Question is ⇒ Consider the following circuit configuration <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">common Emitter</li><li style="padding-top:10px;">common Base</li><li style="padding-top:10px;">emitter follower</li><li style="padding-top:10px;">emitter follower using Darlington pair.</li></ol> The correct sequence in increasing order of I/P impedance of these configuration:, Options are ⇒ (A) 2, 1, 4, 3, (B) 1, 2, 4, 3, (C) 2, 1, 3, 4, (D) 1, 2, 3, 4, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following circuit configuration <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">common Emitter</li><li style="padding-top:10px;">common Base</li><li style="padding-top:10px;">emitter follower</li><li style="padding-top:10px;">emitter follower using Darlington pair.</li></ol> The correct sequence in increasing order of I/P impedance of these configuration:, Options are ⇒ (A) 2, 1, 4, 3, (B) 1, 2, 4, 3, (C) 2, 1, 3, 4, (D) 1, 2, 3, 4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following circuit configuration common Emitter common Base emitter follower emitter follower using Darlington pair. The correct sequence in increasing order of I/P impedance of these configuration:
A.	2, 1, 4, 3 [Wrong Answer]
B.	1, 2, 4, 3 [Correct Answer]
C.	2, 1, 3, 4 [Wrong Answer]
D.	1, 2, 3, 4 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If the drift velocity of holes under a field gradient of 100 V/m in 5 m/s, their mobility (in SI units) is
0.05
0.5
50
500

⇒ If t is relaxation time and t_c is average time between collisions, then in an isotropic metal
t = t_c
t < t_c
t_c < t
T = 0.01 t_e

⇒ The emitter bias largely depends on
gain
signal input
I_E
none of the above

⇒ If A = 3 + j1, A⁴
100 ∠18.43°
100 ∠73.72°
10 ∠18.43°
10 ∠73.72°

⇒ A geosynchronous satellite
has the same period a that of the Earth
has a circular orbit
rotates in the equatorial plane
has all of the above

⇒ In a full bridge single phase inverter feeding RLC load
one thyristor and one diode conduct simultaneously
two thyristors conduct simultaneously
two thyristors or two diodes conduct simultaneously
four thyristors conduct simultaneously

⇒ A dc chopper V = 500 V feeds an electric fraction dc series motor. The chopping frequency is 400 Hz. The series inductance required to limit the maximum current swing to 10 A is
20 mH
about 31 mH
about 51 mH
about 92 mH

⇒ The bidirectional pattern of a broadside array can be converted into unidirectional by
maintaining the distance of λ/4 between the elements
maintaining the distance of λ/2 between the elements
installing an identical array behind the main array at distance λ/4 and exciting it by current leading in phase by 90°
installing an identical array behind the main array at distance λ/2 and exciting it by current leading in phase by 120°

⇒ The inverse response of a system h(n) = aⁿ∪(n) what is the condition for the system to be BIBO stable?
a is real and +ve
a is real and -ve
|a| > 1
|a| < 1

⇒ The ratio of impurity atoms to intrinsic semiconductor atoms in an extrinsic semiconductor is about.
0.0486111111111111
0.736111111111111
1 : 100000
1 : 10⁸

⇒ The gate current required to turn on an SCR is
few amperes
a few mA
almost equal to anode current
about 50% of anode current

⇒ The open loop gain of an amplifier is 50 but likely to decrease by 20% due to various factors. If negative feedback with β = 0.1 is used, the change in gain will be about
0.2
0.02
0.005
0.0005

⇒ Which is correct for a driving point function?
If the real part of a pole or zero is zero, that pole must be simple
If the real part of a pole or zero is zero, that pole or zero must be simple
If the real part of a zero is zero, that pole or zero must be simple
If the real part of a zero is zero that zero must be simple

⇒ Silicon is not suitable for fabrication of light emitting diodes because it is
an indirect band gap semiconductor
direct band gap semiconductor
wideband gap semiconductor
narrowband gap semiconductor

⇒ IC counters are
synchronous only
asynchronous only
both synchronous and asynchronous
none of the above

⇒ A series circuit has fixed resistance and variable reactance. The impedance locus will be a straight line parallel to Y-axis.
TRUE
FALSE

⇒

Assertion (A): A branch with no current through it can be replaced by an open circuit or short circuit.

Reason (R): Reciprocity theorem is applicable only if the circuit has one source.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A lossless transmission line with air dielectric is 6 m long. What is the line length at 30 MHz?
1 wavelength long
0.5 wavelength long
0.6 wavelength long
0.25 wavelength long

⇒ What is the maximum output voltage from the 741 op-amp?
Zero
Approximately 1 V
Approximately 3 V
Approximately 5 V

⇒ The purpose of providing groundings rings with MOSFET is to
avoid any stray voltage at the gate that may destroy SiO₂ layer
protect against any descaling
ground all eddy currents
protect against any physical injury

⇒ When the core of a saturable reactor is saturated, the inductance is high.
TRUE
FALSE

⇒ Vectored interrupt is an interrupt that takes the program to a vector location. TRAP vectors to 0024 FI, RST 7.5 to 003 CH, RST 6.5 to 0034 H and
RST 5.5
RST 6.5
24 H to 48 H
RST 5.5 to 002 CH

⇒ A communication channel disturbed by additive white, Gaussian noise has a bandwidth of 4 kHz and SNR of 15. The highest transmission rate that this channel can support (in k bits/sec) is
16
1.6
3.2
60

⇒ A transmission line has a characteristic impedance of 50 Ω and a resistance of 0.1 Ω/m, if the line is distortion less, the attenuation constant (in Np/m) is
500
5
0.014
0.002

⇒ In 8085 microprocessor, how many lines are there in data bus?
6
8
2
16

⇒ In the NMOS inverter
the driver and achieve load are enhancement type
the driver is enhancement type and load depletion type
both driver and load are depletion type
the driver and load are depletion type

⇒ For 2 port reciprocal network, o.c. output voltage divided by input current is equal to
B
z₁₂
1/y₁₂
h₁₂

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ In VHS format each video head is tilted from azimuth by
20°
10°
6°
1°

⇒ When .4546 E 5 and .5433 E 7 are to be added in normalized floating point mode
none of the numbers is changed to any other form
.4546 E 5 is changed .004546 E 7 and .5433 E 7 is not changed
.5433 E 7 is changed to 54.33 E 5 and .4546 E 5 is not changed
both the numbers are changed and their exponents are made equal to 6