Question is ⇒ Programmable logic array uses, Options are ⇒ (A) RAM matrices, (B) ROMs matrices, (C) PROM matrices, (D) Silo memory, (E) , Leave your comments or Download question paper.

Question is ⇒ Programmable logic array uses, Options are ⇒ (A) RAM matrices, (B) ROMs matrices, (C) PROM matrices, (D) Silo memory, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Programmable logic array uses
A.	RAM matrices [Wrong Answer]
B.	ROMs matrices [Correct Answer]
C.	PROM matrices [Wrong Answer]
D.	Silo memory [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ T- FF used as a
transfer Data switch
toggle switch
time delay switch
none

⇒

Match the following:

	List I (BJT amplifier)		List II (Characteristics)
A.	CE	1.	good voltage gain, good current gain
B.	CC	2.	voltage gain less than 1, high current gain
C.	CB	3.	current gain less than 1, voltage gain high

A-1, B-2, C-3
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ The phenomenon known as "Early effect" in a BJT refers to a reduction of the effective base width caused by
electron-hole recombination at the base
reverse biasing of the base collector junction
forward biasing of emitter base junction
the early removal of stored base charge during saturation to cut off switching

⇒ Which of the following is the poorest conductor of electricity?
Copper
Aluminium
Manganin
Nichrome

⇒ If X = 2.5 and Y = 2.5, which of the following expressions would give the result as 5/7?
X + 2.5 / Y + 3.0
(X + 2.5) / Y + 4.5
(X + 2.5) / (Y + 4.5)
(X + 2.5) / Y + 3.5

⇒ The ratio of the directivity of an end fire antenna to that of a broadside antenna is
2
3
4
5

⇒ A 3 phase dual converter consists of
two 3 phase semiconverters connected in parallel
two 3 phase semiconverters connected in antiparallel
two 3 phase full converters connected in antiparallel
two 3 phase full converters connected in parallel

⇒ +12 V supply is given to plates a, d, g, and 0 V to other plates and grid of a VF display. The plates which will glow are
a, d, g
b, c, e, f
all
none

⇒ In a reverse biased P-N junction, the current through the junction increases abruptly at
zero voltage
1.2 V
0.72 V
breakdown voltage

⇒ Least expensive logic
RTL
DTL
TTL
ECL

⇒ A 1000 kHz carrier wave modulated 40% at 4000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulation after transmission through this circuit?
0.4
0.2
0.27
0.54

⇒ A function will have only sine terms if
f(t) = - f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒

Assertion (A): An op-amp has high voltage gain, high input impedance and low output impedance

Reason (R): Negative feedback increases output impedance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the amplifier circuits using junction transistors has the best gain?
Common emitter
Common base
Common collector
All above has the same gain

⇒ At room temperature a semiconductor material is
perfect insulator
conductor
slightly conducting
any of the above

⇒ Bandwidth of an antenna is related with where Q is quality factor
Q ∝ B
Q ∝ 1/B
Q ∝ B²
Q ∝ 1/B²

⇒ In a Darlington pair
the emitter of first transistor drives the base of the second
the base of the first transistor drives the emitter of the second
emitters of the two transistors are connected through a resistor
none of the above

⇒ Consider a control system shown in given figure. For slight variation in G, the ratio of open loop sensitivity to closed loop sensitivity will be give
1 : (1 + GH)
1 : (1 + GH)^{- 1}
1 : (1 - GH)
1 : (1 - GH)^{- 1}

⇒ Saturation of iron core causes distortion.
TRUE
FALSE

⇒ For 8 bit representation the minimum positive and minimum negative numbers are
2^-128 each
2^-28 and 2^-127
2^-127 and 2^-128
2^-127each

⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above

⇒ When thyristors are connected in parallel, the current distribution may become non-uniform due to
inductive effect of current carrying conductors
capacitive effect of current carrying conductors
both inductive and capacitive effects
none of the above

⇒ If x = 0.1396 radians, the values of 1 - cos x and 2 sin² (x / 2) using floating point arithmetic with a 4 digit mantissa are respectively
.1000 E - 1 each
.9727 E - 2 each
.1000 E - 1 and .9727 E - 2 respectively
.9727 E - 2 and .1000 E - 1 respectively

⇒

Assertion (A): A transducer needs an output measuring or display device for measuring a non electrical quantity.

Reason (R): In some transducers the output voltage is too small and needs amplification before it can be measured.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ For the floating point numbers 1.81 x 10^-29 and 0.0152 x 10¹⁸ the normalised forms are
0.181 x 10^-28 and 0.152 x 10¹⁷respectively
18.1 x 10^-30 and 0.152 x 10¹⁷ respectively
0.181 x 10^-28 and 1.52 x 10¹⁶ respectively
None of the above

⇒ The following program starts at location 0
20 H
02 H
00 H
FFH

⇒ Decimal 43 in hexadecimal and BCD number system is respectively.
B2, 01000011
2B, 01000011
2B, 00110100
B2, 01000100

⇒ A higher directivity is specified by
high gain low BW (Beamwidth)
high gain high BW
low gain high BW
none of the above

⇒ A series RC circuit has R = 5 Ω and C = 10 μF. The current in the circuit is 5 sin 20000t. The applied voltage is
252 sin (20000t + 45°)
252 sin (20000t - 45°)
252 sin 20000t
252 sin (20000t - 90°)

⇒ Figure shows a Wheatstone bridge with RTD to one arm. If resistance of RTD = 1020 Ω, the voltage V₀
49 mV
51 mV
48 mV
45 mV