Question is ⇒ Given below impulse response of two sys, Options are ⇒ (A) h1(n) non causal and stable, (B) h1(n) non causal and stable, (C) h1(n) causal and not stable, (D) h1(n) causal and stable, (E) , Leave your comments or Download question paper.

Question is ⇒ Given below impulse response of two sys, Options are ⇒ (A) h1(n) non causal and stable, (B) h1(n) non causal and stable, (C) h1(n) causal and not stable, (D) h1(n) causal and stable, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Given below impulse response of two sys
A.	h₁(n) non causal and stable [Wrong Answer]
B.	h₁(n) non causal and stable [Correct Answer]
C.	h₁(n) causal and not stable [Wrong Answer]
D.	h₁(n) causal and stable [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An AC circuit has two branches in parallel. The current in one branch is 5 A. Then the current source
must be less than 5 A
must be more than 5 A
may be equal or more or less than 5 A
0.208333333333333

⇒ In push pull amplifier, each transistor conducts for
180°
360°
90°
45°

⇒ In a semi-conductor diode, the barrier offers opposition to
holes in P-region only
free electrons in N-region only
majority carriers in both regions
majority as well as minority carriers in both regions

⇒ A parallel polarized wave is incident from air into paraffin having relative permittivity 3, the value of its Brewster angle is
0°
30°
45°
60°

⇒ In the circuit below, the diode is ideal. The voltage V is give
min(V_i, 1)
max(V_i, 1)
min (-V_i, 1)
max (-V_i, 1)

⇒ Which of the following compensation method in amplifier can be used to reduce the bandwidth?
Pole-zero compensation
Dominant pole compensation
Lead compensation
Any of the above

⇒ In a transistor which of the following region is very lightly doped and is very thin?
Emitter
Base
Collector
None of the above

⇒ An 8085 executes the following instructionsPC = 2715 H HL = 30A0 H
PC = 30A0H HL = 2715H
PC = 6104 H HL = 6140 H
PC = 6140H HL = 2715H

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ In a modem digital computer, a subtractor in normally not used because
subtractors are very expensive
the design of a subtractor is very complex
the adder is geared for doing subtraction
most of the programs do not require subtraction

⇒ If the time is counted from the instant when an ac wave is at its peak value, we get a
sine wave
cosine wave
distorted sine wave
none of the above

⇒ The increase in intensity of trace in a CRO causes a change in
beam current
frequency of time base
gain of Y amplifier
accelerating voltage

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region

⇒ What is the decimal equivalent of the binary number shown in fourth row?
79
97
117
127

⇒ An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
AM-DSB signal with suppressed carrier
AM-DSB signal with carrier
AM-SSB signal with carrier
a sequence of exponentially decaying sine waves

⇒ For a circular wave guide
cutoff frequency for TE₁₀ and TE₀₁ modes are same
cutoff frequency for TE₁₀ and TE₀₁ modes are different
cutoff frequency for TE₁₀ mode = twice the cutoff frequency for TE₂₀ mode
cutoff frequency for TE₁₀ mode = haf the cutoff frequency for TE₂₀ mode

⇒ Maximum effective aperture of an antenna which is operating at a wavelength of 3 meters and has a directivity of 100
71.68 m²
716 m²
7.16 m²
71.6 m²

⇒ An RC series circuit has R = 20 Ω and X_C = 20 Ω. Then Z =
40 Ω
28.28 Ω
20 Ω
1 Ω

⇒ Calculate the conductivity of pure silicon at room temperature when the concentration of carriers is 1.6 x 10¹⁰ per cm³. Take μ_e = 1500 cm²/V-sec, μ_h = 500 cm²/V-sec at room temperature,
5.12 x 10^-16
5 x 10⁺¹⁶
10¹⁶
5 x 10²⁰

⇒ Coaxial cables can be used for which frequency?
15 kHz
10 MHz
200 MHz
2000 MHz

⇒ A 1 ms pulse can be converted into a 10 ms pulse by using which one of the following
An astable multivibrator
Stable multivibrator
A bistable multivibrator
A J-K flip-flop

⇒ In a modulator it is found that the amplitude spectrum consists a component at f_c, the carrier frequency and one component each at f_c - f_s and f_c + f_s where f_s is the modulating signal frequency. Then the modulator used is
AM
AM or MBFM with modulation index 0.5
FM
PAM

⇒ The number of comparator circuits required to build a three-bit simultaneous A/D converter is
7
8
15
16

⇒ Indicate the false statement: If SWR on a transmission line is infinite, the line is terminated in
open circuit
short circuit
pure reactance
complex impedance

⇒ Ferromagnetic materials exhibit
a linear B-H behaviour
a non-linear B-H behaviour
an exponential B-H behaviour
none of the above

⇒ Consider the following operation in a computer

Multiplication of scalar
Iversion of matrix
Printing a line of 120 characters on a printer

Which of the above is a subroutine?
1 and 2 only
1 and 3 only
1, 2 and 3
2 only

⇒ In a metal, the valence electrons
are not shared
are shared only between neighbouring atoms
are shared by all atoms
either (b) or (c)

⇒ In solid dielectrics the rate of deterioration doubles for every 10-12°C rise in temperature.
TRUE
FALSE

⇒ Surface integral of the electric field intensity is
differential of volume flux
electrical charge
net flux emanating from the surface
none of the above