Question is ⇒ The drain characteristics of JFET are drawn between, Options are ⇒ (A) VGS and VDS for different values of drain current, (B) drain current and VGS for different values of VDS, (C) drain current and VDS for different values of VGS, (D) drain current and VGS for one value of VDS, (E) , Leave your comments or Download question paper.

Question is ⇒ The drain characteristics of JFET are drawn between, Options are ⇒ (A) VGS and VDS for different values of drain current, (B) drain current and VGS for different values of VDS, (C) drain current and VDS for different values of VGS, (D) drain current and VGS for one value of VDS, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The drain characteristics of JFET are drawn between
A.	V_GS and V_DS for different values of drain current [Wrong Answer]
B.	drain current and V_GS for different values of V_DS [Wrong Answer]
C.	drain current and V_DS for different values of V_GS [Correct Answer]
D.	drain current and V_GSfor one value of V_DS [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I (Logic family)		List II (Characteristic of logic family)
A.	TTL	1.	Maximum power Consumption
B.	ECL	2.	Highest Packing Density
C.	NMOS	3.	Least Power Consumption
D.	CMOS	4.	Saturated Logic

A-1, B-4, C-2, D-3
A-1, B-4, C-3, D-2
A-4, B-1, C-2, D-3
A-4, B-1, C-3, D-2

⇒ The measurement of Hall coefficient of a semiconductor with one type of charge carriers gives the information about
sign of charge carrier
density of charge carrier
both sign and density of charge carrier
none of the above

⇒ Two coils are so wound that 60% of the flux of one links the other. The coefficient of coupling is
1.67
0.6
0.36
0.216

⇒ Before doping the semiconductor material is
dehydrated
heated
hardened
purified

⇒ (11)₂ + (11)₃ = (11)_?
4
5
6
none

⇒ The merger of hole and free electron is called
covalent bonding
recombination
thermal energy
free electrons

⇒ The number of product terms in the minimized sum of product expression obtained through the following k map is (where "d" denotes don't care states)
2
3
4
5

⇒ In satellite communication, highly directional antennas are used to
direct the spot beam to a particular region of space on Earth
strengthen the beam to overcome the cosmic noise
make corrections in change of polarisation of the beam
select a particular channel in transmission and reception

⇒ Simplify : A + B + A B + (A + B)AB + C(B + AB)
B + A
C
C
1

⇒ In a three input AND gate A = 1, B = 1, C = 0 The output Y =
ABC
ABC
ABC
ABC

⇒ What is the RF amplifier plate voltage when the audio-modulating voltage is +600
-600 V
Zero
600 V
1200 V

⇒ In the schematic representation of bipolar junction transistor, the direction of arrow shows the direction of flow of
holes
electrons
holes in pnp and electrons in npn
electrons in pnp and holes in npn

⇒ Which of the following microphones is used as a standard for calibration?
Moving coil
Carbon
Condenser
Ribbon

⇒ In a transistor CE mode, V_CC = +30 V. If the transistor is in cut off region, V_CE =
+30 V
+20 V
10 V
zero

⇒ The use of SSB
halves the bandwidth required for transmission
does not affect the bandwidth for transmission
decreases the bandwidth required for transmission by 25%
decreases the bandwidth required for transmission by 66.6%

⇒ The function shown in figure, can represent a probability density function for A ________
A = 1/4
A = 1/6
A = 1/8
A = 1/2

⇒ In envelope detection of an AM waveform
One side band and full-ampiitude carrier are needed
Both side bands and full-amplitude carrier are needed
Only two side bands are needed
Upper side band and part of carrier are needed

⇒ In FM, the frequency deviation is
always constant
directly proportional to modulating frequency
inversely proportional to modulating frequency
proportional to amplitude of modulating signal

⇒ Refraction of electromagnetic waves occurs when they
pass through a small slot in a conducting plane
pass into a medium of different dielectric constant
are polarized at right angles to the direction of propagation
encounter a perfectly conduction surface

⇒ 8 bit data can have 256 numbers ranging from 00000000 to 111 111 11.
TRUE
FALSE

⇒ In a J-K FF we have J = Q and K = 1. Assuming the FF was initially cleared and then clocked for 6 pulses, the sequence at the Q output wil
10000
11001
10010
10101

⇒ If INT = 50 and LOOT = 30, the result of assignment statement SAL = INT + LOOT is
50
80
8
5

⇒ Narrowband FM signal can be considered to be equal to
PM
AM
SSB
DSB

⇒ In satellite communication, frequency modulation is used because satellite channel has
small bandwidth and negligible noise
large bandwidth and severe noise
maximum bandwidth and minimum noise
high modulation index

⇒ In a TWT the loss in attenuator is
almost equal to forward gain of tube
much less than forward gain of tube
much higher than forward gain of tube
almost infinite

⇒ In a CE amplifier circuit
Q point must lie on both dc and ac load lines
Q point lies on dc load line
Q point lies on ac load line
Q point lies may or may not lie on both dc and ac load lines

⇒ The useful magnetic flux obtainable from any closed surface is
unity
constant
both (a) and (b)
none of the above

⇒ At night the ionosphere can be considered to be consisting of
D, E, F₁ and F₂ layers
D, E, F₁ layers
D, E, F₂ layers
E and F₂ layers

⇒ Which of the following is an active device?
Transformer
Silicon controlled rectifier
Electric bulb
Loudspeaker

⇒ As compared to the number of network elements in Brune synthesis, the number of network elements Bott-and Duffin in realization is
more
less
equal
any of the above