addresses
I/O devices are accessed during IN and OUT instructions
There can be a maximum of 256 input and 256 output devices
Logic operations can not be performed