Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is |

A. | 100 W [Wrong Answer] |

B. | 66 W [Wrong Answer] |

C. | 50 W [Wrong Answer] |

D. | 25 W [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The amplitude of a modulated RF aerial current is 6 A on the peaks of modulation and 4 A on the troughs of modulation. The value of carrier amplitude is

5

15

20

30

⇒ If E (i.e., available energy state) = E

_{F}(i.e., Fermi level), then probability that state E will be occupied is 0.5 for any temperature T.

TRUE

FALSE

⇒ Which of the following terms is not applicable to Yagi-Uda array?

High gain

Folded dipole

Parasitic elements

Good bandwidth

⇒ If B

_{max}is the maximum flux density, eddy current loss is proportional to

B

_{max}

B

^{1.6}

_{max}

B

^{2}

_{max}

B

^{3}

_{max}

⇒ In

*n*-well CMOS fabrication substrate is:

heavily doped

*n*-type

heavily doped

*p*-type

lightly doped

*n*-type

lightly doped

*p*-type

⇒ Secondary emission results

when temperature of metals is raised to a level above the crystallization temperature

when metals are subjected to strong magnetic fields

when light rays fall on the metal surface

when a high velocity beam of electrons strikes as metal surface

⇒ Consider the CMOS circuit shown, where the gate voltage V

_{G}of the n-MOSEFT is increased from zero, while the gate voltage of the p-MOSFET is kept constant at 3 V. Assume that, for both transistor, the magnitude of the threshold voltage is 1 V and the product of the transconductor parameter and the (W/L) ratio, i.e. the quality μC

_{0x}(W/L), is 1mA. V

^{-2Both the MOSFET are in saturation regionBoth the MOSFET are in triode regionn-MOSFET is in triode and p-MOSFET is in saturation regionn-MOSFET is in saturation and p-MOSFET is in triode region}

⇒ The circuit show

voltage series feedback amplifier

transconductance amplifier

transresistance amplifier with open circuit mutual resistance R

_{F}

transresistance amplifier with short circuit mutual resistance R

_{F}

⇒ Under low level injection assumption, the infected minority carrier current for an extrinsic semiconductor is essentially the

diffusion current

drift current

recombination current

induced current

⇒ Which instrument needs creep compensation?

Dynamometer wattmeter

Induction wattmeter

Energy meter

Both (b) and (c)

⇒ Output of a phase splitter is

a pair of sine waves of unequal amplitude

a pair of sine waves of equal amplitudes

a pair of sine waves of equal amplitudes and opposite phase

a pair of sine waves of unequal amplitudes and opposite phase

⇒ Which one is correct option?

- A pure capacitor never dissipates energy, but only stores.
- Capacitor can store finite amount of energy even cunent is zero.
- The current through a capacitor is zero if voltage across it d.c.
- Voltage across a capacitor cannot change instantaneously since it would require an infinite current.
*q*_{c}(0^{-}) =*q*_{c}(0^{+})

5, 4, 3, 2

3, 4, 1, 2

2, 4, 3, 1

1, 2, 3, 4, 5

⇒ A tape recorder and deck are entirely similar.

TRUE

FALSE

⇒ Consider the following circuits. Assume all gates to have finite propagation d

(1) only

(1) and (2) only

(2) (3) and (4) only

All (1) (2) (3) and (4)

⇒ Which statement is incorrect for the signal

*x*(

*t*) = 5 sin (2p x 10

^{3}

*t*) sin (2p x 10

^{6}

*t*)?

Upper side band frequency is 1001000

Carrier amplitude is 5

Lower sideband frequency is 990000

*x*(

*t*) is DSB-SC

⇒ The first geostationary satellite launched in 1965 was called

ANIK

EARLY BIRD (Intelsat-I)

WESTAR

MOLNIYA

⇒ The units for electric dipole moment are

coulombs

colomb-metre

coulomb/metre

coulomb/m

^{2}

⇒ Which characteristics of a memory chip is called dc characteristics?

Organisation

Timing characteristics

Physical dimensions

Power consumption and bus loading

⇒ An average responding rectifier type electronic voltmeter has its scale calibrated in terms of rms value of sine wave. If 100 V peak value square wave is fed to this voltmeter, the reading will be

111 V

100 V

90.9 V

70.7 V

⇒ E

_{G}for silicon is 1.12 eV and that for germanium is 0.72 eV. Therefore, it can be concluded that

the conductivity of silicon will be less than that of germanium at room temperature

the conductivity of silicon will be more than that of germanium at room temperature

the conductivity of two will be same at 60°C

the conductivity of two will be same at 100°C

⇒

Match the following:

List I | List II | ||
---|---|---|---|

A. | DMA controller | 1. | Interface between computer and video display adapter |

B. | CKT controller | 2. | Used to read data directly from disk into directly memory |

C. | Interrupt controller | 3. | Supervises the operation of control signal |

A-1, B-2, C-3

A-2, B-3, C-1

A-3, B-2, C-1

A-2, B-1, C-3

⇒ In the case of a 70-MHz IF carrier for a transponder bandwidth of 36 MHz, energy must lie between MHz.

34 and 106

52 and 88

106 and 142

34 and 142

⇒ In a BCD to 7 segment decoder the minimum and maximum number of outputs active at any time is

2 and 7

3 and 7

1 and 6

3 and 6

⇒ Which camera tube has highest dark current?

Plumbicon

Vidicon

Saticon

GCD imager

⇒ IC 74181 is a 4 bit device.

TRUE

FALSE

⇒ The sum of positive real functions

is a positive real function

may be a positive real function or not

can not be a positive real function

either (b) or (c)

⇒ In 8085 microprocessor with memory mapped I/O which of the following is true?

I/O devices have 16 bit addresses

I/O devices are accessed during IN and OUT instructions

There can be a maximum of 256 input and 256 output devices

Logic operations can not be performed

⇒ Voltage 1 + 2 sin ω

*t*is applied to the circuit shown be

0 volt

2 volts

-2 volts

-3 volts

⇒ A thyristor has its gate current zero. To start conduction the forward voltage must exceed

about 0.5 V

forward breakover voltage

on state voltage

peak working off state forward voltage

⇒ If ωε is the displacement current factor and s is conduction current density factor then which of the following statements is

*incorrect*?

For a lossless dielectric σ = 0

For an imperfect dielectric σ = 0

For a dielectric ωε >> σ

For a semiconductor ωε = σ