Question is ⇒ The JFET in the circuit shown in figure has an IDSS = 10 mA and Vp = -5 V. The value of the resistance Rs for a drain current IDS = 6.4 mA is (select the nearest va, Options are ⇒ (A) 150 Ω, (B) 150 Ω, (C) 560 Ω, (D) 1 kΩ, (E) , Leave your comments or Download question paper.

Question is ⇒ The JFET in the circuit shown in figure has an IDSS = 10 mA and Vp = -5 V. The value of the resistance Rs for a drain current IDS = 6.4 mA is (select the nearest va, Options are ⇒ (A) 150 Ω, (B) 150 Ω, (C) 560 Ω, (D) 1 kΩ, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The JFET in the circuit shown in figure has an I_DSS = 10 mA and V_p = -5 V. The value of the resistance R_s for a drain current I_DS = 6.4 mA is (select the nearest va
A.	150 Ω [Correct Answer]
B.	150 Ω [Wrong Answer]
C.	560 Ω [Wrong Answer]
D.	1 kΩ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A loss less line is terminated in a circular lines are E lines
SWR = 0
SWE = 0
SWR is finite
SWR = ∞

⇒ Number of cards read per minute by a card reader may be of the order of
20
1
10000
300

⇒ A carrier is simultaneously modulated by two sine waves having modulation indices of 0.4 and 0.3. The total modulation index will be
0.1
0.7
0.5
0.35

⇒ If a function f(t) is an odd, function, its Fourier series
contains only sine terms
contains only cosine terms
contains a constant and sine terms
contains a constant and cosine

⇒ A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
500 Ω
50 Ω
20 Ω
5 Ω

⇒ When the core of a saturable reactor is saturated, the inductance is high.
TRUE
FALSE

⇒ A half bridge inverter
needs a 3 wire dc supply
may use a two wire or 3 wire dc supply
has higher output voltage if fed from 3 wire dc supply
has higher efficiency if fed from 3 wire dc supply

⇒ In an n channel JFET, the gate is
n type
p type
either n or p
partially n & partially p

⇒ Ground wave can be used for communication upto
5 kHz
12 kHz
16 kHz
25 kHz

⇒ The time base generator in a CRO gives an output which is
low frequency sinusoidal
high frequency sinusoidal
low frequency rectangular
high frequency sawtooth

⇒ Friction forces acts in a direction
opposite to that of velocity
same as that of velocity
at right angle to that of velocity
partly opposite and partly at right angle to the direction of velocity

⇒ The content of which of the following determines the state of the CPU at the end of the execute cycle (when the interrupt is recognized)?

Program counter
Processor register
Certain status conditions

Select the correct answer using the codes given below :
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒

Match the following:

	List I		List II
A.	lag compensation	1.	Exterior of unit circle \|z\| = 1
B.	lead compensation	2.	PD control
C.	stability	3.	Non-minimum phase
D.	Instability	4.	Left half s plane
		5.	PI control

A-2, B-5, C-1, D-3
A-3, B-1, C-2, D-5
A-1, B-2, C-3, D-4
A-5, B-2, C-4, D-1

⇒ In Bode analysis the correction at corner frequency is 3 dB.
TRUE
FALSE

⇒ Logic pulser
generates short duration pulses
generates long duration pulses
generates sinusoidal voltage
generates ideal pulses

⇒ The length of half-wave antenna is at 30 MHz
2.5 meter
5 meter
10 meter
100 meter

⇒ The difference between phase and frequency modulation
is purely of academic interest
lies in the different definitions of the modulation index
lies in the poor audio response of phase modulation
is too great to make the two systems compatible

⇒ An antenna has a resistance of 50 Ω and an equivalent noise resistance of 30 Ω The noise figure in decibels is
1.6 dB
2 dB
3.6 dB
6 dB

⇒ The function shown in the fig
impulse function
signum function
unit step function
none of the above

⇒ In a series LCR circuit the maximum inductor voltage is twice the maximum capacitor voltage however current lags by 30° and drop across the inductance is v_L = 100 sin 377t V. Assuming the resistance being 20 Ω, Find the values of the capacitance and inductance.
235 μF, 61.18 μH
230 μF, 61.18 μH
61.18 μF, 230 μH
None of the above

⇒ The value of the integral of the function g(x, y) = 4x³ + 10y⁴ along the straight line segment from the point (0, 0) to the point (1, 2) in the x-y plane is
33
35
40
56

⇒ In a radio detector
stabilization against signal strength variation is provided
linearity is worse than in a phase discriminator
the circuit is the same as in discriminator except that diodes are reversed
output is twice that obtainable from a similar phase discriminator

⇒ The specified maximum junction temperature of thyristors is about
50°C
80°C
120°C
200°C

⇒ In control systems the output of sensor usually, is
analog electrical signal
digital electrical signal
mechanical signal
analog or digital electrical signal

⇒ In the circuit shown the voltage V_s has a phase angle of __________ with respect to V_{L120°
60 °
-90 °
0°}

⇒ In a network
Number of links = Number of branches - number of nodes + 1
Number of links = Number of branches - number of nodes
Number of links = Number of branches - number of nodes - 1
Number of links = Number of branches - number of nodes - 2

⇒

Assertion (A): A VMOS can handle much larger current than other field effect transistors.

Reason (R): In a VMOS the conducting channel is very narrow.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In common base connection, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_C and V_CE
I_E and V_CB
I_E and V_CE

⇒ In measuring resistance using voltmeter and ammeter, the resistances of voltmeter and ammeter also affect the accuracy of measurement.
TRUE
FALSE

⇒ Determine the transistor capacitance of a diffused junction varicap diode of a reverse potential of 4.2 V if C(0) = 80 pf and V_T = 0.7 V
42 pf
153.03 pf
13.33 pf
Data inadequate